Extra-Articular Distal Humerus Plate 3D Model Creation by Using the Method of Anatomical Features.

Proper fixation techniques are crucial in orthopedic surgery for the treatment of various medical conditions. Fractures of the distal humerus can occur due to either high-energy trauma with skin rupture or low-energy trauma in osteoporotic bone. The recommended surgical approach for treating these extra-articular distal humerus fractures involves performing an open reduction and internal fixation procedure using plate implants.

An Experimental Study on the Impact of Layer Height and Annealing Parameters on the Tensile Strength and Dimensional Accuracy of FDM 3D Printed Parts.

This study investigates the impact of annealing time, temperature, and layer height on the tensile strength and dimensional change of three 3D printing materials (PLA, PETG, and carbon fiber-reinforced PETG). Samples with varying layer heights (0.1 mm, 0.

Mechanical and Wetting Properties of TaO and ZnO Coatings on Alloy Substrate of Cardiovascular Stents Manufactured by Casting and DMLS.

In the last years, additive manufacturing technologies have been developed, especially direct metal laser sintering, and used in the dental and medical implant domains. Cardiovascular stents have evolved from bioinert, bare metal cages to biomimetic devices that promote tissue regeneration or healing. In this paper, comparisons concerning mechanical properties between Co-Cr alloy and cast 304L stainless steel were realized using FEM analysis, necessary for manufacturing cardiovascular stents by DMLS technology using Co-Cr alloy.

Correction: Răzvan et al. Selective Laser Sintering of PA 2200 for Hip Implant Applications: Finite Element Analysis, Process Optimization, Morphological and Mechanical Characterization. , , 4240.

The authors wish to make the following correction to their paper [...

Cast Iron Parts Obtained in Ceramic Molds Produced by Binder Jetting 3D Printing-Morphological and Mechanical Characterization.

Mechanical behavior and characteristics of two different types of materials: cast iron with lamellar graphite EN-GJL-250 and cast iron with spheroidal graphite EN-GJS-400-15 which were cast in ceramic molds using gravitational casting method has considered in this research. The ceramic molds were obtained by 3D printing method. First, a finite element analysis was developed to determine Tresca and von Mises stresses and the deformations of the ceramic molds under an applied pressure of 25 MPa.

Selective Laser Sintering of PA 2200 for Hip Implant Applications: Finite Element Analysis, Process Optimization, Morphological and Mechanical Characterization.

Polyamide 12 (PA 22000) is a well-known material and one of the most biocompatible materials tested and used to manufacture customized medical implants by selective laser sintering technology. To optimize the implants, several research activities were considered, starting with the design and manufacture of test samples made of PA 2200 by selective laser sintering (SLS) technology, with different processing parameters and part orientations. The obtained samples were subjected to compression tests and later to SEM analyses of the fractured zones, in which we determined the microstructural properties of the analyzed samples.

Thin Films Deposition of TaO and ZnO by E-Gun Technology on Co-Cr Alloy Manufactured by Direct Metal Laser Sintering.

In recent years in the dental field, new types of materials and techniques for the manufacturing of dental crowns and analog implants have been developed to improve the quality of these products. The objective of this article was to perform the surface characterization and determine the properties of Co-Cr alloy samples fabricated by the direct metal laser sintering (DMLS) process and coated by e-gun technology with thin films of TaO and ZnO. Both oxides are frequently used for dental products, in pharmacology, cosmetics, and medicine, due to their good anticorrosive, antibacterial, and photo-catalytic properties.