Curved versus straight-cut hinges for open-door laminoplasty: A finite element and biomechanical study.

In this study, the stabilities of the hinge sides of plate-augmented open-door laminoplasties based on cutting in a curved or straight line were compared using a finite element (FE) model and an experimental assessment. Using FE models generated from CT scans of a human subject, straight and curved techniques for cutting the hinge side were evaluated. Compressive forces were applied to both simulated models, and the stress distributions on the respective hinge sites were evaluated by comparing the maximum von Mises stresses.

Design and evaluation of a hydraulic mechanism with available components for passive knee prostheses.

Background: Hydraulic knee prosthesis can provide stance phase control and swing phase control suitable for active persons with an amputation. However, typical commercial hydraulic knees are costly and require frequent maintenance making them inaccessible for persons with an amputation in low-income countries. The objective of this article is to present a new design for a low-cost hydraulic knee prosthesis.

An EMG-CT method using multiple surface electrodes in the forearm.

Electromyography computed tomography (EMG-CT) method is proposed for visualizing the individual muscle activities in the human forearm. An EMG conduction model was formulated for reverse-estimation of muscle activities using EMG signals obtained with multi surface electrodes. The optimization process was calculated using sequential quadratic programming by comparing the estimated EMG values from the model with the measured values.