Antiferromagnetic Nanoscale Bit Arrays of Magnetoelectric CrO Thin Films.

Magnetism of oxide antiferromagnets (AFMs) has been studied in single crystals and extended thin films. The properties of AFM nanostructures still remain underexplored. Here, we report on the fabrication and magnetic imaging of granular 100 nm-thick magnetoelectric CrO films patterned in circular bits with diameters ranging from 500 down to 100 nm.

Polarimeters for the Detection of Anisotropy from Reflectance.

Polarimetry is used to determine the Stokes parameters of a laser beam. Once all four S0,1,2,3 parameters are determined, the state of polarisation is established. Upon reflection of a laser beam with the defined polarisation state, the directly measured parameters can be used to determine the optical properties of the surface, which modify the -state upon reflection.

Fraxicon for Optical Applications with Aperture ∼1 mm: Characterisation Study.

Emerging applications of optical technologies are driving the development of miniaturised light sources, which in turn require the fabrication of matching micro-optical elements with sub-1 mm cross-sections and high optical quality. This is particularly challenging for spatially constrained biomedical applications where reduced dimensionality is required, such as endoscopy, optogenetics, or optical implants. Planarisation of a lens by the Fresnel lens approach was adapted for a conical lens (axicon) and was made by direct femtosecond 780 nm/100 fs laser writing in the SZ2080™ polymer with a photo-initiator.

Laser-Patterned Alumina Mask and Mask-Less Dry Etch of Si for Light Trapping with Photonic Crystal Structures.

Ultra-short 230 fs laser pulses of a 515 nm wavelength were tightly focused onto 700 nm focal spots and utilised in opening ∼0.4-1 μm holes in alumina AlO etch masks with a 20-50 nm thickness. Such dielectric masks simplify the fabrication of photonic crystal (PhC) light-trapping patterns for the above-Lambertian performance of high-efficiency solar cells.

Spectral monitoring at SwissFEL using a high-resolution on-line hard X-ray single-shot spectrometer.

The performance and parameters of the online photon single-shot spectrometer (PSSS) at the Aramis beamline of the SwissFEL free-electron laser are presented. The device operates between the photon energies 4 and 13 keV and uses diamond transmission gratings and bent Si crystals for spectral measurements on the first diffraction order of the beam. The device has an energy window of 0.

Improvement and stabilization of optical hydrogen sensing ability of Au-Pd alloys.

Formation of metal hydrides is a signature chemical property of hydrogen and it can be leveraged to enact both storage and detection of this technologically important yet extremely volatile gas. Palladium shows particular promise as a hydrogen storage medium as well as a platform for creating rapid and reliable H optical sensor devices. Furthermore, alloying Pd with other noble metals provides a technologically simple yet powerful way of enacting control over the structural and catalytic properties of the resultant material.

Kirchhoff's Thermal Radiation from Lithography-Free Black Metals.

Lithography-free black metals composed of a nano-layered stack of materials are attractive not only due to their optical properties but also by virtue of fabrication simplicity and the cost reduction of devices based on such structures. We demonstrate multi-layer black metal layered structures with engineered electromagnetic absorption in the mid-infrared (MIR) wavelength range. Characterization of thin SiO2 and Si films sandwiched between two Au layers by way of experimental electromagnetic radiation absorption and thermal radiation emission measurements as well as finite difference time domain (FDTD) numerical simulations is presented.

Metamaterial for Hydrogen Sensing.

A hydrogen sensor based on plasmonic metasurfaces is demonstrated to exhibit the industry-required 10 s reaction time and sensitivity. It consists of a layer of either Y or WO sandwiched between a top Pd nanodisk and a Au mirror at the base. The phase change layer (Y, WO) reacts with hydrogen, and the corresponding change of the refractive index (permittivity) is detected by the spectral shift of the resonance dip in reflectance at the IR spectral window.

Wavefront sensing at X-ray free-electron lasers.

