Mineral and Trace Elements in Nutritious Flours: Total Contents, In Vitro Bioaccessibility and Contribution to Dietary Intake.

The consumption of fruits, vegetables, and cereals in the form of flour has been an alternative for the intake of nutrients, currently seen in a society that seeks a healthier diet. Thus, the assessment of total contents and bioaccessibility is important to better understand the actual intake of nutrients or contaminants present in foods. The objective of this study was to determine the total content and estimate the bioaccessible fraction of Cu, Fe, and Zn in nutritious flours by inductively coupled plasma optical emission spectrometry (ICP OES) after microwave acid digestion.

Selenium inorganic speciation in beers using MSFIA-HG-AFS system after multivariate optimization.

In this work, the use of a multisyringe flow injection analysis coupled to hydride generation atomic fluorescence spectrometry (MSFIA-HG-AFS) for inorganic selenium chemical speciation was proposed. A Doehlert design was applied to optimize the experimental conditions for hydride generation (NaBH and HCl concentrations). The limits of quantification (LoQ) obtained were 0.

Evaluation of the Mineral Content in Forage Palm (Opuntia ficus-indica Mill and Nopalea cochenillifera) Using Chemometric Tools.

An acid digestion procedure of the forage palm (Opuntia ficus-indica Mill and Nopalea cochenilifera) employing a closed digestor block applied full 2 factorial design was optimized. The optimal conditions were HNO 5.0 mol L, 2.

Rare earth elements in drill cutting samples from off-shore oil and gas exploration activities in ultradeep waters.

Rare earth elements (REEs) are essential in high technology industries and have great economic value. The monitoring of REEs concentrations in rocks from oil well drill cuttings is critical to avoid environmental contamination and evaluate new sources of these elements. However, information is scarce about the REEs concentrations in drill cuttings.

Speciation analysis of inorganic As and Sb in urban dust using slurry sampling and detection by fast sequential hydride generation atomic absorption spectrometry.

In this work, a methodology for chemical speciation analysis of inorganic As and Sb in urban dust using slurry sampling and detection by fast sequential hydride generation atomic absorption spectrometry is proposed. Doehlert design and desirability function were used to find the optimum conditions for hydride generation (1.0 mol L HCl and 0.

Sequential determination and chemical speciation analysis of inorganic As and Sb in airborne particulate matter collected in outdoor and indoor environments using slurry sampling and detection by HG AAS.

In this work, fast sequential determination and chemical speciation analysis of inorganic arsenic and antimony in airborne particulate matter collected in outdoor and indoor environments using slurry sampling and detection by hydride generation atomic absorption spectrometry (HG-AAS) is proposed. A Doehlert design was applied to optimise the hydride generation conditions of As and Sb for fast sequential determination in the same aliquot of particulate matter samples after preparation of the slurry. The limits of quantification (LoQ) obtained for As and Sb were 0.

Assessment of cadmium and lead in commercial coconut water and industrialized coconut milk employing HR-CS GF AAS.

In this work, an analytical method for the determination of Cd and Pb in natural coconut water samples, industrialized coconut water samples and coconut milk using high-resolution continuum source graphite furnace atomic absorption spectrometry (HR-CS GF AAS), after minimum treatment of the sample was developed. The analytical method was applied to 46 samples collected in Salvador, Bahia (Brazil). The ranges of concentrations obtained were: 0.

Determination of nutrients in sugarcane juice using slurry sampling and detection by ICP OES.

The fractional factorial and Doehlert designs for optimization of a slurry sampling procedure to determine of nutrients in sugarcane juice by inductively coupled plasma optical emission spectrometry (ICP OES) were applied. External calibration curves were used for direct analysis of the slurry. This procedure allowed determination of Ca, Cu, Fe, K and Mg with limits of detection (LoD) obtained of 2.

Optimization of sample preparation procedures for evaluation of the mineral composition of fish feeds using ICP-based methods.

This work describes the application of an experimental design in optimizing the decomposition and spectrometer operational conditions for analysis of fish feeds. The content of 22 elements (six macroelements, four microelements and eleven trace elements) in feeds for fishes (ornamental and for human consumption) was determined by inductively coupled plasma (ICP)-based methods. Limits of quantification were obtained and the values ranged between 0.

Comparison of Spectrophotometric Methods for the Determination of Copper in Sugar Cane Spirit.

Three spectrophotometric methods were developed for the determination of copper (Cu) in sugar cane spirit using the chromogenic reagents neocuproine, cuprizone, and bathocuproine. Experimental conditions, such as reagent concentration, reducer concentration, pH, buffer concentration, the order of addition of reagents, and the stability of the complexes, were optimized. The work range was established from 1.

Determination of Zn in Dry Feeds for Cats and Dogs by Energy-Dispersive X-Ray Fluorescence Spectrometry.

This work describes an analytical method for Zn determination in dry feeds for cats and dogs by energy-dispersive X-ray fluorescence (EDXRF). Samples of dry feed were powdered and prepared in the form of pellets for direct analysis by EDXRF. The LOQ (10σ) was 0.