Effect of dentine conditioners on the bonding efficacy of one-bottle adhesives.

The bonding efficacy of four one-bottle adhesives (OptiBond Solo Plus, Gluma Comfort Bond, One Step and Prime & Bond NT) and a multi-step adhesive (Clearfil Photo Bond) as a control was evaluated. The dentine cavity wall was conditioned with phosphoric acid or ethylenediaminetetraacetic acid (EDTA) and the marginal integrity was estimated by measuring the wall-to-wall contraction gap width between the composite and the dentine cavity surface. In the positive control group, the adhesive was applied following glyceryl methacrylate (GM) priming.

Effect of multiple application of a dentin adhesive on contraction gap width of a resin-based composite.

Purpose: To test the efficacy of the multiple application of a total-etch dentin adhesive was investigated by measuring (1) the contraction gap width of a light-activated resin-based composite in a cylindrical dentin cavity and (2) the early tensile bond strength to a flat dentin surface with the Single Bond Dental Adhesive System.

Materials And Methods: Contraction gap width was measured in a cylindrical dentin cavity (3 mm x 1.5 mm) treated with a single coat or double coats of the Single Bond adhesive and restored with Silux Plus or Z-100.

The efficacy of dentine adhesive to sclerotic dentine.

Objective: To evaluate the effect of a dentine bonding system to sclerotic dentine in comparison with normal dentine.

Methods: The efficacy of the dentine bonding system to sclerotic dentine was examined by measuring wall-to-wall polymerization contraction gap width. The dentine cavity wall was pretreated with an experimental dentine bonding system with and without a dentine primer.

Efficacy of dentin bonding to cervical defects.

The bonding efficacy of sclerotic dentin was determined by measuring the polymerization contraction gap width of a commercial light-activated resin composite in a cervical defect and by measuring the micro-Vicker's hardness at the dentin adhesive surface; morphological characteristics were observed using a scanning electron microscope in extracted human incisors and premolars. Contraction gap formation was completely prevented when the cavity wall was primed with 35 vol% glyceryl mono-methacrylate solution after 0.5 mol/L EDTA conditioning.

Depth of cure and marginal adaptation to dentin of xenon lamp polymerized resin composites.

Marginal adaptation of four resin composites (Clearfil APX, Estelite, Silux Plus and Z-100) cured with two xenon lamp units (Plasma Arc Curing System or Apollo 95E) or a halogen lamp unit (Witelite) were evaluated by measuring the wall-to-wall contraction gap width. A cylindrical dentin cavity (ø3 mm x 1.5 mm) prepared in an extracted human molar was treated with the Megabond system or an experimental bonding system consisting of 0.