The pursuit of renewable and eco-friendly raw materials for biobased materials is a growing field. This study utilized ellagitannin and cellulose microfibrils derived from rambutan peel waste alongside gelatin to develop eco-conscious hydrogels. The cellulose/gelatin hydrogels were formulated in two weight ratios (0.
View Article and Find Full Text PDFThis study assesses the viability of an accelerated solvent extraction technique employing environmentally friendly solvents to extract ellagitannins while producing cellulose-rich fibers from rambutan peel. Two sequential extraction protocols were investigated: 1) water followed by acetone/water (4:1, v:v), and 2) acetone followed by acetone/water (4:1, v:v), both performed at 50 °C. The first protocol had a higher extraction yield of 51 %, and the obtained extractives featured a higher total phenolic (531.
View Article and Find Full Text PDFIn this study, nanocomposite film was fabricated using cellulose nanocrystals (CNCs) as nanofiller in a polymer matrix of polyvinyl alcohol (PVA) and gum tragacanth (GT) via solution casting. CNCs were extracted from sugarcane bagasse using a steam explosion technique followed by acid hydrolysis. Initial analysis of CNCs by transmission electron microscopy (TEM) showed nanosized particles of 104 nm in length and 7 nm in width.
View Article and Find Full Text PDFThe goal of this study is to isolate cellulose nanocrystals (CNC) from sugarcane leaves (SCL) and fabricate filter membranes. Filter membranes consisting of the CNC and varying amount graphene oxide (GO) were fabricated using vacuum filtration technique. The α-cellulose content increased from 53.
View Article and Find Full Text PDFAgroindustrial wastes are renewable sources and the most promising sustainable alternative to lignocellulosic biomass for cellulose production. This study assessed the electrothermal pretreatment of rambutan peel (RP) for producing cellulose fibers. The pretreatment was carried out by Ohmic heating at a solid-to-liquid ratio of 1:10 (w/v) in a water/ethanol (1:1, v/v) mixture as the electrical transmission medium at 60 ± 1 °C for different holding times (15, 30, and 60 min).
View Article and Find Full Text PDFThis study extracted ellagitannins from rambutan peel using the Soxhlet technique. The extract was further partitioned and fractionated to get extract rich in ellagitannin and geraniin, respectively. The partitioning of the extract significantly increased total phenolic content (TPC) by 36.
View Article and Find Full Text PDFAbstract: Particulate matter (PM) pollution and SARS-CoV-2 (COVID-19) have brought severe threats to public health. High level of PM serves as a carrier of COVID-19 which is a global pandemic. This study fabricated filter membrane for face mask using bacterial cellulose and fingerroot extract (BC-FT) via immersion technique.
View Article and Find Full Text PDFThis study employed the principles of electrothermal process using ohmic heating (OH) to extract phenolic compounds from rambutan peel. Deionized water and ethanol at different concentrations (50% and 70%) were used as electrical-transmission medium at different holding times (15, 30 and 60 min). The result showed significant difference (p ≤ 0.
View Article and Find Full Text PDFNanocomposite film of poly(vinyl alcohol) (PVA) incorporated with bacterial cellulose nanocrystals (BCNCs) and magnetite nanoparticles (FeO) is reported in this study. The BCNC-FeO nanoparticles and PVA film was prepared by in situ synthesis technique using chemical co-precipitation. Different concentrations of BCNC-FeO (20%, 40% and 60% /) were mechanically dispersed in PVA solution to form the nanocomposite film.
View Article and Find Full Text PDFIn this study, cellulose was obtained from sugarcane bagasse (SCB) and treated with xylanase to remove residual noncellulosic polymers (hemicellulose and lignin) to improve its dyeability. The cellulose fibers were dyed with natural dye solutions extracted from the heart wood of Linn. and Lam.
View Article and Find Full Text PDF