Integration of paper-based analytical devices with digital microfluidics for colorimetric detection of creatinine.

Digital microfluidics (DMF) is a platform that enables the automated manipulation of individual droplets of sizes ranging from nanoliter to microliter and can be coupled with numerous techniques, including colorimetry. However, although the DMF electrode architecture is highly versatile, its integration with different analytical methods often requires either changes in sample access, top plate design, or the integration of supplementary equipment into the system. As an alternative to overcome these challenges, this study proposes a simple integration between paper-based analytical devices (PADs) and DMF for automated and eco-friendly sample processing aiming at the colorimetric detection of creatinine (CR, an important biomarker for kidney disease) in artificial urine.

Integration of complementary split-ring resonators into digital microfluidics for manipulation and direct sensing of droplet composition.

This paper demonstrates the integration of complementary split-ring resonators (CSSRs) with digital microfluidics (DMF) sample manipulation for passive, on-chip radio-frequency (RF) sensing. Integration is accomplished by having the DMF and the RF-sensing components share the same ground plane: by designing the RF-resonant openings directly into the ground plane of a DMF device, both droplet motion and sensing are achieved, adding a new on-board detection mode for use in DMF. The system was modelled to determine basic features and to balance various factors that need to be optimized to maintain both functionalities (DMF-enabled droplet movement and RF detection) on the same chip.

Digital microfluidic platform assembled into a home-made studio for sample preparation and colorimetric sensing of S-nitrosocysteine.

Digital microfluidics (DMF) is a versatile lab-on-a-chip platform that allows integration with several types of sensors and detection techniques, including colorimetric sensors. Here, we propose, for the first time, the integration of DMF chips into a mini studio containing a 3D-printed holder with previously fixed UV-LEDs to promote sample degradation on the chip surface before a complete analytical procedure involving reagent mixture, colorimetric reaction, and detection through a webcam integrated on the equipment. As a proof-of-concept, the feasibility of the integrated system was successfully through the indirect analysis of S-nitrosocysteine (CySNO) in biological samples.

A Novel Host of an Emerging Disease: SARS-CoV-2 Infection in a Giant Anteater (Myrmecophaga tridactyla) Kept Under Clinical Care in Brazil.

A young male free-ranging giant anteater (Myrmecophaga tridactyla) was found with paralysis of pelvic limbs on a highway and kept under human care. Radiographs confirmed multiple incomplete fractures in the thoracolumbar vertebrae. Due to the poor prognosis, euthanasia was chosen.

Use of a rapid digital microfluidics-powered immunoassay for assessing measles and rubella infection and immunity in outbreak settings in the Democratic Republic of the Congo.

The Democratic Republic of the Congo (DRC) has a high measles incidence despite elimination efforts and has yet to introduce rubella vaccine. We evaluated the performance of a prototype rapid digital microfluidics powered (DMF) enzyme-linked immunoassay (ELISA) assessing measles and rubella infection, by testing for immunoglobulin M (IgM), and immunity from natural infection or vaccine, by testing immunoglobulin G (IgG), in outbreak settings. Field evaluations were conducted during September 2017, in Kinshasa province, DRC.

Correction to: A microfluidic platform for continuous monitoring of dopamine homeostasis in dopaminergic cells.

[This corrects the article DOI: 10.1038/s41378-019-0049-2.].

A microfluidic platform for continuous monitoring of dopamine homeostasis in dopaminergic cells.

Homeostasis of dopamine, a classical neurotransmitter, is a key indicator of neuronal health. Dysfunction in the regulation of dopamine is implicated in a long list of neurological disorders, including addiction, depression, and neurodegeneration. The existing methods used to evaluate dopamine homeostasis in vitro are inconvenient and do not allow for continuous non-destructive measurement.

"Plug-n-Play" Sensing with Digital Microfluidics.

Digital microfluidics (DMF) is a platform that enables highly reconfigurable and automated fluidic operations using a generic device architecture. A unique hallmark of DMF is its "flexibility": a generic device design can be used and reused for many different, divergent fluidic operations. The flexibility of DMF is compromised when devices are permanently modified with embedded sensors.

Characterization of Off-Stoichiometry Microfluidic Devices for Bioanalytical Applications.

