Electrostatic polarization fields trigger glioblastoma stem cell differentiation.

Over the last few years it has been understood that the interface between living cells and the underlying materials can be a powerful tool to manipulate cell functions. In this study, we explore the hypothesis that the electrical cell/material interface can regulate the differentiation of cancer stem-like cells (CSCs). Electrospun polymer fibres, either polyamide 66 or poly(lactic acid), with embedded graphene nanoplatelets (GnPs), have been fabricated as CSC scaffolds, providing both the 3D microenvironment and a suitable electrical environment favorable for CSCs adhesion, growth and differentiation.

Strategy for primary prevention of non-communicable diseases (NCD) and mitigation of climate change in Italy.

This paper derives from a document commissioned in 2019 by the Italian Minister of Health, and outlines a general strategy for primary prevention of non-communicable diseases in Italy, with a special focus on cobenefits of climate change mitigation. Given that action against climate change is primarily taken via energy choices, limiting the use of fossil fuels and promoting renewable sources, an effective strategy is one in which interventions are designed to prevent diseases and jointly mitigate climate change, the so-called cobenefits. For policies capable of producing relevant co-benefits we focus on three categories of interventions, urban planning, diet and transport that are of special importance.

Comprehensive Enhancement in Thermomechanical Performance of Melt-Extruded PEEK Filaments by Graphene Incorporation.

A simple and scalable fabrication process of graphene nanoplatelets (GnPs)-reinforced polyether ether ketone (PEEK) filaments with enhanced mechanical and thermal performance was successfully demonstrated in this work. The developed PEEK-GnP nanocomposite filaments by a melt-extrusion process showed excellent improvement in storage modulus at 30 °C (61%), and significant enhancement in tensile strength (34%), Young's modulus (25%), and elongation at break (37%) when GnP content of 1.0 wt.

Biodegradable and Insoluble Cellulose Photonic Crystals and Metasurfaces.

The replacement of plastic with eco-friendly and biodegradable materials is one of the most stringent environmental challenges. In this respect, cellulose stands out as a biodegradable polymer. However, a significant challenge is to obtain biodegradable materials for high-end photonics that are robust in humid environments.

Thermoresponsive Iron Oxide Nanocubes for an Effective Clinical Translation of Magnetic Hyperthermia and Heat-Mediated Chemotherapy.

The use of magnetic nanoparticles in oncothermia has been investigated for decades, but an effective combination of magnetic nanoparticles and localized chemotherapy under clinical magnetic hyperthermia (MH) conditions calls for novel platforms. In this study, we have engineered magnetic thermoresponsive iron oxide nanocubes (TR-cubes) to merge MH treatment with heat-mediated drug delivery, having in mind the clinical translation of the nanoplatform. We have chosen iron oxide based nanoparticles with a cubic shape because of their outstanding heat performance under MH clinical conditions, which makes them benchmark agents for MH.

Triggering Cation Exchange Reactions by Doping.

Cation exchange (CE) reactions have emerged as a technologically important route, complementary to the colloidal synthesis, to produce nanostructures of different geometries and compositions for a variety of applications. Here it is demonstrated with first-principles simulations that an interstitial impurity cation in CdSe nanocrystals weakens nearby bonds and reduces the CE barrier in the prototypical exchange of Cd ions by Ag ions. A Wannier function-based tight binding model is employed to quantify microscopic mechanisms that influence this behavior.

Ultrafast dissolution and creation of bonds in IrTe induced by photodoping.

The observation and control of interweaving spin, charge, orbital, and structural degrees of freedom in materials on ultrafast time scales reveal exotic quantum phenomena and enable new active forms of nanotechnology. Bonding is the prime example of the relation between electronic and nuclear degrees of freedom. We report direct evidence illustrating that photoexcitation can be used for ultrafast control of the breaking and recovery of bonds in solids on unprecedented time scales, near the limit for nuclear motions.

Cutin from agro-waste as a raw material for the production of bioplastics.

Cutin is the main component of plant cuticles constituting the framework that supports the rest of the cuticle components. This biopolymer is composed of esterified bi- and trifunctional fatty acids. Despite its ubiquity in terrestrial plants, it has been underutilized as raw material due to its insolubility and lack of melting point.

Cellulose-polyhydroxylated fatty acid ester-based bioplastics with tuning properties: Acylation via a mixed anhydride system.

