Green sample preparation of medicinal herbs in closed digester block for elemental determination by ICP OES.

This work presents a simple, cost-effective, and environmentally friendly digestion method employing inductively coupled plasma optical emission spectrometry (ICP OES) for the determination of As, Ca, Cd, Cr, Cu, Fe, K, Mg, Mn, Na, P, Pb, Sr, and Zn in medicinal herbs. A fractional factorial design uses a multivariate strategy to optimize the experimental parameters. At 180 ºC and 120 min of sample digestion, the optimal condition for a closed block digester was achieved with a mixture consisting of 1.

Mineral and Trace Elements in Nutritious Flours: Total Contents, In Vitro Bioaccessibility and Contribution to Dietary Intake.

The consumption of fruits, vegetables, and cereals in the form of flour has been an alternative for the intake of nutrients, currently seen in a society that seeks a healthier diet. Thus, the assessment of total contents and bioaccessibility is important to better understand the actual intake of nutrients or contaminants present in foods. The objective of this study was to determine the total content and estimate the bioaccessible fraction of Cu, Fe, and Zn in nutritious flours by inductively coupled plasma optical emission spectrometry (ICP OES) after microwave acid digestion.

Geochemistry of trace metals in surface sediments from the continental slope of the states of Sergipe and Alagoas, Northeastern Brazil.

Geochemical analyses were used to determine the origin and identify the main factors that lead to the metal trace distribution on the surface sediments from the continental slope of Sergipe in Brazil. Sediment samples were collected during the dry and rainy periods, from 36 sampling points distributed at water depths from 400 to 3000 m. In general, no effect of seasonality was observed on the metal concentrations and no significant differences were observed between the depth ranges.

Multielement determination (essential and potentially toxic elements) in eye shadows exposed to consumption in Brazil using ICP OES.

Worldwide, cosmetics (especially eye shadows) are widely consumed and have a great impact on the economy. The aim of this study was to determine the multielement composition, focusing on essential and potentially toxic elements, in cosmetics (eye shadow) exposed to consumption in Brazil. Concentrations of 17 elements (Al, As, Ba, Cd, Co, Cr, Cu, Mn, Mo, Ni, Pb, Sb, Se, Sr, Ti, V and Zn) were determined in samples (produced in China and Brazil) using a sequential optical emission spectrometer with inductively coupled plasma (ICP OES) after acid digestion, assisted by a closed digester block (6 mL of HNO + 2 mL of HO + 1 mL of Triton ×-100 + 1 mL of ultrapure water).

Selenium inorganic speciation in beers using MSFIA-HG-AFS system after multivariate optimization.

In this work, the use of a multisyringe flow injection analysis coupled to hydride generation atomic fluorescence spectrometry (MSFIA-HG-AFS) for inorganic selenium chemical speciation was proposed. A Doehlert design was applied to optimize the experimental conditions for hydride generation (NaBH and HCl concentrations). The limits of quantification (LoQ) obtained were 0.

A Review on Atmospheric Analysis Focusing on Public Health, Environmental Legislation and Chemical Characterization.

Atmospheric pollution has been considered one of the most important topics in environmental science once it can be related to the incidence of respiratory diseases, climate change, and others. Knowing the composition of this complex and variable mixture of gases and particulate matter is crucial to understand the damages it causes, help establish limit levels, reduce emissions, and mitigate risks. In this work, the current scenario of the legislation and guideline values for indoor and outdoor atmospheric parameters will be reviewed, focusing on the inorganic and organic compositions of particulate matter and on biomonitoring.

Evaluation of the Mineral Content in Forage Palm (Opuntia ficus-indica Mill and Nopalea cochenillifera) Using Chemometric Tools.

An acid digestion procedure of the forage palm (Opuntia ficus-indica Mill and Nopalea cochenilifera) employing a closed digestor block applied full 2 factorial design was optimized. The optimal conditions were HNO 5.0 mol L, 2.

Determination of total and bioavailable As and Sb in children's paints using the MSFIA system coupled to HG-AFS.

In this study, the use of hydride generation atomic fluorescence spectrometry (HG-AFS) coupled with the multi-syringe flow injection analysis (MSFIA) has been proposed in the application of the Doehlert design to optimise the determination of As and Sb in gouache and tempera children's paints. The determination of the total and bioavailable As and Sb in paint samples from various brands and colours was also investigated. The limits of quantification (LOQ) obtained for the determination of As and Sb were 14.

Rare earth elements in drill cutting samples from off-shore oil and gas exploration activities in ultradeep waters.

