Electrochemical-Based Biosensors on Different Zinc Oxide Nanostructures: A Review.

Electrochemical biosensors have shown great potential in the medical diagnosis field. The performance of electrochemical biosensors depends on the sensing materials used. ZnO nanostructures play important roles as the active sites where biological events occur, subsequently defining the sensitivity and stability of the device.

Effect of solution pH and adsorbent concentration on the sensing parameters of TGN-based electrochemical sensor.

The response of trilayer graphene nanoribbon (TGN)-based ion-sensitive field-effect transistor (ISFET) to different pH solutions and adsorption effect on the sensing parameters are analytically studied in this research. The authors propose a TGN-based sensor to electrochemically detect pH. To this end, absorption effect on the sensing area in the form of carrier concentration, carrier velocity, and conductance variations are investigated.

Experimental and theoretical investigation of sensing parameters in carbon nanotube-based DNA sensor.

Nowadays, sensitive biosensors with high selectivity, lower costs and short response time are required for detection of DNA. The most preferred materials in DNA sensor designing are nanomaterials such as carbon and Au nanoparticles, because of their very high surface area and biocompatibility which lead to performance and sensitivity improvements in DNA sensors. Carbon nanomaterials such as carbon nanotubes (CNTs) can be considered as a suitable DNA sensor platform due to their high surface-to-volume ratio, favourable electronic properties and fast electron transfer rate.

A carrier velocity model for electrical detection of gas molecules.

Nanomaterial-based sensors with high sensitivity, fast response and recovery time, large detection range, and high chemical stability are in immense demand for the detection of hazardous gas molecules. Graphene nanoribbons (GNRs) which have exceptional electrical, physical, and chemical properties can fulfil all of these requirements. The detection of gas molecules using gas sensors, particularly in medical diagnostics and safety applications, is receiving particularly high demand.

Toxic metals in Perna viridis mussel and surface seawater in Pasir Gudang coastal area, Malaysia, and its health implications.

Contamination of toxic metals in P. viridis mussels has been prevalently reported; hence, health risk assessment for consuming this aquaculture product as well as the surrounding surface seawater at its harvesting sites appears relevant. Since Kampung Pasir Puteh, Pasir Gudang is the major harvesting site in Malaysia, and because the last heavy metal assessment was done in 2009, its current status remains unclear.

Graphene Based Biosensor Model for Escherichia Coli Bacteria Detection.

As a new nanomaterial, graphene demonstrates great potential as an electrode for biomedical applications in sensing molecules and cells. Thus, development of biosensors based on graphene is gaining much interest due to its exceptional properties such as, large surface-to-volume ratio, high conductivity and high flexibility. In this work a liquid gated graphene field effect transistor based biosensor model is analytically developed for electrical detection of Escherichia Coli O157:H7 bacteria.

Graphene nanoribbon field-effect transistor at high bias.

Combination of high-mean free path and scaling ability makes graphene nanoribbon (GNR) attractive for application of field-effect transistors and subject of intense research. Here, we study its behaviour at high bias near and after electrical breakdown. Theoretical modelling, Monte Carlo simulation, and experimental approaches are used to calculate net generation rate, ionization coefficient, current, and finally breakdown voltage (BV).

Analytical performance of 3 m and 3 m +1 armchair graphene nanoribbons under uniaxial strain.

The electronic band structure and carrier density of strained armchair graphene nanoribbons (AGNRs) with widths of n =3 m and n =3 m +1 were examined using tight-binding approximation. The current-voltage (I-V) model of uniaxial strained n =3 m AGNRs incorporating quantum confinement effects is also presented in this paper. The derivation originates from energy dispersion throughout the entire Brillouin zone of uniaxial strained AGNRs based on a tight-binding approximation.

Analytical development and optimization of a graphene-solution interface capacitance model.

Graphene, which as a new carbon material shows great potential for a range of applications because of its exceptional electronic and mechanical properties, becomes a matter of attention in these years. The use of graphene in nanoscale devices plays an important role in achieving more accurate and faster devices. Although there are lots of experimental studies in this area, there is a lack of analytical models.

Use of pilot plant scale continuous fryer to simulate industrial production of potato chips: thermal properties of palm olein blends under continuous frying conditions.

Binary blends of palm olein (PO) with sunflower oil (SFO), canola oil (CNO), and cottonseed oil (CSO) were formulated to assess their stability under continuous frying conditions. The results were then compared with those obtained in PO. The oil blends studied were: (1) 60:40 for PO + SFO; (2) 70:30 for PO + CNO; and (3) 50:50 for PO + CSO.

Analytical modeling of glucose biosensors based on carbon nanotubes.

In recent years, carbon nanotubes have received widespread attention as promising carbon-based nanoelectronic devices. Due to their exceptional physical, chemical, and electrical properties, namely a high surface-to-volume ratio, their enhanced electron transfer properties, and their high thermal conductivity, carbon nanotubes can be used effectively as electrochemical sensors. The integration of carbon nanotubes with a functional group provides a good and solid support for the immobilization of enzymes.

The effect of uniaxial strain on graphene nanoribbon carrier statistic.

: Armchair graphene nanoribbon (AGNR) for n=3m and n=3m+1 family carrier statistic under uniaxial strain is studied by means of an analytical model based on tight binding approximation. The uniaxial strain of AGNR carrier statistic models includes the density of state, carrier concentration, and carrier velocity. From the simulation, it is found that AGNR carrier concentration has not been influenced by the uniaxial strain at low normalized Fermi energy for n=3m and n=3m+1.

Analytical modeling of trilayer graphene nanoribbon Schottky-barrier FET for high-speed switching applications.

Recent development of trilayer graphene nanoribbon Schottky-barrier field-effect transistors (FETs) will be governed by transistor electrostatics and quantum effects that impose scaling limits like those of Si metal-oxide-semiconductor field-effect transistors. The current-voltage characteristic of a Schottky-barrier FET has been studied as a function of physical parameters such as effective mass, graphene nanoribbon length, gate insulator thickness, and electrical parameters such as Schottky barrier height and applied bias voltage. In this paper, the scaling behaviors of a Schottky-barrier FET using trilayer graphene nanoribbon are studied and analytically modeled.

Antioxidative properties of Murraya koenigii leaf extracts in accelerated oxidation and deep-frying studies.

Murraya koenigii leaf extract antioxidant potentials were evaluated in palm olein using accelerated oxidation storage and deep-frying studies at 180 degrees C for up to 40 h. The extracts (0.2%) retarded oil oxidation and deterioration significantly (P<0.

Antioxidative properties of Pandanus amaryllifolius leaf extracts in accelerated oxidation and deep frying studies.

The potential uses of Pandanus amaryllifolius leaf extract as a natural antioxidant were evaluated in refined, bleached and deodorized (RBD) palm olein, using accelerated oxidation and deep frying studies at 180°C from 0 to 40h. The extracts (optimum concentration 0.2%) significantly retarded oil oxidation and deterioration (P<0.

Palm oil and palm olein frying applications.

Several million tones of palm oil and palm olein are used annually in the world for frying. This paper will discuss their frying performances in three major applications - industrial production of potato chips/crisps, industrial production of pre-fried frozen French fries and in fast food outlets. In the first study, about four tones of potato chips were continuously fried 8 hours a day and five days a week.