Assessment of temperature dynamics and microbial community responses in aerobic membrane bioreactors from mesophilic to hyper-thermophilic conditions.

This study investigates the impact of temperature variations on the performance of an aerobic membrane bioreactor (MBR) as it transitions from mesophilic (30 °C) to hyper-thermophilic (65 °C) conditions. The microbial community structure was analyzed using 16S rRNA gene sequencing to assess how temperature influences microbial diversity and composition. In mesophilic conditions, the system exhibited high alpha diversity with a Shannon index of 5.

Innovative hyper-thermophilic aerobic submerged membrane distillation bioreactor for wastewater reclamation.

For the first time, a hyper-thermophilic aerobic (>60 °C) bioreactor has been integrated with direct submerged membrane distillation (MD), highlighting its potential as an advanced wastewater treatment solution. The hyper-thermophilic aerobic bioreactor, operating up to 65 °C, is tailored for high organic removal, while MD efficiently produces clean water. Throughout the study, high removal rates of 99.

Effect of biomass retention time on performance and fouling of a stirred membrane photobioreactor.

Co-culture of microalgae-activated sludge has the potential to purify wastewater while reduce energy demand from aeration. In this work, a mechanically stirred membrane photobioreactor (stirred-MPBR) was used to evaluate the impact of the biomass retention time (BRT) on the treatment performance and membrane fouling. Results showed that stirred-MPBR was affected by BRT during treating domestic wastewater at a flux of 16.

Enhanced understanding of osmotic membrane bioreactors through machine learning modeling of water flux and salinity.

Mathematical modeling can be helpful to understand and optimize osmotic membrane bioreactors (OMBR), a promising technology for sustainable wastewater treatment with simultaneous water recovery. Herein, seven machine learning (ML) algorithms were employed to model both water flux and salinity of a lab-scale OMBR. Through the optimum hyperparameters tuning and 5-fold cross-validation, the ML models have achieved more accurate results without obvious overfitting and bias.

Microplastics waste in environment: A perspective on recycling issues from PPE kits and face masks during the COVID-19 pandemic.

During the COVID-19 pandemic, the extensive use of face masks and protective personal equipment (PPE) kits has led to increasing degree of microplastic pollution (MP) because they are typically discarded into the seas, rivers, streets, and other parts of the environment. Currently, microplastic (MP) pollution has a negative impact on the environment because of high-level fragmentation. Typically, MP pollution can be detected by various techniques, such as microscopic analysis, density separation, and Fourier transform infrared spectrometry.

Water reclamation and microbial community investigation: Treatment of tetramethylammonium hydroxide wastewater through an anaerobic osmotic membrane bioreactor hybrid system.

Tetramethylammonium hydroxide (TMAH) is a toxic photoresist developer used in the photolithography process in thin-film transistor liquid crystal display (TFT-LCD) production, and it can be removed through anaerobic treatment. TMAH cannot be released into the environment because of its higher toxicity. A tight membrane, such as a forward osmosis (FO) membrane, together with an anaerobic biological process can ensure that no TMAH is released into the environment.

Preparation of Metal Modified onto Biochar from Hazardous Waste for Arsenic Removal.

Use of urban sludge, hospital sludge, and aquatic product sludge as a biochar adsorbent from wastewater treatment plants was investigated. Microwave carbonization was used to carbonize the sludge and then chemically activated at high temperatures to increase porosity and surface area. Effective of arsenic adsorption in water presents a newly designed metal doped to biochar.

A breakthrough dynamic-osmotic membrane bioreactor/nanofiltration hybrid system for real municipal wastewater treatment and reuse.

This study designed a Dynamic-Osmotic membrane bioreactor/nanofiltration (OsMBR/NF) system for municipal wastewater treatment and reuse. Results indicated that a continuously rotating FO module with 60 RPM in Dynamic-OsMBR system could enhance shear stress and reduce cake layer of foulants, leading to higher flux (50%) compared to Traditional-OsMBR during a 40-operation day. A negligible specific reverse salt flux (0.

Microbial community response to ciprofloxacin toxicity in sponge membrane bioreactor.

This study aims to offer insights into how ciprofloxacin (CIP) impact bacterial community structures in the Sponge-MBR process when CIP is spiked into hospital wastewater. We found that the CIP toxicity decreased richness critical phylotypes such as phylum class ẟ-, β-, ɣ-proteobacteria, and Flavobacteria that co-respond to suppress denitrification and cake fouling to 37% and 28% respectively. Cluster analysis shows that the different community structures were formed under the influence of CIP toxicity.