Rare earth elements (REEs) are essential in high technology industries and have great economic value. The monitoring of REEs concentrations in rocks from oil well drill cuttings is critical to avoid environmental contamination and evaluate new sources of these elements. However, information is scarce about the REEs concentrations in drill cuttings.

A Comparative Study of the Catalytic Performance of Pt-Based Bi and Trimetallic Nanocatalysts Towards Methanol, Ethanol, Ethylene Glycol, and Glycerol Electro-Oxidation.

Carbon-supported platinum is used as an anode and cathode electrocatalyst in low-temperature fuel cells fueled with low-molecular-weight alcohols in fuel cells. The cost of Pt and its low activity towards the complete oxidation of these fuels are significant barriers to the widespread use of these types of fuel cells. Here, we report on the development of PtRhNi nanocatalysts supported on carbon made using a reduction chemistry method with different atomic rates.

Speciation analysis of inorganic As and Sb in urban dust using slurry sampling and detection by fast sequential hydride generation atomic absorption spectrometry.

In this work, a methodology for chemical speciation analysis of inorganic As and Sb in urban dust using slurry sampling and detection by fast sequential hydride generation atomic absorption spectrometry is proposed. Doehlert design and desirability function were used to find the optimum conditions for hydride generation (1.0 mol L HCl and 0.

Sequential determination and chemical speciation analysis of inorganic As and Sb in airborne particulate matter collected in outdoor and indoor environments using slurry sampling and detection by HG AAS.

In this work, fast sequential determination and chemical speciation analysis of inorganic arsenic and antimony in airborne particulate matter collected in outdoor and indoor environments using slurry sampling and detection by hydride generation atomic absorption spectrometry (HG-AAS) is proposed. A Doehlert design was applied to optimise the hydride generation conditions of As and Sb for fast sequential determination in the same aliquot of particulate matter samples after preparation of the slurry. The limits of quantification (LoQ) obtained for As and Sb were 0.

Assessment of cadmium and lead in commercial coconut water and industrialized coconut milk employing HR-CS GF AAS.

In this work, an analytical method for the determination of Cd and Pb in natural coconut water samples, industrialized coconut water samples and coconut milk using high-resolution continuum source graphite furnace atomic absorption spectrometry (HR-CS GF AAS), after minimum treatment of the sample was developed. The analytical method was applied to 46 samples collected in Salvador, Bahia (Brazil). The ranges of concentrations obtained were: 0.

Multivariate data analysis of trace elements in bivalve molluscs: Characterization and food safety evaluation.

Four species of bivalve molluscs (Anomalocardia brasiliana, Iphigenia brasiliana, Lucina pectinata and Trachycardium muricatum) were collected in the Todos os Santos Bay (TSB), Bahia, Brazil, in order to evaluate As, Cd, Co, Cu, Cr, Fe, Mn, Ni, Pb, Se, V and Zn levels and, consequently, the risk of bivalve mollusc consumption in humans. The samples were analyzed by inductively coupled plasma optical emission spectrometry (ICP OES) and inductively coupled plasma mass spectrometry (ICP-MS) after closed-vessel microwave digestion. The accuracy was confirmed using the certified reference materials of oyster tissue (NIST 1566b) and mussel tissue (NIST 2977), and the results were statistically equivalent to the certified values.

Determination of nutrients in sugarcane juice using slurry sampling and detection by ICP OES.

The fractional factorial and Doehlert designs for optimization of a slurry sampling procedure to determine of nutrients in sugarcane juice by inductively coupled plasma optical emission spectrometry (ICP OES) were applied. External calibration curves were used for direct analysis of the slurry. This procedure allowed determination of Ca, Cu, Fe, K and Mg with limits of detection (LoD) obtained of 2.

Optimization of sample preparation procedures for evaluation of the mineral composition of fish feeds using ICP-based methods.

This work describes the application of an experimental design in optimizing the decomposition and spectrometer operational conditions for analysis of fish feeds. The content of 22 elements (six macroelements, four microelements and eleven trace elements) in feeds for fishes (ornamental and for human consumption) was determined by inductively coupled plasma (ICP)-based methods. Limits of quantification were obtained and the values ranged between 0.

Analysis of children modelling clay (toy) using inductively coupled plasma-based methods.

