Sol-gel synthesis of nano-scale, end-member albite feldspar (NaAlSiO).

Feldspars are the most abundant minerals in the Earth's crust, and are also important constituents of many lunar rocks and some stony meteorites. Albite (NaAlSiO) makes up the sodium corner of the feldspar ternary diagram (KAlSiO - NaAlSiO - CaAlSiO) and connects the alkali-feldspar and plagioclase binary joins. Synthesis of albite, however, has long been a problem, even at high temperatures and even at high pressures when dry.

Sorption, solubility and cytotoxicity of novel antibacterial nanofilled dental adhesive resins.

Dental adhesives hydrolyze in the mouth. This study investigated the water sorption (SOR), solubility (SOL) and cytotoxicity (CYTO) of experimental adhesives containing nitrogen-doped titanium dioxide nanoparticles (N_TiO). Specimens (n = 15/group [SOR, SOL]; n = 10/group [CYTO]) of unaltered Clearfil SE Protect (CSP), OptiBond Solo Plus (OSP), Adper Scotchbond (ASB) and experimental adhesives (OSP + 25% or 30% of N_TiO) were fabricated, desiccated (37 °C) and tested for SOR and SOL according to ISO Specification 4049 (2009).

Advanced characterization of surface-modified nanoparticles and nanofilled antibacterial dental adhesive resins.

Nanotechnology can improve the performance of dental polymers. The objective of this study was to modify the surfaces of nanoparticles with silanes and proteins, characterize nanoparticles' agglomeration levels and interfaces between nanoparticles and the polymeric matrix. Undoped (n-TiO), nitrogen-doped (N_TiO) and nitrogen-fluorine co-doped titanium dioxide nanoparticles (NF_TiO) were synthesized and subjected to surface modification procedures in preparation for Small-Angle X-Ray Scattering (SAXS) and Small-Angle Neutron Scattering (SANS) characterizations.

Optimization of a real-time high-throughput assay for assessment of Streptococcus mutans metabolism and screening of antibacterial dental adhesives.

Objective: The present work shows the optimization of a high-throughput bioluminescence assay to assess the metabolism of intact Streptococcus mutans biofilms and its utility as a screening method for nanofilled antibacterial dental materials.

Methods: The assay was optimized by monitoring changes in bioluminescence mediated by variation of the experimental parameters investigated (growth media and sucrose concentration, inoculum:D-Luciferin ratio, dilution factor, inoculum volume, luminescence wavelength, replicate and luciferase metabolic activity). Confocal microscopy was then used to demonstrate the impact of biofilm growth conditions on the 3-D distribution of extracellular polymeric substance (EPS) within Streptococcus mutans biofilms and its implications as confounding factors in high-throughput studies (HTS).

Ionic Conductance through Graphene: Assessing Its Applicability as a Proton Selective Membrane.

Inspired by recent reports on possible proton conductance through graphene, we have investigated the behavior of pristine graphene and defect engineered graphene membranes for ionic conductance and selectivity with the goal of evaluating a possibility of its application as a proton selective membrane. The averaged conductance for pristine chemical vapor deposited (CVD) graphene at pH1 is ∼4 mS/cm but varies strongly due to contributions from the unavoidable defects in our CVD graphene. From the variations in the conductance with electrolyte strength and pH, we can conclude that pristine graphene is fairly selective and the conductance is mainly due to protons.

Adsorption of Molecular Nitrogen in Electrical Double Layers near Planar and Atomically Sharp Electrodes.

The adsorption of gas molecules at electrode-electrolyte interfaces is an important step in electrochemical reactions. Using molecular dynamics simulations, we investigate the adsorption of dissolved N in the electrical double layers (EDLs) of an aqueous electrolyte near planar and 1 nm radius spherical carbon electrodes. The adsorption of N is found to be overall enriched near neutral electrodes regardless of their surface curvature, although it can be locally enriched or depleted depending on the distance from the electrode surface.

Antibacterial dental adhesive resins containing nitrogen-doped titanium dioxide nanoparticles.

Unlabelled: The development of dental adhesive resins with long-lasting antibacterial properties is a possible solution to overcome the problem of secondary caries in modern adhesive dentistry.

Objectives: (i) Synthesis and characterization of nitrogen-doped titanium dioxide nanoparticles (N_TiO), (ii) topographical, compositional and wettability characterization of thin-films (unaltered and experimental) and, (iii) antibacterial efficacy of N_TiO-containing dental adhesives against Streptococcus mutans biofilms.

Materials And Methods: Nanoparticles were synthesized and characterized using different techniques.

A physical catalyst for the electrolysis of nitrogen to ammonia.

