Ultrasonic flow meter using mode coupling transducers.

This paper describes the development of an ultrasonic flow meter using a new type of transducer called the mode coupling transducer (MCT). The mode coupling transducer consists of a thin plate of a suitable piezoelectric material on which an interdigital transducer (IDT) is deposited for the generation and detection of plate acoustic waves. The flow meter consists of two such transducers mounted on opposite walls of a pipe through which the fluid is flowing.

The power flow angle of acoustic waves in thin piezoelectric plates.

The curves of slowness and power flow angle (PFA) of quasi-antisymmetric (A(0)) and quasi-symmetric (S(0)) Lamb waves as well as quasi-shear-horizontal (SH(0)) acoustic waves in thin plates of lithium niobate and potassium niobate of X-,Y-, and Z-cuts for various propagation directions and the influence of electrical shorting of one plate surface on these curves and PFA have been theoretically investigated. It has been found that the group velocity of such waves does not coincide with the phase velocity for the most directions of propagation. It has been also shown that S(0) and SH(0) wave are characterized by record high values of PFA and its change due to electrical shorting of the plate surface in comparison with surface and bulk acoustic waves in the same material.

New method of change in temperature coefficient delay of acoustic waves in thin piezoelectric plates.

As is well-known, the development of high-effective and thermostable acoustic devices assumes using the acoustic waves with high coefficient of electromechanical coupling (K2) and low temperature coefficient of delay (TCD). At present, it also is well-known that fundamental shear horizontal (SH0) acoustic waves in thin piezoelectric plates possess by significantly more electromechanical coupling compared to surface acoustic waves (SAW) in the same material. However, although the value of TCD of SH0 waves is insignificantly less than for SAW, this is not enough for development of thermostable devices.

Transmission of surface acoustic waves through the interface based on discontinuity of electrical boundary conditions on surface of potassium niobate.

This paper presents theoretical investigation of the propagation of surface acoustic waves (SAWs) across the boundary between metallized (electrically shorted) and unmetallized (electrically open) regions on the surface of potassium niobate crystals. Potassium niobate is a very strong piezoelectric material and has the interesting property that only one type of SAW, namely a Rayleigh wave, can exist on unmetallized surface, where as two types of SAWs, namely Rayleigh and Bleustein-Gulyaev (BG), can exist on a metallized surface. Analysis shows that the Rayleigh wave propagates through the interface with very little change in amplitude or polarization.

Reflection of plate acoustic waves produced by a periodic array of mechanical load strips or grooves.

The reflection of fundamental acoustic waves propagating in a thin piezoelectric plate by a periodic array of conducting strips of finite thickness or grooves has been theoretically and experimentally investigated. The analysis has shown that electrical shorting and mass loading affect the relationship of neighboring region impedances in a contrary manner. In some cases, these effects are comparable, and there exists a certain strip thickness for each piezoactive fundamental plate mode at which the reflection coefficient can become zero.