Chlorophyll-a specific volume scattering function of phytoplankton.

Chlorophyll-a specific light volume scattering functions (VSFs) by cultured phytoplankton in visible spectrum range is presented. Chlorophyll-a specific VSFs were determined based on the linear least squares method using a measured VSFs with different chlorophyll-a concentrations. We found obvious variability of it in terms of spectral and angular shapes of VSF between cultures.

Accurate estimation of the backscattering coefficient by light scattering at two backward angles.

Backscattering coefficients are frequently estimated from light scattering at one backward angle multiplied by a conversion factor. We determined that the shapes of the volume scattering functions (VSFs), particularly for scattering angles larger than 170°, cause significant variations in the conversion factor at 120°. Our approach uses the ratio of scattering at 170° and at 120°, which is a good indicator of the shape differences of the VSFs for most oceanic waters and wavelengths in the visible range.

A new approach to measure the volume scattering function.

We present a novel optical approach to measure the volume scattering function (VSF) by image detection. The instrument design, based upon a combination of two reflectors, uses a unique measurement principle and allows the rapid simultaneous determination of scattering at a wide range of angles. The advantages of the newly developed scattering meter are that: 1) it can determine the scattering function from 8° to 172° at 1° intervals without changing the sensitivity of the detector, without moving any optical parts, and can do so within a few seconds, 2) the unique optical design facilitates determination of the spectral VSF over the full visible spectrum, i.

Simultaneous illumination method: application in a two-channel emission fluorometer with multi-wavelength excitation.

We developed a new illumination method called the simultaneous illumination method. This method does not require synchronization between light sources and sensor signals, which drastically simplifies the instrumentation. As a proof-of-concept, we applied this method to an oceanographic fluorometer.

Practical test of a point-source integrating cavity absorption meter: the performance of different collector assemblies.

A prototype point-source integrating cavity absorption meter (PSICAM) is presented and compared with spectrophotometric absorption measurements. Different light collector assemblies of the PSICAM were tested regarding their capability to determine the absorption of water constituents accurately over a wide range of concentrations and scattering properties. The PSICAM setup with a radiance-type sensor showed the best performance.