Here a direct comparison is made between various X-ray wavefront sensing methods with application to optics alignment and focus characterization at X-ray free-electron lasers (XFELs). Focus optimization at XFEL beamlines presents unique challenges due to high peak powers as well as beam pointing instability, meaning that techniques capable of single-shot measurement and that probe the wavefront at an out-of-focus location are desirable. The techniques chosen for the comparison include single-phase-grating Talbot interferometry (shearing interferometry), dual-grating Talbot interferometry (moiré deflectometry) and speckle tracking.

Kirchhoff's metasurfaces towards efficient photo-thermal energy conversion.

Thermo-optical properties of the nanodisc and metal hole array plasmonic perfect absorber (PPA) metasurfaces were designed and characterized at mid-infrared wavelengths. Both, radiation emitter and detector systems operating in various spectral domains are highly sought after for a diverse range of applications, one example being future sensor networks employed in the internet-of-things. Reciprocity of the absorbance and emittance is shown experimentally, i.

SwissFEL Aramis beamline photon diagnostics. Erratum.

The list of authors in the paper by Juranić et al. (2018) [J. Synchrotron Rad.

Towards X-ray transient grating spectroscopy.

The extension of transient grating spectroscopy to the x-ray regime will create numerous opportunities, ranging from the study of thermal transport in the ballistic regime to charge, spin, and energy transfer processes with atomic spatial and femtosecond temporal resolution. Studies involving complicated split-and-delay lines have not yet been successful in achieving this goal. Here we propose a novel, simple method based on the Talbot effect for converging beams, which can easily be implemented at current x-ray free electron lasers.

First Principles Calculations Toward Understanding SERS of 2,2'-Bipyridyl Adsorbed on Au, Ag, and Au-Ag Nanoalloy.

First principles electrodyanmics and quantum chemical simulations are performed to gain insights into the underlying mechanisms of the surface enhanced Raman spectra of 22BPY adsorbed on pure Au and Ag as well as on Au-Ag alloy nanodiscs. Experimental SERS spectra from Au and Ag nanodiscs show similar peaks, whereas those from Au-Ag alloy reveal new spectral features. The physical enhancement factors due to surface nano-texture were considered by numerical FDTD simulations of light intensity distribution for the nano-textured Au, Ag, and Au-Ag alloy and compared with experimental results.

SwissFEL Aramis beamline photon diagnostics.

The SwissFEL Aramis beamline, covering the photon energies between 1.77 keV and 12.7 keV, features a suite of online photon diagnostics tools to help both users and FEL operators in analysing data and optimizing experimental and beamline performance.

Tunable kinoform x-ray beam splitter.

We demonstrate an x-ray beam splitter with high performances for multi-kilo-electron-volt photons. The device is based on diffraction on kinoform structures, which overcome the limitations of binary diffraction gratings. This beam splitter achieves a dynamical splitting ratio in the range 0-99.

Optical readout of hydrogen storage in films of Au and Pd.

For hydrogen sensor and storage applications, films of Au and Pd were (i) co-sputtered at different rates or (ii) deposited in a sequentially alternating fashion to create a layered structure on a cover glass. Peculiarities of hydrogen uptake and release were optically monitored using 1.3 μm wavelength light.

Gigahertz Optomechanical Modulation by Split-Ring-Resonator Nanophotonic Meta-Atom Arrays.

Using polarization-resolved transient reflection spectroscopy, we investigate a metasurface consisting of coherently vibrating nanophotonic U-shaped split-ring meta-atoms that exhibit colocalized optical and mechanical resonances. With an array of these resonators formed of gold on glass, essentially miniature tuning forks, we monitor the visible-pump induced gigahertz oscillations in reflected infrared light intensity to probe the multimodal vibrational response. Numerical simulations of the associated transient deformations and strain fields elucidate the complex nanomechanical dynamics contributing to the ultrafast optical modulation and point to the role of acousto-plasmonic interactions through the opening and closing motion of the SRR gaps as the dominant effect.

