Nanoribbons, nanometre-wide strips of a two-dimensional material, are a unique system in condensed matter. They combine the exotic electronic structures of low-dimensional materials with an enhanced number of exposed edges, where phenomena including ultralong spin coherence times, quantum confinement and topologically protected states can emerge. An exciting prospect for this material concept is the potential for both a tunable semiconducting electronic structure and magnetism along the nanoribbon edge, a key property for spin-based electronics such as (low-energy) non-volatile transistors.
View Article and Find Full Text PDFJ Phys Condens Matter
October 2024
Atomically thin group IV monochalcogenides or phosphorene analogues are a promising family of materials. Theoretical calculations predict that monolayers (MLs) should be semiconducting, ferroelectric and ferroelastic at room temperature, exhibit large charge mobilities and large non-linear optical response. Yet, experimental studies of these systems are scarce because of the difficulty to produce such MLs.
View Article and Find Full Text PDFTransition metal oxides are state-of-the-art materials for catalysing the oxygen evolution reaction (OER), whose slow kinetics currently limit the efficiency of water electrolysis. However, microscale physicochemical heterogeneity between particles, dynamic reactions both in the bulk and at the surface, and an interplay between particle reactivity and electrolyte makes probing the OER challenging. Here, we overcome these limitations by applying state-of-the-art compressive Raman imaging to uncover concurrent bias-dependent pathways for the OER in a dense, crystalline electrocatalyst, α-LiIrO.
View Article and Find Full Text PDFLiquid phase separation using aqueous biphasic systems (ABS) is widely used in industrial processes for the extraction, separation and purification of macromolecules. Using water as the single solvent, a wide variety of solutes have been used to induce phase separation including polymers, ionic liquids or salts. For each system, polymer-polymer, polymer-ionic liquid, polymer-salt or salt-salt, different driving forces were proposed to induce phase separation.
View Article and Find Full Text PDFPhoto(electro)catalysts use sunlight to drive chemical reactions such as water splitting. A major factor limiting photocatalyst development is physicochemical heterogeneity which leads to spatially dependent reactivity. To link structure and function in such systems, simultaneous probing of the electrochemical environment at microscopic length scales and a broad range of timescales (ns to s) is required.
View Article and Find Full Text PDFAdaptive optics (AO) has revolutionized imaging in fields from astronomy to microscopy by correcting optical aberrations. In label-free microscopes, however, conventional AO faces limitations because of the absence of a guide star and the need to select an optimization metric specific to the sample and imaging process. Here, we propose an AO approach leveraging correlations between entangled photons to directly correct the point spread function.
View Article and Find Full Text PDFUnderstanding (de)lithiation heterogeneities in battery materials is key to ensure optimal electrochemical performance. However, this remains challenging due to the three-dimensional morphology of electrode particles, the involvement of both solid- and liquid-phase reactants and a range of relevant timescales (seconds to hours). Here we overcome this problem and demonstrate the use of confocal microscopy for the simultaneous three-dimensional operando measurement of lithium-ion dynamics in individual agglomerate particles, and the electrolyte in batteries.
View Article and Find Full Text PDFPhotobatteries, batteries with a light-sensitive electrode, have recently been proposed as a way of simultaneously capturing and storing solar energy in a single device. Despite reports of photocharging with multiple different electrode materials, the overall mechanism of operation remains poorly understood. Here, we use optical reflection microscopy to investigate light-induced charging in LiVO electrodes.
View Article and Find Full Text PDFQuasi-1D nanoribbons provide a unique route to diversifying the properties of their parent 2D nanomaterial, introducing lateral quantum confinement and an abundance of edge sites. Here, a new family of nanomaterials is opened with the creation of arsenic-phosphorus alloy nanoribbons (AsPNRs). By ionically etching the layered crystal black arsenic-phosphorus using lithium electride followed by dissolution in amidic solvents, solutions of AsPNRs are formed.
View Article and Find Full Text PDFSimultaneous transport and coupling of ionic and electronic charges is fundamental to electrochemical devices used in energy storage and conversion, neuromorphic computing and bioelectronics. While the mixed conductors enabling these technologies are widely used, the dynamic relationship between ionic and electronic transport is generally poorly understood, hindering the rational design of new materials. In semiconducting electrodes, electrochemical doping is assumed to be limited by motion of ions due to their large mass compared to electrons and/or holes.
View Article and Find Full Text PDFProc Natl Acad Sci U S A
April 2023
Unlike the interface between two immiscible electrolyte solutions (ITIES) formed between water and polar solvents, molecular understanding of the liquid-liquid interface formed for aqueous biphasic systems (ABSs) is relatively limited and mostly relies on surface tension measurements and thermodynamic models. Here, high-resolution Raman imaging is used to provide spatial and chemical resolution of the interface of lithium chloride - lithium bis(trifluoromethanesulfonyl)imide - water (LiCl-LiTFSI-water) and HCl-LiTFSI-water, prototypical salt-salt ABSs found in a range of electrochemical applications. The concentration profiles of both TFSI anions and water are found to be sigmoidal thus not showing any signs of a positive adsorption for both salts and solvent.
View Article and Find Full Text PDFAutosomal dominant polycystic kidney disease (ADPKD) is the most prevalent potentially lethal monogenic disorder. Mutations in the PKD1 gene, which encodes polycystin-1 (PC1), account for approximately 78% of cases. PC1 is a large 462-kDa protein that undergoes cleavage in its N and C-terminal domains.