This work proposes the application of a Doehlert design to optimize dilute HNO and HO concentrations employed for the digestion of samples of modelling clay for children (used as toy). Inductively coupled plasma-based (ICP) methods were employed to determine 22 inorganic constituents (Al, As, Ba, Ca, Cd, Co, Cr, Cu, Fe, K, Mg, Mn, Na, Ni, P, Pb, S, Sb, Se, Sr, V and Zn) in children's modelling clay samples. The limits of quantification (LoQ) obtained were between 0.

Multivariate optimization of a procedure employing microwave-assisted digestion for the determination of nickel and vanadium in crude oil by ICP OES.

This work presents the optimization of a sample preparation procedure using microwave-assisted digestion for the determination of nickel and vanadium in crude oil employing inductively coupled plasma optical emission spectrometry (ICP OES). The optimization step was performed utilizing a two-level full factorial design involving the following factors: concentrated nitric acid and hydrogen peroxide volumes, and microwave-assisted digestion temperature. Nickel and vanadium concentrations were used as responses.

Chlorine determination via MgCl molecule in environmental samples using high resolution continuum source graphite furnace molecular absorption spectrometry.

This paper describes a method development for chlorine determination through the formation of MgCl molecule, applied for the first time for Cl quantification, by high resolution continuum source graphite furnace molecular absorption spectrometry (HR-CS GF MAS) in environmental samples. Pyrolysis and vaporization temperatures were optimized as well as the use of chemical modifier. Determinations were carried out at the wavelength of 377.

Comparison of Spectrophotometric Methods for the Determination of Copper in Sugar Cane Spirit.

Three spectrophotometric methods were developed for the determination of copper (Cu) in sugar cane spirit using the chromogenic reagents neocuproine, cuprizone, and bathocuproine. Experimental conditions, such as reagent concentration, reducer concentration, pH, buffer concentration, the order of addition of reagents, and the stability of the complexes, were optimized. The work range was established from 1.

Multivariate Optimization of Conditions for Digestion of Wet Feeds for Dogs and Cats Using a Closed Digester Block and Multielement Determination by ICP-OES.

A full 24 factorial design was applied to find the best combination of diluted reagents (HNO3 and H2O2), time, and temperature for the digestion of samples of wet feed for dogs and cats using a closed digestion block. The residual carbon concentration (RCC) was used as the response in the factorial design. All variables and their interactions significantly influenced the digestion of the feed samples, as indicated by the RCC.

Characterisation and source identification of the total airborne particulate matter collected in an urban area of Aracaju, Northeast, Brazil.

In this work, studies using samples collected in an urban area of Aracaju city, Sergipe State, Northeast, Brazil revealed that soil dust in suspension was the main source of total airborne particulate matter (TAPM), followed by vehicular pollution. The concentration profiles for Cu, Fe, Mn, Ni, V and Ti were established for the collected TAPM samples. The concentrations of SO and smoke were also measured all along the 42 sampling days.

Determination of Zn in Dry Feeds for Cats and Dogs by Energy-Dispersive X-Ray Fluorescence Spectrometry.

This work describes an analytical method for Zn determination in dry feeds for cats and dogs by energy-dispersive X-ray fluorescence (EDXRF). Samples of dry feed were powdered and prepared in the form of pellets for direct analysis by EDXRF. The LOQ (10σ) was 0.

Assessment of the Halogen Content of Brazilian Inhalable Particulate Matter (PM10) Using High Resolution Molecular Absorption Spectrometry and Electrothermal Vaporization Inductively Coupled Plasma Mass Spectrometry, with Direct Solid Sample Analysis.

Halogens in the atmosphere play an important role in climate change and also represent a potential health hazard. However, quantification of halogens is not a trivial task, and methods that require minimum sample preparation are interesting alternatives. Hence, the aim of this work was to evaluate the feasibility of direct solid sample analysis using high-resolution continuum source molecular absorption spectrometry (HR-CS MAS) for F determination and electrothermal vaporization-inductively coupled plasma mass spectrometry (ETV-ICP-MS) for simultaneous Cl, Br, and I determination in airborne inhalable particulate matter (PM10) collected in the metropolitan area of Aracaju, Sergipe, Brazil.

Multivariate optimization of an analytical method for the analysis of dog and cat foods by ICP OES.

Experimental design methodology was used to optimize an analytical method for determination of the mineral element composition (Al, Ca, Cd, Cr, Cu, Ba, Fe, K, Mg, Mn, P, S, Sr and Zn) of dog and cat foods. Two-level full factorial design was applied to define the optimal proportions of the reagents used for microwave-assisted sample digestion (2.0 mol L(-1) HNO3 and 6% m/v H2O2).