Ammonia synthesis consumes 3 to 5% of the world's natural gas, making it a significant contributor to greenhouse gas emissions. Strategies for synthesizing ammonia that are not dependent on the energy-intensive and methane-based Haber-Bosch process are critically important for reducing global energy consumption and minimizing climate change. Motivated by a need to investigate novel nitrogen fixation mechanisms, we herein describe a highly textured physical catalyst, composed of N-doped carbon nanospikes, that electrochemically reduces dissolved N gas to ammonia in an aqueous electrolyte under ambient conditions.

Author Correction: Facile emulsion mediated synthesis of phase-pure diopside nanoparticles.

A correction to this article has been published and is linked from the HTML and PDF versions of this paper. The error has not been fixed in the paper.

Facile emulsion mediated synthesis of phase-pure diopside nanoparticles.

Diopside is a common natural pyroxene that is rarely found in a pure state, since magnesium is often partially substituted by iron, and other elements (sodium and aluminum) are often present. This pyroxene, along with feldspars and olivines, is common in concrete. As the prospective license renewal of light water reactors to 80 years of operation has raised concerns on the effects of radiation in the concrete biological shield surrounding the reactors, mineral nanoparticles can be valuable to perform amorphization studies to inform predictive models of mechanical properties of irradiated concrete.

Nano-scale synthesis of the complex silicate minerals forsterite and enstatite.

Olivine is a relatively common family of silicate minerals in many terrestrial and extraterrestrial environments, and is also useful as a refractory ceramic. A capability to synthesize fine particles of olivine will enable additional studies on surface reactivity under geologically relevant conditions. This paper presents a method for the synthesis of nanocrystalline samples of the magnesium end-member, forsterite (MgSiO) in relatively large batches (15-20g) using a sol-gel/surfactant approach.

Atomistic-Scale Simulations of Defect Formation in Graphene under Noble Gas Ion Irradiation.

Despite the frequent use of noble gas ion irradiation of graphene, the atomistic-scale details, including the effects of dose, energy, and ion bombardment species on defect formation, and the associated dynamic processes involved in the irradiations and subsequent relaxation have not yet been thoroughly studied. Here, we simulated the irradiation of graphene with noble gas ions and the subsequent effects of annealing. Lattice defects, including nanopores, were generated after the annealing of the irradiated graphene, which was the result of structural relaxation that allowed the vacancy-type defects to coalesce into a larger defect.

Focused helium-ion beam irradiation effects on electrical transport properties of few-layer WSe2: enabling nanoscale direct write homo-junctions.

Atomically thin transition metal dichalcogenides (TMDs) are currently receiving significant attention due to their promising opto-electronic properties. Tuning optical and electrical properties of mono and few-layer TMDs, such as tungsten diselenide (WSe2), by controlling the defects, is an intriguing opportunity to synthesize next generation two dimensional material opto-electronic devices. Here, we report the effects of focused helium ion beam irradiation on the structural, optical and electrical properties of few-layer WSe2, via high resolution scanning transmission electron microscopy, Raman spectroscopy, and electrical transport measurements.

Polarization Control via He-Ion Beam Induced Nanofabrication in Layered Ferroelectric Semiconductors.

Rapid advances in nanoscience rely on continuous improvements of material manipulation at near-atomic scales. Currently, the workhorse of nanofabrication is resist-based lithography and its various derivatives. However, the use of local electron, ion, and physical probe methods is expanding, driven largely by the need for fabrication without the multistep preparation processes that can result in contamination from resists and solvents.

Graphene engineering by neon ion beams.

Achieving the ultimate limits of lithographic resolution and material performance necessitates engineering of matter with atomic, molecular, and mesoscale fidelity. With the advent of scanning helium ion microscopy, maskless He(+) and Ne(+) beam lithography of 2D materials, such as graphene-based nanoelectronics, is coming to the forefront as a tool for fabrication and surface manipulation. However, the effects of using a Ne focused-ion-beam on the fidelity of structures created out of 2D materials have yet to be explored.

Development of Electrochemical Small-Angle Neutron Scattering (eSANS) for Simultaneous Structure and Redox Characterization of Nanoparticles.

An electrochemical small-angle neutron scattering (eSANS) method was developed to measure simultaneously the redox properties and size, shape and interactions of solution-dispersed nanomaterials. By combining multi-step potentials and chronocoulometry readout with SANS, the structure and redox properties of engineered nanomaterials are followed in one experiment. Specifically, ZnO nanoparticles were examined as dilute dispersions in pH buffered deuterium oxide solutions under negative electrode potentials.

Improvement of the fracture toughness of hydroxyapatite (HAp) by incorporation of carboxyl functionalized single walled carbon nanotubes (CfSWCNTs) and nylon.

