Reduced staining from a chlorhexidine mouthwash: A randomized clinical trial.

Purpose: To investigate the stain preventing ability of a new chlorhexidine mouthwash while maintaining efficacy using a randomized clinical trial design.

Methods: 98 subjects were enrolled and completed a 4-week clinical study that evaluated the effectiveness of the new mouthwash on plaque, gingivitis, and staining as compared to a commercially available chlorhexidine mouthwash. A subset of 62 subjects was evaluated for the effectiveness of the mouthwashes against plaque bacteria.

Mode of action studies of a new desensitizing mouthwash containing 0.8% arginine, PVM/MA copolymer, pyrophosphates, and 0.05% sodium fluoride.

Objective: The mode of action of an arginine mouthwash using the Pro-Argin™ Mouthwash Technology, containing 0.8% arginine, PVM/MA copolymer, pyrophosphates and 0.05% sodium fluoride, has been proposed and confirmed as occlusion using a variety of in vitro techniques.

Efficacy of a mouthwash containing 0.8% arginine, PVM/MA copolymer, pyrophosphates, and 0.05% sodium fluoride compared to a commercial mouthwash containing 2.4% potassium nitrate and 0.022% sodium fluoride and a control mouthwash containing 0.05% sodium fluoride on dentine hypersensitivity: a six-week randomized clinical study.

Objective: Evaluate the efficacy of 0.8% arginine, potassium nitrate and sodium fluoride mouthwashes on dentine hypersensitivity reduction.

Methods: Six week randomized, double blinded, two cell, parallel single centre clinical study in the Dominican Republic; subjects were randomized into three treatment groups: mouthwash containing 0.

The development of a new desensitising mouthwash containing arginine, PVM/MA copolymer, pyrophosphates, and sodium fluoride--a hydraulic conductance study.

Objective: To investigate the ability of a novel mouthwash comprised of 0.8% arginine, PVM/MA copolymer, pyrophosphates, and 0.05% sodium fluoride in an alcohol-free base (Pro-Argin™ Mouthwash Technology) to reduce dentine permeability.

Efficacy of a mouthwash containing 0.8% arginine, PVM/MA copolymer, pyrophosphates, and 0.05% sodium fluoride compared to a negative control mouthwash on dentin hypersensitivity reduction. A randomized clinical trial.

Objective: The objective of this eight week, single-center, two-cell, double-blind, and randomized clinical study was to evaluate the dentin hypersensitivity reduction efficacy of a mouthwash using Pro-Argin™ Mouthwash Technology containing 0.8% arginine, PVM/MA copolymer, pyrophosphates, and 0.05% sodium fluoride in an alcohol-free base ("Arginine Mouthwash") compared to an ordinary mouthwash without any active ingredients ("Negative Control").

Anti-hypersensitivity mechanism of action for a dentifrice containing 0.3% triclosan, 2.0% PVM/MA copolymer, 0.243% NaF and specially-designed silica.

Purpose: To evaluate the laboratory dentin occlusion efficacy and effects on dentin permeability of a new multi-benefit dentifrice in order to gain insight into the mechanism of action of a novel technology for dentin hypersensitivity relief based on a specially-designed silica and copolymer system.

Methods: Acid-etched human dentin was evaluated with confocal laser scanning microscopy (CLSM) and scanning electron microscopy (SEM) after treatment with one of the following: (1) a dentifrice containing 0.3% triclosan, 2.

Langmuir and Langmuir-Blodgett films containing a porphyrin-ruthenium complex.

The fabrication of supramolecular structures from the tetraruthenated porphyrin-containing phosphines, {TPyP[RuCl3(dppb)]4}, RuTPyP, is demonstrated with Langmuir and Langmuir-Blodgett films. The surface pressure-molecular area isotherms (pi-A) point to an edge-on arrangement for the RuTPyP molecules in the condensed state. Weak aggregation in the Langmuir films was indicated by non-zero surface potentials at large areas per molecule and a slight red shift in the ultraviolet-visible absorption spectrum in comparison to the spectrum in solution.

Self-doping effect in poly(o-methoxyaniline)/poly(3-thiopheneacetic acid) layer-by-layer films.

Nanostructured films from two conducting polymers, poly(o-methoxyaniline) (POMA) and poly(3-thiopheneacetic acid) (PTAA), were fabricated with the layer-by-layer (LBL) technique. The electrochemical response of the LBL films differs from that of a POMA cast film, even in a potential range where PTAA is inactive. This is attributed to differences in the diffusion-controlled charge and mass transport, where distinct ionic species participate in the LBL films, as demonstrated by quartz crystal microbalance measurements.

The interaction between OPH and paraoxon at the air-water interface studied by AFM and epifluorescence microscopies.

The paraoxon hydrolysis reaction catalyzed by organophosphorus hydrolase (OPH) monolayer at the air-water interface was studied. OPH-paraoxon interactions, occurring at the two-dimensional interface, by close-packed, highly orientated OPH monolayer, were investigated by several different surface chemistry techniques; e.g.

Langmuir and Langmuir-Blodgett films of organophosphorus acid anhydrolase.

In this paper, we describe the preparation and characterization of Langmuir and Langmuir-Blodgett (LB) monolayers of the enzyme organophosphorus acid anhydrolase (OPAA). Langmuir films of OPAA were characterized on different subphases, such as phosphate, ammonium carbonate, and bis-tris-propane buffers. Monolayers at the air-water interface were characterized by measuring the surface pressure and surface potential-area isotherms.

Layer-by-layer self-assembled chitosan/poly(thiophene-3-acetic acid) and organophosphorus hydrolase multilayers.

The aim of this study is to immobilize an enzyme, namely, organophosphorus hydrolase (OPH), and to detect the presence of paraoxon, which is an organophosphorus compound, using the layer-by-layer (LbL) deposition technique. To lift the OPH from the solid substrate, a pair of polyelectrolytes (positively charged chitosan (CS) and negatively charged poly(thiophene-3-acetic acid) (PTAA)) were combined. These species were made charged by altering the pH of the solutions.