Crossing the threshold of ultrafast laser writing in bulk silicon.

An important challenge in the field of three-dimensional ultrafast laser processing is to achieve permanent modifications in the bulk of silicon and narrow-gap materials. Recent attempts by increasing the energy of infrared ultrashort pulses have simply failed. Here, we establish that it is because focusing with a maximum numerical aperture of about 1.

Millijoule femtosecond micro-Bessel beams for ultra-high aspect ratio machining.

We report on a functional experimental design for Bessel beam generation capable of handling high-energy ultrashort pulses (up to 1.2 mJ per pulse of 50 fs duration). This allows us to deliver intensities exceeding the breakdown threshold for air or any dielectric along controlled micro-filaments with lengths exceeding 4 mm.

Ultrafast electron and phonon response of oriented and diameter-controlled germanium nanowire arrays.

Carrier and phonon dynamics in dense arrays of aligned, single-crystal Ge nanowires (NWs) of controlled diameter are investigated by ultrafast optical pump-probe measurements, effective medium calculations, and elasticity analysis. Both a pronounced induced absorption and the amplitude and spectral range of Fabry-Perot oscillations observed in the probe signal are predicted for the NW array/air metamaterial by effective medium calculations. Detected temporal oscillations of reflectivity are consistent with excitation of radial breathing mode acoustic phonons by the intense pump pulse.

The exciton dynamics in tetracene thin films.

Tetracene thin films are investigated by time-resolved photoluminescence on picosecond to nanosecond time-scales. The picosecond luminescence decay dynamics is confirmed to be independent of temperature, but the nanosecond timescale luminescence dynamics is highly temperature dependent. This is interpretted in terms of motion along an intermolecular coordinate which couples the S1 state to the multiexciton (ME) state, arising from frustrated photodimerization, and giving rise to exciton dimming through adiabatic coupling.

Synthesis and luminescence properties of iridium(III) azide- and triazole-bisterpyridine complexes.

We describe here the synthesis of azide-functionalised iridium(III) bisterpyridines using the "chemistry on the complex" strategy. The resulting azide-complexes are then used in the copper(I)-catalysed azide-alkyne Huisgen 1,3-dipolar cycloaddition "click chemistry" reaction to from the corresponding triazole-functionalised iridium(III) bisterpyridines. The photophysical characteristics, including lifetimes, of these compounds were also investigated.

Synthesis and ultrafast excited-state dynamics of zinc and palladium triply fused diporphyrins.

We report the synthesis and ultrafast excited-state dynamics of two new meso-meso, β-β, β-β triply fused diporphyrins, Zn-3DP and Pd-3DP. Both compounds were found to have short excited-state lifetimes: Zn-3DP possessed an average S1 lifetime of 14 ps before nonradiative deactivation to the ground state, whereas Pd-3DP displayed a longer average S1 lifetime of 18 ps before crossing to the T1 state, which itself possessed a very short triplet lifetime of 1.7 ns.

Entropically driven photochemical upconversion.

Conventional photochemical upconversion (UC) through homo-geneous triplet-triplet annihilation (TTA) is subject to several enthalpic losses that limit the UC margin. Here, we address one of these losses: the triplet energy transfer (TET) from the sensitizer to the emitter molecules. Usually, the triplet energy level of the emitter is set below that of the sensitizer.

Towards an aligned luminophore solar concentrator.

Luminescent solar concentrators promise to reduce the cost of solar energy, but are hindered by a number of losses. Escape of luminescence through the large waveguide-air interfaces can be attenuated through alignment of the optical transition dipole of the luminophore along the waveguide surface normal, directing the maximum possible proportion of luminescence into waveguide modes. We demonstrate such alignment using a guest-host dye-doped liquid crystal sandwiched between conductive glass slides.

On the efficiency limit of triplet-triplet annihilation for photochemical upconversion.

Photochemical upconversion is performed, whereby emitter triplet states are produced through triplet energy transfer from sensitizer molecules excited with low energy photons. The triplet emitter molecules undergo triplet-triplet annihilation to yield excited singlet states which emit upconverted fluorescence. Experiments comparing the 560 nm prompt fluorescence when rubrene emitter molecules are excited directly, using 525 nm laser pulses, to the delayed, upconverted fluorescence when the porphyrin sensitizer molecules are excited with 670 nm laser pulses reveal annihilation efficiencies to produce excited singlet emitters in excess of 20%.

Identification of the jet-cooled 1-indanyl radical by electronic spectroscopy.

The electronic spectrum of the jet-cooled 1-indanyl radical has been identified in the products of a hydrocarbon discharge in argon. Electronic excitation spectra were observed in the region 20800-22600 cm(-1) by resonant two-color two-photon ionization and laser-induced fluorescence spectroscopies. In addition to the new spectrum at m/z = 117, the spectrum of 1-phenylpropargyl was also observed strongly, as was an unidentified spectrum carried by m/z = 133.

High-efficiency, broad band, high-damage threshold high-index gratings for femtosecond pulse compression.

High efficiency, broad-band TE-polarization diffraction over a wavelength range centered at 800 nm is obtained by high index gratings placed on a non-corrugated mirror. More than 96% efficiency wide band top-hat diffraction efficiency spectra, as well as more than 1 J/cm(2) damage threshold under 50 fs pulses are demonstrated experimentally. This opens the way to high-efficiency Chirped Pulse Amplification for high average power laser machining by means of all-dielectric structures as well as for ultra-short high energy pulses by means of metal-dielectric structures.