Silk: Optical Properties over 12.6 Octaves THz-IR-Visible-UV Range.

Domestic () and wild () silk fibers were characterised over a wide spectral range from THz 8 cm -1 ( λ = 1.25 mm, f = 0.24 THz) to deep-UV 50 × 10 3 cm - 1 ( λ = 200 nm, f = 1500 THz) wavelengths or over a 12.

Nano-rescaling of gold films on polystyrene: thermal management for SERS.

Nano-textured Au surfaces were prepared on pre-stretched 2D polystyrene (PS) sheets sputtered with different thicknesses of Au. The Au-coated PS was subjected to thermal annealing above the glass transition temperature at ∼150 °C, thus undergoing surface area rescaling via a volume phase transition. The yellow color of the Au changed from the typical mirror-like appearance to a diffusive dark yellow, progressing to dark brown at the smallest feature size, hence, electromagnetic energy was coupled into the substrate.

Engineering and Localization of Quantum Emitters in Large Hexagonal Boron Nitride Layers.

Hexagonal boron nitride is a wide-band-gap van der Waals material that has recently emerged as a promising platform for quantum photonics experiments. In this work, we study the formation and localization of narrowband quantum emitters in large flakes (up to tens of micrometers wide) of hexagonal boron nitride. The emitters can be activated in as-grown hexagonal boron nitride by electron irradiation or high-temperature annealing, and the emitter formation probability can be increased by ion implantation or focused laser irradiation of the as-grown material.

Au-Ag-Cu nano-alloys: tailoring of permittivity.

Precious metal alloys enables new possibilities to tailor materials for specific optical functions. Here we present a systematic study of the effects of a nanoscale alloying on the permittivity of Au-Ag-Cu metals at 38 different atomic mixing ratios. The permittivity was measured and analyzed numerically by applying the Drude model.

Nanostructured Antireflective and Thermoisolative Cicada Wings.

Inter-related mechanical, thermal, and optical macroscopic properties of biomaterials are defined at the nanoscale by their constituent structures and patterns, which underpin complex functions of an entire bio-object. Here, the temperature diffusivity of a cicada (Cyclochila australasiae) wing with nanotextured surfaces was measured using two complementary techniques: a direct contact method and IR imaging. The 4-6-μm-thick wing section was shown to have a thermal diffusivity of α⊥ = (0.

Photoluminescence from voids created by femtosecond-laser pulses inside cubic-BN.

Photoluminescence (PL) from femtosecond-laser-modified regions inside cubic-boron nitride (c-BN) was measured under UV and visible light excitation. Bright PL at the red spectral range was observed, with a typical excited state lifetime of ∼4  ns. Sharp emission lines are consistent with PL of intrinsic vibronic defects linked to the nitrogen vacancy formation (via Frenkel pair) observed earlier in high-energy electron-irradiated and ion-implanted c-BN.

Antibacterial titanium nano-patterned arrays inspired by dragonfly wings.

Titanium and its alloys remain the most popular choice as a medical implant material because of its desirable properties. The successful osseointegration of titanium implants is, however, adversely affected by the presence of bacterial biofilms that can form on the surface, and hence methods for preventing the formation of surface biofilms have been the subject of intensive research over the past few years. In this study, we report the response of bacteria and primary human fibroblasts to the antibacterial nanoarrays fabricated on titanium surfaces using a simple hydrothermal etching process.

Black silicon as a platform for bacterial detection.

Surface-enhanced Raman scattering (SERS) shows promise for identifying single bacteria, but the short range nature of the effect makes it most sensitive to the cell membrane, which provides limited information for species-level identification. Here, we show that a substrate based on black silicon can be used to impale bacteria on nanoscale SERS-active spikes, thereby producing spectra that convey information about the internal composition of the bacterial capsule. This approach holds great potential for the development of microfluidic devices for the removal and identification of single bacteria in important clinical diagnostics and environmental monitoring applications.