Investigating the activity of CaFeO additives on the thermochemical energy storage performance of limestone waste.

Efficient and reliable energy storage systems are necessary to address the intermittency and variability of renewable energy sources. Thermochemical energy storage (TCES) has emerged as a promising solution for long-term renewable energy storage, with limestone being a widely studied material due to its abundance and high energy density. However, the practical implementation of limestone-based TCES systems faces challenges related to performance degradation upon multiple energy storage/release cycles, impacting their long-term viability and efficiency.

Femtosecond Laser Assisted Crystallization of Gold Thin Films.

We propose a novel low temperature annealing method for selective crystallization of gold thin films. Our method is based on a non-melt process using highly overlapped ultrashort laser pulses at a fluence below the damage threshold. Three different wavelengths of a femtosecond laser with the fundamental (1030 nm), second (515 nm) and third (343 nm) harmonic are used to crystallize 18-nm and 39-nm thick room temperature deposited gold thin films on a quartz substrate.

Crystallographic Characterisation of Ultra-Thin, or Amorphous Transparent Conducting Oxides-The Case for Raman Spectroscopy.

The electronic and optical properties of transparent conducting oxides (TCOs) are closely linked to their crystallographic structure on a macroscopic (grain sizes) and microscopic (bond structure) level. With the increasing drive towards using reduced film thicknesses in devices and growing interest in amorphous TCOs such as n-type InGaZnO 4 (IGZO), ZnSnO 3 (ZTO), p-type Cu x CrO 2 , or ZnRh 2 O 4 , the task of gaining in-depth knowledge on their crystal structure by conventional X-ray diffraction-based measurements are becoming increasingly difficult. We demonstrate the use of a focal shift based background subtraction technique for Raman spectroscopy specifically developed for the case of transparent thin films on amorphous substrates.

Importance of Local Bond Order to Conduction in Amorphous, Transparent, Conducting Oxides: The Case of Amorphous ZnSnO.

In this report, reactive and nonreactive sputtering of amorphous ZnSnO (a-ZnSnO) was investigated, and extensive composition maps have been measured by X-ray photoelectron spectroscopy. The comprehensive analysis of the ((ZnO)(SnO)) composition reveals that the best Zn/Sn ratio for high conductivity of the material can vary depending on the deposition technique utilized. Best conductivities of 225 S/cm were found to occur at = 0.

Measurement of deposition rate and ion energy distribution in a pulsed dc magnetron sputtering system using a retarding field analyzer with embedded quartz crystal microbalance.

A compact retarding field analyzer with embedded quartz crystal microbalance has been developed to measure deposition rate, ionized flux fraction, and ion energy distribution arriving at the substrate location. The sensor can be placed on grounded, electrically floating, or radio frequency (rf) biased electrodes. A calibration method is presented to compensate for temperature effects in the quartz crystal.

Pulsed-Plasma Physical Vapor Deposition Approach Toward the Facile Synthesis of Multilayer and Monolayer Graphene for Anticoagulation Applications.

We demonstrate the growth of multilayer and single-layer graphene on copper foil using bipolar pulsed direct current (DC) magnetron sputtering of a graphite target in pure argon atmosphere. Single-layer graphene (SG) and few-layer graphene (FLG) films are deposited at temperatures ranging from 700 °C to 920 °C within <30 min. We find that the deposition and post-deposition annealing temperatures influence the layer thickness and quality of the graphene films formed.

Protection and functionalisation of silver as an optical sensing platform for highly sensitive SPR based analysis.

Silver thin films are well known as the most sensitive material for surface plasmon resonance (SPR) based analysis. However, the use of silver for this purpose is limited by three main issues, namely poor adhesion to plastic substrates, chemical instability in both air and aqueous environments and hence the difficulty in functionalizing the silver coated substrate for immobilizing biomolecular ligands by conventional liquid phase methods. In this work, we have successfully addressed these problems using gas-phase coating processes.