The synthesis of microcrystalline cellulose (MCC) and 9,10,16-hydroxyhexadecanoic (aleuritic) acid ester-based bioplastics was investigated through acylation in a mixed anhydride (trifluoroacetic acid (TFA)/trifluoroacetic acid anhydride (TFAA)), chloroform co-solvent system. The effects of chemical interactions and the molar ratio of aleuritic acid to the anhydroglucose unit (AGU) of cellulose were investigated. The degree of substitution (DS) of new polymers were characterized by two-dimensional solution-state NMR and ranged from 0.

Selective Targeting of Neurons with Inorganic Nanoparticles: Revealing the Crucial Role of Nanoparticle Surface Charge.

Nanoparticles (NPs) are increasingly used in biomedical applications, but the factors that influence their interactions with living cells need to be elucidated. Here, we reveal the role of NP surface charge in determining their neuronal interactions and electrical responses. We discovered that negatively charged NPs administered at low concentration (10 nM) interact with the neuronal membrane and at the synaptic cleft, whereas positively and neutrally charged NPs never localize on neurons.

Microsurgery robots: addressing the needs of high-precision surgical interventions.

Robotics has a significant potential to enhance the overall capacity and efficiency of healthcare systems. Robots can help surgeons perform better quality operations, leading to reductions in the hospitalisation time of patients and in the impact of surgery on their postoperative quality of life. In particular, robotics can have a significant impact on microsurgery, which presents stringent requirements for superhuman precision and control of the surgical tools.

Report on First International Workshop on Robotic Surgery in Thoracic Oncology.

A workshop of experts from France, Germany, Italy, and the United States took place at Humanitas Research Hospital Milan, Italy, on February 10 and 11, 2016, to examine techniques for and applications of robotic surgery to thoracic oncology. The main topics of presentation and discussion were robotic surgery for lung resection; robot-assisted thymectomy; minimally invasive surgery for esophageal cancer; new developments in computer-assisted surgery and medical applications of robots; the challenge of costs; and future clinical research in robotic thoracic surgery. The following article summarizes the main contributions to the workshop.

A Thermochromic Superhydrophobic Surface.

Highly enhanced solid-state thermochromism is observed in regioregular poly(3-hexylthiophene), P3HT, when deposited on a superhydrophobic polymer-SiO2 nanocomposite coating. The conformal P3HT coating on the nanocomposite surface does not alter or reduce superhydrophicity while maintaining its reversible enhanced thermochromism. The polymeric matrix of the superhydrophobic surface is comprised of a blend of poly(vinylidene fluoride-co-hexafluoropropylene) copolymer and an acrylic adhesive.

Low-Cost and Effective Fabrication of Biocompatible Nanofibers from Silk and Cellulose-Rich Materials.

Here, we show the production of nanofibrous mats with controlled mechanical properties and excellent biocompatibility by combining fibroin with pure cellulose and cellulose-rich parsley powder agro-waste. To this end, trifluoroacetic acid was used as a common solvent for all of the involved biomaterials, achieving highly homogeneous blends that were suitable for the electrospinning technique. Morphological analysis revealed that the electrospun composite nanofibers were well-defined and defect-free, with a diameter in the range of 65-100 nm.

Pectin-lipid self-assembly: influence on the formation of polyhydroxy fatty acids nanoparticles.

Nanoparticles, named cutinsomes, have been prepared from aleuritic (9,10,16-trihidroxipalmitic) acid and tomato fruit cutin monomers (a mixture of mainly 9(10),16-dihydroxypalmitic acid (85%, w/w) and 16-hydroxyhexadecanoic acid (7.5%, w/w)) with pectin in aqueous solution. The process of formation of the nanoparticles of aleuritic acid plus pectin has been monitored by UV-Vis spectrophotometry, while their chemical and morphological characterization was analyzed by ATR-FTIR, TEM, and non-contact AFM.

Continuous-wave biexciton lasing at room temperature using solution-processed quantum wells.

Solution-processed inorganic and organic materials have been pursued for more than a decade as low-threshold, high-gain lasing media, motivated in large part by their tunable optoelectronic properties and ease of synthesis and processing. Although both have demonstrated stimulated emission and lasing, they have not yet approached the continuous-wave pumping regime. Two-dimensional CdSe colloidal nanosheets combine the advantage of solution synthesis with the optoelectronic properties of epitaxial two-dimensional quantum wells.

An advanced lithium-ion battery based on a graphene anode and a lithium iron phosphate cathode.

