Secondary structure assessment of formulated bevacizumab in the presence of SDS by deep ultraviolet resonance Raman (DUVRR) spectroscopy.

A deep-ultraviolet resonance Raman (DUVRR) spectroscopic method has been used to study the secondary structural changes of a therapeutic monoclonal antibody (mAb), bevacizumab (Avastin™) under a chemical stress: the presence of sodium dodecyl sulfate (SDS). The results demonstrate that DUVRR spectroscopy can assay the higher order structure of the formulated protein in a sensitive and selective manner. The SDS-induced partially unfolding of the mAb was probed by DUVRR spectroscopy where the amide I, II and III spectral features showed conformational changes between beta-sheet, alpha-helix and random coil forms.

Classification of Ciprofloxacin Tablets Using Near-Infrared Spectroscopy and Chemometric Modeling.

Exposure to unknown, mislabeled, and counterfeit pharmaceutical products is a worldwide problem that presents a serious risk to public health. Near-infrared (NIR) spectroscopy can serve as a useful tool for screening pharmaceuticals in a rapid and cost-effective manner to ensure that drug products are safe and effective. By applying chemometric techniques to NIR spectra from finished products in tablet form, minor spectral differences are discoverable, even in instances where the tablets being evaluated contain the same active pharmaceutical ingredients (APIs).

Deep-Ultraviolet Resonance Raman (DUVRR) Spectroscopy of Therapeutic Monoclonal Antibodies Subjected to Thermal Stress.

The structural assessment of Rituximab, an IgG1 mAb, was investigated with deep-ultraviolet resonance Raman (DUVRR) spectroscopy. DUVRR spectroscopy was used to monitor the changes to the secondary structure of Rituximab under thermal stress. DUVRR spectra showed obvious changes from 22 to 72 °C.

Deep-ultraviolet (UV) resonance raman spectroscopy as a tool for quality control of formulated therapeutic proteins.

A deep-ultraviolet (UV) Raman spectrometer with excitation source tunable from 193 to 210 nm has been built and characterized. The dispersion of the spectrometer over the entire range was measured and described theoretically. The relative sensitivity of the spectrometer was estimated using the integrated intensity ratio of two Raman bands of cyclohexane.

Selective melamine detection in multiple sample matrices with a portable Raman instrument using surface enhanced Raman spectroscopy-active gold nanoparticles.

Melamine adulteration of food and pharmaceutical products is a major concern and there is a growing need to protect the public from exposure to contaminated or adulterated products. One approach to reduce this threat is to develop a portable method for on-site rapid testing. We describe a universal and selective method for the detection of melamine in a variety of solid matrices at the 100-200 μg L(-1) level by surface enhanced Raman spectroscopy (SERS) with gold nanoparticles.

Libraries, classifiers, and quantifiers: a comparison of chemometric methods for the analysis of Raman spectra of contaminated pharmaceutical materials.

In this study, pharmaceutical grade sorbitol was used as a model system for comparison of Raman based library spectral correlation methods with more sophisticated methods of chemometric data analysis. Both crystallizing sorbitol (CS) and non-crystallizing sorbitol (NCS) from several manufacturers were examined. The Raman spectrum of each sample was collected and identified by correlation with a spectral library that included the CS spectrum but not the NCS spectrum.

Multivariate calibration and instrument standardization for the rapid detection of diethylene glycol in glycerin by Raman spectroscopy.

The transfer of a multivariate calibration model for quantitative determination of diethylene glycol (DEG) contaminant in pharmaceutical-grade glycerin between five portable Raman spectrometers was accomplished using piecewise direct standardization (PDS). The calibration set was developed using a multi-range ternary mixture design with successively reduced impurity concentration ranges. It was found that optimal selection of calibration transfer standards using the Kennard-Stone algorithm also required application of the algorithm to multiple successively reduced impurity concentration ranges.

Rapid limit tests for metal impurities in pharmaceutical materials by X-ray fluorescence spectroscopy using wavelet transform filtering.

We introduce a new method for analysis of X-ray fluorescence (XRF) spectra based on continuous wavelet transform filters, and the method is applied to the determination of toxic metals in pharmaceutical materials using hand-held XRF spectrometers. The method uses the continuous wavelet transform to filter the signal and noise components of the spectrum. We present a limit test that compares the wavelet domain signal-to-noise ratios at the energies of the elements of interest to an empirically determined signal-to-noise decision threshold.

Detection of diethylene glycol adulteration in propylene glycol--method validation through a multi-instrument collaborative study.

Four portable NIR instruments from the same manufacturer that were nominally identical were programmed with a PLS model for the detection of diethylene glycol (DEG) contamination in propylene glycol (PG)-water mixtures. The model was developed on one spectrometer and used on other units after a calibration transfer procedure that used piecewise direct standardization. Although quantitative results were produced, in practice the instrument interface was programmed to report in Pass/Fail mode.