On the feasibility to conduct gradient liquid chromatography separations in narrow-bore columns at pressures up to 2000bar.

The limits in operating pressures are extended for narrow-bore columns in gradient elution up to 2000bar. As the required pumps for these pressures are incompatible with common chromatographic solvents and are not suitable to apply a mobile phase composition gradient, a mobile phase delivery and injection system is described and experimentally validated which allows to use any possible chromatographic solvent in isocratic and gradient elution. The mobile phase delivery and injection system also allows to perform multiple separations without the need to depressurize the column.

Effect of reference conditions on flow rate, modifier fraction and retention in supercritical fluid chromatography.

When using compressible mobile phases such as fluidic CO2, the density, the volumetric flow rates and volumetric fractions are pressure dependent. The pressure and temperature definition of these volumetric parameters (referred to as the reference conditions) may alter between systems, manufacturers and operating conditions. A supercritical fluid chromatography system was modified to operate in two modes with different definition of the eluent delivery parameters, referred to as fixed and variable mode.

Using the column wall itself as resistive heater for fast temperature gradients in liquid chromatography.

A new system is proposed for applying fast temperature gradients in liquid chromatography. It consists of a 0.7 mm × 150 mm fused-silica column coated with a 50 μm Nickel-layer, which is connecting with a power source and a temperature control system to perform fast and reproducible temperature gradients using the column wall itself as a resistive heater.

Understanding and diminishing the extra-column band broadening effects in supercritical fluid chromatography.

Supercritical fluid chromatography, where a low-viscosity mobile phase such as carbon dioxide is used, proves to be an excellent technique for fast and efficient separations, especially when sub-2μm particles are used. However, to achieve high velocities when using these small particles, and in order to stay within the flow rate range of current SFC-instruments, narrow columns (e.g.

Exploring the speed-resolution limits of supercritical fluid chromatography at ultra-high pressures.

The limits of supercritical fluid chromatography have been experimentally explored using inlet pressures at the limits of the current commercial instrumentation (400-600 bar), as well as pressures significantly surpassing this (up to 1050 bar). It was found that efficiencies in the range of 200,000 theoretical plates can be achieved for a void time t0 of roughly 6min using superficially porous particles (2.7 and 4.

Temperature effects in supercritical fluid chromatography: a trade-off between viscous heating and decompression cooling.

The study of radial and axial temperature profiles always has been an area interest both in liquid chromatography (LC) and supercritical fluid chromatography (SFC). Whereas in LC always an increase in temperature is observed due to the dominance of viscous heating, in SFC, especially for low modifier content, a decrease in temperature is found due to the much larger decompression cooling. However, for higher modifier content and higher operating pressure, the temperature effects become a trade-off between viscous heating and decompression cooling, since in SFC the latter is a strong function of operating pressure and mobile phase composition.

Occurrence of turbulent flow conditions in supercritical fluid chromatography.

Having similar densities as liquids but with viscosities up to 20 times lower (higher diffusion coefficients), supercritical CO2 is the ideal (co-)solvent for fast and/or highly efficient separations without mass-transfer limitations or excessive column pressure drops. Whereas in liquid chromatography the flow remains laminar in both the packed bed and tubing, except in extreme cases (e.g.

Extending the limits of operating pressure of narrow-bore column liquid chromatography instrumentation.

The increase of the operating pressure in Liquid Chromatography, has been one of the crucial steps toward faster and more efficient separations. In the present contribution, it was investigated if the pressure limits for narrow-bore columns (2.1mm ID) could be increased beyond those of commercially available (1300bar) instrumentation without performance loss.

Theoretical evaluation of the advantages and limitations of constant pressure versus constant flow rate gradient elution separation in supercritical fluid chromatography.

This study reports on the possible advantages of switching from constant flow (cF) based gradient elution separations to constant pressure (cP) based ones in Supercritical fluid chromatography (SFC) by means of mathematical models. All the important parameters (e.g.

Possibilities and limitations of the kinetic plot method in supercritical fluid chromatography.

Although supercritical fluid chromatography (SFC) is becoming a technique of increasing importance in the field of analytical chromatography, methods to compare the performance of SFC-columns and separations in an unbiased way are not fully developed. The present study uses mathematical models to investigate the possibilities and limitations of the kinetic plot method in SFC as this easily allows to investigate a wide range of operating pressures, retention and mobile phase conditions. The variable column length (L) kinetic plot method was further investigated in this work.