We report an advanced lithium-ion battery based on a graphene ink anode and a lithium iron phosphate cathode. By carefully balancing the cell composition and suppressing the initial irreversible capacity of the anode in the round of few cycles, we demonstrate an optimal battery performance in terms of specific capacity, that is, 165 mAhg(-1), of an estimated energy density of about 190 Wh kg(-1) and a stable operation for over 80 charge-discharge cycles. The components of the battery are low cost and potentially scalable.

Infrared and Raman spectroscopic features of plant cuticles: a review.

The cuticle is one of the most important plant barriers. It is an external and continuous lipid membrane that covers the surface of epidermal cells and whose main function is to prevent the massive loss of water. The spectroscopic characterization of the plant cuticle and its components (cutin, cutan, waxes, polysaccharides and phenolics) by infrared and Raman spectroscopies has provided significant advances in the knowledge of the functional groups present in the cuticular matrix and on their structural role, interaction and macromolecular arrangement.

A general mechanism for intracellular toxicity of metal-containing nanoparticles.

The assessment of the risks exerted by nanoparticles is a key challenge for academic, industrial, and regulatory communities worldwide. Experimental evidence points towards significant toxicity for a range of nanoparticles both in vitro and in vivo. Worldwide efforts aim at uncovering the underlying mechanisms for this toxicity.

Biomimetic approach for liquid encapsulation with nanofibrillar cloaks.

Technologies that are able to handle microvolumes of liquids, such as microfluidics and liquid marbles, are attractive for applications that include miniaturized biological and chemical reactors, sensors, microactuators, and drug delivery systems. Inspired from natural fibrous envelopes, here, we present an innovative approach for liquid encapsulation and manipulation using electrospun nanofibers. We demonstrated the realization of non-wetting soft solids consisting of a liquid core wrapped in a hydrophobic fibrillar cloak of a fluoroacrylic copolymer and cellulose acetate.

Toxicity assessment of silica coated iron oxide nanoparticles and biocompatibility improvement by surface engineering.

We have studied in vitro toxicity of iron oxide nanoparticles (NPs) coated with a thin silica shell (Fe3O4/SiO2 NPs) on A549 and HeLa cells. We compared bare and surface passivated Fe3O4/SiO2 NPs to evaluate the effects of the coating on the particle stability and toxicity. NPs cytotoxicity was investigated by cell viability, membrane integrity, mitochondrial membrane potential (MMP), reactive oxygen species (ROS) assays, and their genotoxicity by comet assay.

Nanocomposite pattern-mediated magnetic interactions for localized deposition of nanomaterials.

We present a method to create, align, and locate magnetic wires throughout and on the surface of patterned polymer matrices, following the magnetophoretic transport and self-assembly of ferromagnetic nanoparticles under a static magnetic field during laser photopolymerization of monomer/nanoparticle casted solutions. The resulting films have the ability to attract and immobilize small quantities of magnetic nanomaterials locally on the ferromagnetic wires, as proved by a detailed topography study. Magnetic studies on the films before and after the spontaneous deposition, demonstrate that the deposited nanomaterials alter significantly the magnetic character of the system, making thus possible their macroscopic identification.

Gold-nanoparticle-based colorimetric discrimination of cancer-related point mutations with picomolar sensitivity.

Point mutations in the Kirsten rat sarcoma viral oncogene homologue (KRAS) gene are being increasingly recognized as important diagnostic and prognostic markers in cancer. In this work, we describe a rapid and low-cost method for the naked-eye detection of cancer-related point mutations in KRAS based on gold nanoparticles. This simple colorimetric assay is sensitive (limit of detection in the low picomolar range), instrument-free, and employs nonstringent room temperature conditions due to a combination of DNA-conjugated gold nanoparticles, a probe design which exploits cooperative hybridization for increased binding affinity, and signal enhancement on the surface of magnetic beads.

Subnanometer local temperature probing and remotely controlled drug release based on azo-functionalized iron oxide nanoparticles.

Local heating can be produced by iron oxide nanoparticles (IONPs) when exposed to an alternating magnetic field (AMF). To measure the temperature profile at the nanoparticle surface with a subnanometer resolution, here we present a molecular temperature probe based on the thermal decomposition of a thermo-sensitive molecule, namely, azobis[N-(2-carboxyethyl)-2-methylpropionamidine]. Fluoresceineamine (FA) was bound to the azo molecule at the IONP surface functionalized with poly(ethylene glycol) (PEG) spacers of different molecular weights.