Purpose: In amorphous solid dispersions (ASDs), the chemical potential of a drug can be reduced due to mixing with the polymer in the solid matrix, and this can lead to reduced drug release when the polymer is insoluble in the dissolution media. If both the drug and the polymer composing an ASD are ionizable, drug release from the ASD becomes pH-dependent. The goal of this study was to gain insights into the pH-dependent solubility suppression from ASD formulations.
View Article and Find Full Text PDFTo improve the dissolution and hence the oral bioavailability, amorphous felodipine (FEL) solid dispersions (SDs) with Kollidon® VA 64 (PVP/VA) were prepared. Hot-melt extrusion was employed with an extruding temperature below the melting point (Tm ) of FEL. X-ray powder diffraction (XRPD) and (13) C CP/MAS nuclear magnetic resonance (NMR) measurements show that the extrudates are amorphous.
View Article and Find Full Text PDFWe report the first case of a pharmaceutical cocrystal formed between an inorganic acid and an active pharmaceutical ingredient (API), which enabled us to develop a stable crystalline and bioavailable solid dosage form for pharmaceutical development where otherwise only unstable amorphous free form or salts could have been used.
View Article and Find Full Text PDFA method to detect and quantify a small amount crystalline material within a liquid solution of solubilized material is described. 19F CP-MAS ssNMR was investigated as a technique to detect low levels (0.2 mg/g) of crystalline sodium (2R)-7-{3-[2-chloro-4-(2,2,2-trifluoroethoxy)phenoxy]propoxy}-2-methyl-3,4-dihydro-2H-chromane-2-carboxylate (I) within a solid mixture (with microcrystalline cellulose) and a slurry with a liquid vehicle (capric and caprylic acid triglycerides).
View Article and Find Full Text PDFA thermally induced irreversible conformational transition of amylose tris(3,5-dimethylphenylcarbamate) (i.e., Chiralpak AD) chiral stationary phase (CSP) in the enantioseparation of dihydropyrimidinone (DHP) acid racemate was studied for the first time by quasi-equilibrated liquid chromatography with cyclic van't Hoff and step temperature programs and solid-state ((13)C CPMAS and (19)F MAS) NMR using ethanol and trifluoroacetic acid (TFA)-modified n-hexane as the mobile phase.
View Article and Find Full Text PDFFollowing a previous publication, the present paper reports additional results on the effects of alcohol mobile-phase modifiers on the structure and chiral selectivity of amylose tris(3,5-dimethylphenylcarbamate) (Chiralpak AD) chiral stationary phase (CSP). Solid-state NMR (1H/13C CPMAS) was utilized to identify and compare structural differences in Chiralpak AD caused by the various alcohol mobile-phase modifiers, many of which were not studied in the previous publication. The influences of the various alcohol modifiers (in hexane-based mobile phase) on the structure and chiral selectivity of the CSP were studied and compared.
View Article and Find Full Text PDFIn this study, we report the use of attenuated total reflectance Fourier transform infrared spectroscopy (ATR-FT-IR) for the identification and quantitation of two polymorphs of Aprepitant, a substance P antagonist for chemotherapy-induced emesis. Mixtures of the polymorph pair were prepared by weight and ATR-FT-IR spectra of the powdered samples were obtained over the wavelength range of 700-1500 cm(-1). Significant spectral differences between the two polymorphs at 1140 cm(-1) show that ATR-FT-IR can provide definitive identification of the polymorphs.
View Article and Find Full Text PDFThe purpose of the following investigation was to display the utility of 19F solid-state nuclear magnetic resonance (NMR) in both distinguishing between solid forms of a selective muscarinic M3 receptor antagonist and characterizing the active pharmaceutical ingredient in low-dose tablets. Ambient- and elevated-temperature solid-state 19F fast (15 kHz) magic-angle spinning (MAS) NMR experiments were employed to obtain desired spectral resolution in this system. Ambient sample temperature combined with rotor frequencies of 15 kHz provided adequate 19F peak resolution to successfully distinguish crystalline and amorphous forms in this system.
View Article and Find Full Text PDF