View Article and Find Full Text PDFDoping halide perovskites (HPs) with extrinsic species, such as alkali metal ions, plays a critical, albeit often elusive role in optimising optoelectronic devices. Here, we use solid state lithium ion battery inspired devices with a polyethylene oxide-based polymer electrolyte to dope HPs controllably with lithium ions. We perform a suite of material analysis techniques while dynamically varying Li doping concentrations.
View Article and Find Full Text PDFThermally activated delayed fluorescence enables organic semiconductors with charge transfer-type excitons to convert dark triplet states into bright singlets via reverse intersystem crossing. However, thus far, the contribution from the dielectric environment has received insufficient attention. Here we study the role of the dielectric environment in a range of thermally activated delayed fluorescence materials with varying changes in dipole moment upon optical excitation.
View Article and Find Full Text PDFWhile there have been numerous reports of long-range polariton transport at room-temperature in organic cavities, the spatiotemporal evolution of the propagation is scarcely reported, particularly in the initial coherent sub-ps regime, where photon and exciton wavefunctions are inextricably mixed. Hence the detailed process of coherent organic exciton-polariton transport and, in particular, the role of dark states has remained poorly understood. Here, femtosecond transient absorption microscopy is used to directly image coherent polariton motion in microcavities of varying quality factor.
View Article and Find Full Text PDFQuantum dot (QD) solids are an emerging platform for developing a range of optoelectronic devices. Thus, understanding exciton dynamics is essential towards developing and optimizing QD devices. Here, using transient absorption microscopy, we reveal the initial exciton dynamics in QDs with femtosecond timescales.
View Article and Find Full Text PDFNatural photosystems use protein scaffolds to control intermolecular interactions that enable exciton flow, charge generation, and long-range charge separation. In contrast, there is limited structural control in current organic electronic devices such as OLEDs and solar cells. We report here the DNA-encoded assembly of π-conjugated perylene diimides (PDIs) with deterministic control over the number of electronically coupled molecules.
View Article and Find Full Text PDFPhosphorene nanoribbons (PNRs) have been widely predicted to exhibit a range of superlative functional properties; however, because they have only recently been isolated, these properties are yet to be shown to translate to improved performance in any application. PNRs show particular promise for optoelectronics, given their predicted high exciton binding energies, tunable bandgaps, and ultrahigh hole mobilities. Here, we verify the theorized enhanced hole mobility in both solar cells and space-charge-limited-current devices, demonstrating the potential for PNRs improving hole extraction in universal optoelectronic applications.
View Article and Find Full Text PDFStrong-coupling between excitons and confined photonic modes can lead to the formation of new quasi-particles termed exciton-polaritons which can display a range of interesting properties such as super-fluidity, ultrafast transport and Bose-Einstein condensation. Strong-coupling typically occurs when an excitonic material is confided in a dielectric or plasmonic microcavity. Here, we show polaritons can form at room temperature in a range of chemically diverse, organic semiconductor thin films, despite the absence of an external cavity.
View Article and Find Full Text PDFStrong light-matter coupling to form exciton- and vibropolaritons is increasingly touted as a powerful tool to alter the fundamental properties of organic materials. It is proposed that these states and their facile tunability can be used to rewrite molecular potential energy landscapes and redirect photophysical pathways, with applications from catalysis to electronic devices. Crucial to their photophysical properties is the exchange of energy between coherent, bright polaritons and incoherent dark states.
View Article and Find Full Text PDFMolecular chirality can be exploited as a sensitive reporter of the nature of intra- and interchromophore interactions in π-conjugated systems. In this report, we designed an intramolecular singlet fission (iSF)-based pentacene dimer with an axially chiral binaphthyl bridge (2,2'-(2,2'-dimethoxy-[1,1'-binaphthalene]-3,3'-diyl) -octyl-di-isopropyl silylethynyl dipentacene, ) to utilize its chiroptical response as a marker of iSF chromophore-bridge-chromophore (SFC-β-SFC) interactions. The axial chirality of the bridge enforces significant one-handed excitonic coupling of the pentacene monomer units; as such, exhibits significant chiroptical response in the ground and excited states.
View Article and Find Full Text PDFThe inherently low photoluminescence (PL) yields in the as prepared transition metal dichalcogenide (TMD) monolayers are broadly accepted to be the result of atomic vacancies (, defects) and uncontrolled doping, which give rise to non-radiative exciton decay pathways. To date, a number of chemical passivation schemes have been successfully developed to improve PL in sulphur based TMDs , molybdenum disulphide (MoS) and tungsten disulphide (WS) monolayers. Studies on solution based chemical passivation schemes for improving PL yields in selenium (Se) based TMDs are however lacking in comparison.
View Article and Find Full Text PDFMany optoelectronic devices based on organic materials require rapid and long-range singlet exciton transport. Key factors controlling exciton transport include material structure, exciton-phonon coupling and electronic state symmetry. Here, we employ femtosecond transient absorption microscopy to study the influence of these parameters on exciton transport in one-dimensional conjugated polymers.
View Article and Find Full Text PDFHeterostructures of two-dimensional (2D) transition metal dichalcogenides (TMDs) and inorganic semiconducting zero-dimensional (0D) quantum dots (QDs) offer useful charge and energy transfer pathways, which could form the basis of future optoelectronic devices. To date, most have focused on charge transfer and energy transfer from QDs to TMDs, that is, from 0D to 2D. Here, we present a study of the energy transfer process from a 2D to 0D material, specifically exploring energy transfer from monolayer tungsten disulfide (WS) to near-infrared emitting lead sulfide-cadmium sulfide (PbS-CdS) QDs.
View Article and Find Full Text PDF