Various industries polluting the water bodies by discharging untreated wastewater directly into the environment and conventional wastewater treatments are often insufficient for effectively treating the pollutants. However, membrane bioreactors (MBRs) offer a promising solution for wastewater treatment where membrane serving as the heart of the system. In this study, polyethersulfone (PES) was used as the membrane material and hydrophilicity of the membranes were tuned up by mixing with hydrophilic additives such as polyethylene glycol (PEG) and polyvinylpyrrolidone (PVP) and the membranes have shown promising results in treating wastewater, particularly in terms of chemical oxygen demand (COD), biochemical oxygen demand (BOD), and color removal.
View Article and Find Full Text PDFSoil parameters are crucial aspects in increasing agricultural production. Even though Bangladesh is heavily dependent on agriculture, little research has been done regarding its automation. And a vital aspect of agricultural automation is predicting soil parameters.
View Article and Find Full Text PDFCOVID-19 is spreading around the world like wildfire. Chest X-rays are used as one of the primary tools for diagnosing COVID-19. However, about two-thirds of the world population do not have access to sufficient radiological services.
View Article and Find Full Text PDFThe following paper summarizes the findings of a pilot study to develop a simple, low-cost, holistic water concept on fluoride removal from groundwater in rural communities of Tanzania; an ideal representative community for other areas in the world with similar problems. A small photovoltaic powered nanofiltration (NF) pilot plant was installed at a vocational training center in Boma Ng´ombe in northern Tanzania. The groundwater in this region is contaminated with fluoride at very high concentrations of up to 60 mg/L.
View Article and Find Full Text PDFA novel antifouling coating based on the polymerization of a polymerisable bicontinuous microemulsion (PBM) was developed and applied for commercially available membranes for textile wastewater treatment. PBM coating was produced by polymerizing, on a polyethersulfone (PES) membrane, a bicontinuous microemulsion, realized by finely tuning its properties in terms of chemical composition and polymerization temperature. In particular, the PBM was prepared by using, as the surfactant component, inexpensive and commercially available dodecyltrimethylammonium bromide (DTAB).
View Article and Find Full Text PDF