Novel MnO-Graphite Dual-Ion Battery and New Insights into Its Reaction Mechanism during Initial Cycle by Operando Techniques.

Dual-ion battery complements lithium-ion batteries in terms of the use of inexpensive materials and ease to construct cells. To improve the safety and energy density of dual-ion battery, in this paper, a novel MnO-graphite dual-ion battery is reported for the first time. Microporous MnO materials are used as anode, which exhibits a low conversion potential and a low voltage hysteresis.

Tuning Electrochemical Properties of Li-Rich Layered Oxide Cathodes by Adjusting Co/Ni Ratios and Mechanism Investigation Using in situ X-ray Diffraction and Online Continuous Flow Differential Electrochemical Mass Spectrometry.

Owing to high specific capacity of ∼250 mA h g, lithium-rich layered oxide cathode materials (LiNi Co MnO) have been considered as one of the most promising candidates for the next-generation cathode materials of lithium ion batteries. However, the commercialization of this kind of cathode materials seriously restricted by voltage decay upon cycling though Li-rich materials with high cobalt content have been widely studied and show good capacity. This research successfully suppresses voltage decay upon cycling while maintaining high specific capacity with low Co/Ni ratio in Li-rich cathode materials.

Origin of Structural Evolution in Capacity Degradation for Overcharged NMC622 via Operando Coupled Investigation.

The nickel-rich layered oxide materials have been selected as promising cathode materials for the next generation lithium ion batteries because of their large capacity and comparably high operating voltage. However, at high voltage (beyond 4.30 V vs Li/Li), the members of this family are all suffering from a rapid capacity decay, which was commonly concerned with crystal lattice distortion and related cation disordering.

Platinum-nickel alloy excavated nano-multipods with hexagonal close-packed structure and superior activity towards hydrogen evolution reaction.

Crystal phase regulations may endow materials with enhanced or new functionalities. However, syntheses of noble metal-based allomorphic nanomaterials are extremely difficult, and only a few successful examples have been found. Herein, we report the discovery of hexagonal close-packed Pt-Ni alloy, despite the fact that Pt-Ni alloys are typically crystallized in face-centred cubic structures.

New Insights into the Structure Changes and Interface Properties of Li3VO4 Anode for Lithium-Ion Batteries during the Initial Cycle by in-Situ Techniques.

Li3VO4 has been regarded as a new-type anode of lithium-ion batteries in recent years, which has a high theoretical specific capacity of 394 mAh g(-1), a proper potential for Li(+) insertion/deinsertion (∼1 V), and a good rate capacity. However, its low initial Coulombic efficiency, poor conductivity, and poor cycle performance restricts its development. In order to figure out the cause of the low initial Coulombic efficiency of Li3VO4 material, the nanosized Li3VO4 material was synthesized by citric acid-assisted sol-gel method.

Kinetics and structural changes of Li-rich layered oxide 0.5Li2MnO3·0.5LiNi(0.292)Co(0.375)Mn(0.333)O2 material investigated by a novel technique combining in situ XRD and a multipotential step.

Li-rich layered oxide 0.5Li2MnO3·0.5LiNi0.

Facile synthesis of the Li-rich layered oxide Li1.23Ni0.09Co0.12Mn0.56O2 with superior lithium storage performance and new insights into structural transformation of the layered oxide material during charge-discharge cycle: in situ XRD characterization.

In this work, the Li-rich oxide Li1.23Ni0.09Co0.