Analysis of the Biomechanical Behavior of an Animal Model of Triple Hamstring Graft Configuration for Combined ACL and ALL Reconstruction with a Single Femoral Tunnel and a Single Strand for ALL Reconstruction.

 To describe and biomechanically test a configuration, in an animal model that simulates the triple hamstring graft for combined anterior cruciate ligament (ACL) and anterolateral ligament (ALL) reconstruction, with a single femoral tunnel and a single strand for ALL reconstruction.  Deep flexor porcine tendons were used as the graft and fixed with titanium interference screws in a polyurethane block. The samples were divided into 3 groups: group 1 (control) - with a quadruple graft; group 2-with a simple triple graft; and group 3-with a braided triple graft.

Analysis of the Mechanical Behavior of Porcine Graft Fixation in a Polyurethane Block Using a 3D-printed PLA Interference Screw.

 The interest in using 3D printing in the healthcare field has grown over the years, given its advantages and potential in the rapid manufacturing of personalized devices and implants with complex geometries. Thus, the aim of the present study was to compare the mechanical fixation behavior of a 3D-printed interference screw, produced by fused deposition modeling of polylactic acid (PLA) filament, with that of a titanium interference screw.  Eight deep flexor porcine tendons, approximately 8 mm wide and 9 cm long, were used as graft and fixed to a 40 pounds-per-cubic-foot (PCF) polyurethane block at each of its extremities.