Adsorption Configurations of Iron Complexes on As(III) Adsorption Over Sludge Biochar Surface.

Waste recycling and reuse will result in significant material and energy savings. In this research, usage of hospital sludge as a biochar adsorbent for wastewater treatment plants was investigated. Microwave carbonization was used to carbonize the sludge and then chemically activated with ZnCl₂to increase surface area and porosity.

Aqueous Oxytetracycline and Norfloxacin Sonocatalytic Degradation in the Presence of Peroxydisulfate with Multilayer Sheet-Like Zinc Oxide.

Multilayer ZnO sheet-like flakes were synthesized by a simple method of precipitation and characterized by the techniques of X-Ray Diffraction (XRD) and Scanning Electron Microscopy (SEM). The findings are proven that the SEM images show the overall morphology of a single sheet-like ZnO nanostructure made from uniformly thick nano-sheets. In an aqueous environment, the acoustic ability of the prepared material was assessed using ultrasound (US) radiation to degrade oxytetracycline (OTC) and norfloxacin (NF).

Efficient Cu removal from CuEDTA complex-containing wastewater using electrochemically controlled sacrificial iron anode.

In this study, an electro-replacement/precipitation/deposition/direct reduction (ERPDD) process with scrap iron packed in a Ti mesh cage as a sacrificial anode was investigated for the treatment of wastewater containing CuEDTA complexes. The ERPDD mechanisms were responsible for the removal of Cu from CuEDTA complexes and were verified by a series of experiments using either iron or carbon plates as anodes for the Cu-containing solutions with and without EDTA. A complete Cu removal was achieved with electrical current density applied (1.

Recovery of iodide as triiodide from thin-film transistor liquid crystal display wastewater by forward osmosis.

Triiodide, a larger charged molecule compared to iodide, is thermodynamically favored with the presence of both iodide and iodine, and is easier to be retained by membrane processes. For the first time, iodide was recovered in the form of triiodide by forward osmosis (FO) for thin-film transistor liquid crystal display industries by preoxidation of iodide to triiodide. Partial oxidation by NaOCl was used to convert the iodide to iodine and then to form triiodide.

A novel thermophilic anaerobic granular sludge membrane distillation bioreactor for wastewater reclamation.

Membrane distillation (MD) has a high heat requirement. Integrating MD with thermophilic bioreactors could remedy this problem. A laboratory-scale thermophilic anaerobic granular sludge membrane distillation bioreactor (ThAGS-MDBR) was used to treat wastewater with a high organic loading rate (OLR).

Recent Developments in Nanomaterials-Modified Membranes for Improved Membrane Distillation Performance.

Membrane distillation (MD) is a thermally induced membrane separation process that utilizes vapor pressure variance to permeate the more volatile constituent, typically water as vapor, across a hydrophobic membrane and rejects the less volatile components of the feed. Permeate flux decline, membrane fouling, and wetting are some serious challenges faced in MD operations. Thus, in recent years, various studies have been carried out on the modification of these MD membranes by incorporating nanomaterials to overcome these challenges and significantly improve the performance of these membranes.

Water and nutrient recovery by a novel moving sponge - Anaerobic osmotic membrane bioreactor - Membrane distillation (AnOMBR-MD) closed-loop system.

For the first time, a novel sponge-based moving bed-anaerobic osmosis membrane bioreactor/membrane distillation (AnOMBR/MD) system using mixed NaPO/EDTA-2Na as the draw solution was employed to treat wastewater for enhanced water flux and reduced membrane fouling. Results indicated that the moving sponge-AnOMBR/MD system obtained a stable water flux of 4.01 L/m h and less membrane fouling for a period lasting 45 days.

Application of progressive freezing on forward osmosis draw solute recovery.

Progressive freezing is a solvent purification technology with low energy requirements and high concentration efficiency. Although these advantages make it a promising technology, the technique has never been explored for draw solution recovery for forward osmosis (FO). Hence, in this study, the progressive freezing process was used to concentrate three common diluted draw solutions: NaCl, MgCl, and EDTA-2Na with different ice front speeds, stirring rates, and initial draw solution concentrations.