In this paper, we further investigate the properties of off-stoichiometry thiol-ene polymers (OSTE) aiming its application in microchip electrophoresis for bioanalytical applications. The proportion of 1.3:1 (allyl:thiol) and 1:2.

Degeneration of the osteocyte network in the C57BL/6 mouse model of aging.

Age-related bone loss and associated fracture risk are major problems in musculoskeletal health. Osteocytes have emerged as key regulators of bone mass and as a therapeutic target for preventing bone loss. As aging is associated with changes in the osteocyte lacunocanalicular system, we focused on the responsible cellular mechanisms in osteocytes.

Pre-concentration by liquid intake by paper (P-CLIP): a new technique for large volumes and digital microfluidics.

Microfluidic platforms are an attractive option for incorporating complex fluid handling into low-cost and rapid diagnostic tests. A persistent challenge for microfluidics, however, is the mismatch in the "world-to-chip" interface - it is challenging to detect analytes present at low concentrations in systems that can only handle small volumes of sample. Here we describe a new technique termed pre-concentration by liquid intake by paper (P-CLIP) that addresses this mismatch, allowing digital microfluidics to interface with volumes on the order of hundreds of microliters.

Carnosine modulates nitric oxide in stimulated murine RAW 264.7 macrophages.

Excess nitric oxide (NO) production occurs in several pathological states, including neurodegeneration, ischemia, and inflammation, and is generally accompanied by increased oxidative/nitrosative stress. Carnosine [β-alanine-histidine (β-Ala-His)] has been reported to decrease oxidative/nitrosative stress-associated cell damage by reducing the amount of NO produced. In this study, we evaluated the effect of carnosine on NO production by murine RAW 264.

Indirect detection of superoxide in RAW 264.7 macrophage cells using microchip electrophoresis coupled to laser-induced fluorescence.

Superoxide, a naturally produced reactive oxygen species (ROS) in the human body, is involved in many pathological and physiological signaling processes. However, if superoxide formation is left unregulated, overproduction can lead to oxidative damage to important biomolecules, such as DNA, lipids, and proteins. Superoxide can also lead to the formation of peroxynitrite, an extremely hazardous substance, through its reaction with endogenously produced nitric oxide.

Surface modification of PDMS microchips with poly(ethylene glycol) derivatives for μTAS applications.

In this work is presented a method for the modification of native PDMS surface in order to improve its applicability as a substrate for microfluidic devices, especially in the analysis of nonpolar analytes. Therefore, poly(ethylene glycol) divinyl ether modified PDMS substrate was obtained by surface modification of native PDMS. The modified substrate was characterized by attenuated total reflectance infrared spectroscopy, water contact angle measurements, and by evaluating the adsorption of rhodamine B and the magnitude of the EOF mobility.

Raman imaging spectroscopic characterization of modified poly(dimethylsiloxane) for micro total analysis systems applications.

Methacryloxypropyl-modified poly(dimethylsiloxane) rubbers were obtained from poly(dimethylsiloxane), PDMS, and methacryloxypropyltrimethoxysilane, MPTMS, by polycondensation reactions. The modified rubbers, prepared with 20 and 30% (v/v) of MPTMS, were used as substrates for microchannel fabrication by the CO(2) laser ablation technique. Raman imaging spectroscopy was used for the surface characterization, showing the homogeneity of the rubbery material, with uniform distribution of the crosslinking centers.

Preparation, characterization and in vitro evaluation of 50% enantiomeric excess bupivacaine (S75-R25)-loaded microspheres.

Background And Objectives: Microspheres can be used as a controlled delivery system to prolong the duration of action of local anesthetics. The objective of this study was the preparation, characterization and analysis of the in vitro release of 50% enantiomeric excess bupivacaine (S75-R25)-loaded microspheres.

Methods: Microspheres were prepared using the copolymer of polylactide-co-glycolic acid by the spray-dryed method.

[Analysis of healing in the Alba Linea with the use of Orbignya phalerata (babassu) water extract. Controlled study in rats].

Introduction: The babassu mesocarp (Orbignya phalerata) has been used in experimental research studies focused on its antiinflammatory action. In state of Maranhão--Brazil it is widely used not only as food, but also as popular medicine in wound healing process.

Purpose: To evaluate the action of Orbignya phalerata extract in macroscopic, histologic and tensiometric aspects in the healing process of median laparotomy in rats.