The potential of improving the fracture toughness of synthetic hydroxyapatite (HAp) by incorporating carboxyl functionalized single walled carbon nanotubes (CfSWCNTs) and polymerized ε-caprolactam (nylon) was studied. A series of HAp samples with CfSWCNTs concentrations varying from 0 to 1.5 wt.

Structural Phase Transitions and Water Dynamics in Uranyl Fluoride Hydrates.

We report a novel production method for uranium oxyfluoride [(UO2)7F14(H2O)7]·4H2O, referred to as structure D. Structure D is produced as a product of hydrating anhydrous uranyl fluoride, UO2F2, through the gas phase at ambient temperatures followed by desiccation by equilibration with a dry environment. We follow the structure of [(UO2)7F14(H2O)7]·4H2O through an intermediate, liquid-like phase, wherein the coordination number of the uranyl ion is reduced to 5 (from 6 in the anhydrous structure), and a water molecule binds as an equatorial ligand to the uranyl ion.

Degradation of Trichloroethene with a Novel Ball Milled Fe-C Nanocomposite.

Nanoscale zero-valent iron (NZVI) is effective in reductively degrading dense non-aqueous phase liquids (DNAPLs), such as trichloroethene (TCE), in groundwater (i.e., dechlorination) although the NZVI technology itself still suffers from high material costs and inability to target hydrophobic contaminants in source zones.

Correlating high power conversion efficiency of PTB7:PC71BM inverted organic solar cells with nanoscale structures.

Advances in material design and device engineering led to inverted organic solar cells (i-OSCs) with superior power conversion efficiencies (PCEs) compared to their "conventional" counterparts, in addition to the well-known better ambient stability. Here, we report an in-depth morphology study of the i-OSC active and cathode modifying layers, employing a model system with a well-established bulk-heterojunction, PTB7:PC71BM as the active layer and poly-[(9,9-bis(3'-(N,N-dimethylamino)propyl)-2,7-fluorene)-alt-2,7-(9,9-dioctylfluorene)] (PFN) as the cathode surface modifying layer. We have also identified the role of a processing additive, 1,8-diiodooctane (DIO), used in the spin-casting of the active layer to increase PCE.

Maskless Lithography and in situ Visualization of Conductivity of Graphene using Helium Ion Microscopy.

The remarkable mechanical and electronic properties of graphene make it an ideal candidate for next generation nanoelectronics. With the recent development of commercial-level single-crystal graphene layers, the potential for manufacturing household graphene-based devices has improved, but significant challenges still remain with regards to patterning the graphene into devices. In the case of graphene supported on a substrate, traditional nanofabrication techniques such as e-beam lithography (EBL) are often used in fabricating graphene nanoribbons but the multi-step processes they require can result in contamination of the graphene with resists and solvents.

Synthesis and characterization of lanthanum phosphate nanoparticles as carriers for (223)Ra and (225)Ra for targeted alpha therapy.

Introduction: Targeted alpha therapy (TAT) has the potential for killing micro-metastases with minimum collateral damage to surrounding healthy tissue. In-vivo generator radionuclides, such as(223)Ra, (225)Ra, and (225)Ac, are of special interest for radiotherapeutic applications as they emit multiple α-particles during their decay. Utilizing appropriate carriers capable of retaining both the parent radioisotope as well as daughter products is important for the effective delivery of the radioisotope to the tumor site while mitigating global in vivo radiotoxicity.

Nanostructure enhanced ionic transport in fullerene reinforced solid polymer electrolytes.

Solid polymer electrolytes, such as polyethylene oxide (PEO) based systems, have the potential to replace liquid electrolytes in secondary lithium batteries with flexible, safe, and mechanically robust designs. Previously reported PEO nanocomposite electrolytes routinely use metal oxide nanoparticles that are often 5-10 nm in diameter or larger. The mechanism of those oxide particle-based polymer nanocomposite electrolytes is under debate and the ion transport performance of these systems is still to be improved.

Scalable production of microbially mediated zinc sulfide nanoparticles and application to functional thin films.

A series of semiconducting zinc sulfide (ZnS) nanoparticles were scalably, reproducibly, controllably and economically synthesized with anaerobic metal-reducing Thermoanaerobacter species. These bacteria reduced partially oxidized sulfur sources to sulfides that extracellularly and thermodynamically incorporated with zinc ions to produce sparingly soluble ZnS nanoparticles with ∼5nm crystallites at yields of ∼5gl(-1)month(-1). A predominant sphalerite formation was facilitated by rapid precipitation kinetics, a low cation/anion ratio and a higher zinc concentration compared to background to produce a naturally occurring hexagonal form at the low temperature, and/or water adsorption in aqueous conditions.