Measuring surface energy of solid surfaces using centrifugal adhesion balance.

The standard way to evaluate the solid surface energy using probe liquids relies on contact angle measurements. The measured contact angles rely on visible means and are different from their nanoscopic thermodynamic values. This compromises the surface-energy predictions so much that the surface energy-values can be hundreds of percentages higher than expected based on comparisons with different methods as reported in several studies.

Stages That Lead to Drop Depinning and Onset of Motion.

In this paper, we consider drops that are subjected to a gradually increasing lateral force and follow the stages of the motion of the drops. We show that the first time a drop slides as a whole is when the receding edge of the drop is pulled by the advancing edge (the advancing edge drags the receding edge). The generality of this phenomenon includes sessile and pendant drops and spans over various chemically and topographically different cases.

Comment on "Comparison of the Lateral Retention Forces on Sessile, Pendant, and Inverted Sessile Drops".

Tadmor et al.'s 2009 article shows experiments of pendant drops with ∼30% higher retention forces than their sessile analogues. A recent article (de la Madrid, R.

A Novel Technique Enables Quantifying the Molecular Interaction of Solvents with Biological Tissues.

The pharmaceutical industry uses various solvents to increase drug penetrability to tissues. The solvent's choice affects the efficacy of a drug. In this paper, we provide an unprecedented means of relating a solvent to a tissue quantitatively.

Droplets Sliding down a Vertical Surface under Increasing Horizontal Forces.

We have investigated the retention forces of liquid drops on rotating, vertical surfaces. We considered two scenarios: in one, a horizontal, centrifugal force pushes the drop toward the surface (?pushed drop? case), and in the other, a horizontal, centrifugal force pulls the drop away from the surface (?pulled drop? case). Both drops slide down as the centrifugal force increases, although one expects that the pushed drop should remain stuck to the surface.

The Influence of Gravity on Contact Angle and Circumference of Sessile and Pendant Drops has a Crucial Historic Aspect.

Normally, pendant drops adapt contact angles that are closer to 90° than their sessile analogues. This is due to the drop's weight that pulls the pendant drop and straightens its contact angles. In this paper, we show a case in which the opposite happens: sessile drops that adapt contact angles that are closer to 90° than their pendant analogues.

Why Drops Bounce on Smooth Surfaces.

It is shown that introducing gravity in the energy minimization of drops on surfaces results in different expressions when minimized with respect to volume or with respect to contact angle. This phenomenon correlates with the probability of drops to bounce on smooth surfaces on which they otherwise form a very small contact angle or wet them completely. Theoretically, none of the two minima is stable: the drop should oscillate from one minimum to the other as long as no other force or friction will dissipate the energy.

Solid-Liquid Work of Adhesion.

We establish a tool for direct measurements of the work needed to separate a liquid from a solid. This method mimics a pendant drop that is subjected to a gravitational force that is slowly increasing until the solid-liquid contact area starts to shrink spontaneously. The work of separation is then calculated in analogy to Tate's law.