Ultrasensitive fiber sensor with enhanced Vernier effect for simultaneous measurements of transverse load and temperature.

Based on enhanced Vernier effect, a compact fiber sensor with ultrahigh sensitivity is proposed for simultaneous transverse load (TL) and temperature measurements. A single mode fiber (SMF) is spliced with a segment of hollow-core fiber (HCF) coated with polydimethylsiloxane (PDMS), some PDMS is injected into the HCF, forming a Vernier sensor with an air cavity adjacent to a PDMS cavity. It is shown that TL and temperature changes give rise to opposite and remarkable different variations in lengths of the two cavities, thereby enhancing Vernier effect and in favor of simultaneous measurements of TL and temperature.

Compact Vernier sensor with an all-fiber reflective scheme for simultaneous measurements of temperature and strain.

We propose an all-fiber reflective sensing scheme to simultaneously measure temperature and strain. A length of polarization-maintaining fiber serves as the sensing element, and a piece of hollow-core fiber assists with introducing Vernier effect. Both theoretical deductions and simulative studies have demonstrated the feasibility of the proposed Vernier sensor.

Precise laser linewidth measurement by feature extraction with short-delay self-homodyne.

We propose a precision measurement method of laser linewidth based on short-delay self-homodyne, using the second peak-valley difference (SPVD) feature of the coherent power spectrum to fit laser linewidth. The SPVD model of the self-homodyne coherent envelope spectrum was established. One-to-one correspondence among the values of SPVD, the delay length, and the laser linewidth was determined theoretically and through simulations, while the reliability and stability of the method was verified experimentally.

Signal processing assisted Vernier effect in a single interferometer for sensitivity magnification.

The Vernier effect magnifies optical sensitivity by the superposition of two spectra with slightly shifted frequencies from a sensing interferometer (SIM) and a reference interferometer (RIM). In this study, we demonstrate that the Vernier effect can be obtained through a single interferometer, which detects the changed signal and provides an artificial reference spectrum (ARS) to be superposed with the changed signal spectrum. The ARS extracted by spatial frequency down-conversion of one sensing spectrum in the signal processing is not affected by environmental changes and can be detuned at an arbitrarily small amount with the measured signal spectrum.

Ultrasensitive refractive index sensor based on enhanced Vernier effect through cascaded fiber core-offset pairs.

An ultrasensitive refractive index (RI) sensor based on enhanced Vernier effect is proposed, which consists of two cascaded fiber core-offset pairs. One pair functions as a Mach-Zehnder interferometer (MZI), the other with larger core offset as a low-finesse Fabry-Perot interferometer (FPI). In traditional Vernier-effect based sensors, an interferometer insensitive to environment change is used as sensing reference.

Experimental Investigations on Subsequent Yield Surface of Pure Copper by Single-Sample and Multi-Sample Methods under Various Pre-Deformation.

Using copper thin-walled tubular specimens, the subsequent yield surfaces under pre-tension, pre-torsion and pre-combined tension-torsion are measured, where the single-sample and multi-sample methods are applied respectively to determine the yield stresses at specified offset strain. The rule and characteristics of the evolution of the subsequent yield surface are investigated. Under the conditions of different pre-strains, the influence of test point number, test sequence and specified offset strain on the measurement of subsequent yield surface and the concave phenomenon for measured yield surface are studied.

Tens of hertz narrow-linewidth laser based on stimulated Brillouin and Rayleigh scattering.

We proposed and demonstrated a linewidth compression method of a laser based on stimulated Brillouin scattering (SBS) and a Rayleigh backscattering structure (RBS). The relationship between the output SBS laser linewidth and the input pump linewidth was studied theoretically and experimentally. It is shown that the narrower linewidth of the pump laser leads to the narrower bandwidth of the SBS gain and, finally, the bandwidth of the SBS will tend to its intrinsic value as the linewidth of a pump laser narrower than 10 kHz; then the linewidth of an SBS fiber ring laser would tend to 200 Hz.

Dual-cavity feedback assisted DFB narrow linewidth laser.

Single longitudinal mode (SLM) distributed feedback (DFB) lasers with a linewidth lower than a few kHz find applications in many coherent detection systems. In this paper, we proposed and experimentally demonstrated a novel method to compress the linewidth of a SLM DFB laser by utilizing a dual-cavity feedback structure (DCFS). The DCFS first provides optical self-injection feedback to compress the laser linewidth, and then the two feedback lengths are carefully optimized to achieve SLM output via the Vernier principle and the suppression of modes overlapping between two cavities.

Precise measurement of ultra-narrow laser linewidths using the strong coherent envelope.

Laser linewidth narrowing down to kHz or even Hz is an important topic in areas like clock synchronization technology, laser radars, quantum optics, and high-precision detection. Conventional decoherence measurement methods like delayed self-heterodyne/homodyne interferometry cannot measure such narrow linewidths accurately. This is because a broadening of the Gaussian spectrum, which hides the laser's intrinsic Lorentzian linewidth, cannot be avoided.

Tunable dual-wavelength fiber laser with ultra-narrow linewidth based on Rayleigh backscattering.

Dual-wavelength fiber lasers with ultra-narrow linewidth find wide applications in high-speed optical communications, fiber optic sensors, high resolution measurements and medical instruments and microwave or terahertz generation systems. Based on the linewidth compression mechanism due to Rayleigh backscattering, this paper adopts a simple ring structure cooperated with two fiber Bragg gratings centered at 1550 nm and 1530 nm respectively, achieving a dual-wavelength fiber laser with ultra-narrow linewidth, with a 3dB linewidth of ~700 Hz for each wavelength, and the SNR of 60dB. Tuning the center wavelength of one of the two FBGs while the other one keeps unchanged, the fiber laser keeps stable dual-wavelength lasing and the linewidth is still ~700 Hz.

Characteristics of PM2.5 in rural areas of southern Jiangsu Province, China.

To understand pollution level and possible sources of atmospheric fine particulates in rural areas of southern Jiangsu Province of China, samples of PM2.5 were collected and analyzed in Xueyan Town and Taihu Lake Station over three seasons from July 2002 to January 2003. The mass concentrations of PM2.