Exploring Nanosilver-Coated Hollow Fiber Microfiltration to Mitigate Biofouling for High Loading Membrane Bioreactor.

For the first time, a nanosilver-coated hollow fiber microfiltration (MF) was fabricated by a simple chemical reduction method, then tested for membrane biofouling mitigation study under extreme high mixed liquor suspended solid (MLSS) concentration for long term. This study presents a simple and novel technique to modify a commercially available MF membrane using silver nanoparticles (AgNPs) followed by an investigation of mitigating membrane biofouling potentials using this modified membrane to compare with an unmodified membrane for 60-day operation period. The modified membranes showed that AgNPs was attached to the MF-membrane successfully with a high density of 119.

A comprehensive review of recent developments in 3D printing technique for ceramic membrane fabrication for water purification.

Additive manufacturing (AM), which is also commonly known as 3D printing, provides flexibility in the manufacturing of complex geometric parts at competitive prices and within a low production time. However, AM has not been used to a large extent in filtration and water treatment processes. AM results in the creation of millions of nanofibers that are sublayered on top of each other and compressed into a thin membrane.

Hospital wastewater treatment by sponge membrane bioreactor coupled with ozonation process.

Herein, a sponge membrane bioreactor (Sponge-MBR) combined with ozonation process was performed to remove the antibiotics which frequently existed in the hospital wastewater. Whilst seven antibiotics i.e.

Innovative upflow anaerobic sludge osmotic membrane bioreactor for wastewater treatment.

A novel upflow anaerobic sludge-forward osmotic membrane bioreactor was developed for simultaneous wastewater treatment, membrane fouling reduction, and nutrient recovery. An upflow anaerobic sludge blanket (UASB) reactor was incorporated into the system, suspending the anaerobic sludge at the bottom of the reactor. A forward osmosis membrane replaced the traditional three-phase separator of the UASB technology.

Preparation of Zn-Doped Amino Functionalized Biochar from Hazardous Waste for Arsenic Removal.

The utilization of sludge from Far Eastern Memorial hospital (New Taipei city, Taiwan) wastewater treatment plants as biochar adsorbent was investigated. The sludge was carbonized using microwave carbonization and then chemically activated at high temperatures by using ZnCl₂ to enhance porosity and surface area. A newly designed Zndoped amino-functionalized sludge biochar (Zn-SBC-DETA) presents effective As adsorption in water.

Effect of ciprofloxacin dosages on the performance of sponge membrane bioreactor treating hospital wastewater.

This study aimed to evaluate treatment performance and membrane fouling of a lab-scale Sponge-MBR under the added ciprofloxacin (CIP) dosages (20; 50; 100 and 200 µg L) treating hospital wastewater. The results showed that Sponge-MBR exhibited effective removal of COD (94-98%) during the operation period despite increment of CIP concentrations from 20 to 200 µg L. The applied CIP dosage of 200 µg L caused an inhibition of microorganisms in sponges, i.

Understanding the mechanisms of trace organic contaminant removal by high retention membrane bioreactors: a critical review.

High retention membrane bioreactors (HR-MBR) combine a high retention membrane separation process such as membrane distillation, forward osmosis, or nanofiltration with a conventional activated sludge (CAS) process. Depending on the physicochemical properties of the trace organic contaminants (TrOCs) as well as the selected high retention membrane process, HR-MBR can achieve effective removal (80-99%) of a broad spectrum of TrOCs. An in-depth assessment of the available literature on HR-MBR performance suggests that compared to CAS and conventional MBRs (using micro- or ultra-filtration membrane), aqueous phase removal of TrOCs in HR-MBR is significantly better.

Sol-Gel Hydrothermal Synthesis and Visible Light Photocatalytic Degradation Performance of Fe/N Codoped TiO₂ Catalysts.

Using Ti(OC₄H₉)₄ as a precursor, Fe(NO₃)₃⋅9H₂O as the source of iron, and NH₄NO₃ as the source of nitrogen, an Fe/N codoped TiO₂ catalyst was prepared using a sol-gel hydrothermal method. The as-prepared powders were characterized using X-ray powder diffraction, electron spectroscopy for chemical analysis, Fourier-transform infrared spectroscopy, and ultraviolet-visible spectrophotometry. Fe and N codoping resulted in decreased crystallite size and increased specific surface area.