Strength Optimisation of Hybrid Bolted/Bonded Composite Joints Based on Finite Element Analysis.

A finite element analysis (FEA) was conducted to examine the behaviour of single-lap quasi-isotropic (QI) and cross-ply (CP) hybrid bolted/bonded (HBB) configurations subjected to tensile shear loading. Several critical design factors influencing the composite joint strength, failure conditions, and load-sharing mechanisms that would optimise the joining performance were assessed. The study of the stress concentration around the holes and along the adhesive layer highlights the fact that the HBB joints benefit from significantly lower stresses compared to only bolted joints, especially for CP configurations.

Microwave-Assisted Pyrolysis of Carbon Fiber-Reinforced Polymers and Optimization Using the Box-Behnken Response Surface Methodology Tool.

This article introduces an eco-friendly method for the reclamation of carbon fiber-reinforced polymers (CFRP). The research project involved numerous experiments using microwave-assisted pyrolysis (MAP) to explore a range of factors, such as the inert gas flow, the power level, the On/Off frequency of rotation, and the reaction duration. To design the experiments, the three-level Box-Behnken optimization tool was employed.

The Tensile Behavior of Hybrid Bonded Bolted Composite Joints: 3D-Digital Image Correlation versus Finite Element Analysis.

This study examines the behavior of hybrid bolted/bonded (HBB) joints loaded in tensile shear comprising plain weave carbon/epoxy laminates in quasi-isotropic (QI) and cross-ply (CP) layups. It proposes a combined approach of 3D digital image correlation and finite element analysis (FEA) to assess their behavior. To apply the FEA simulation accurately, a single layer of plain fabric was replaced with [0/90]s lamination.

Unified Formulation for a Triaxial Elastoplastic Constitutive Law for Concrete.

A constitutive model to describe the triaxial load-response spectrum of plain concrete in both tension and shear was developed. The inelastic phenomena are described using the plastic flow with direction determined by the gradient of the plastic potential. A new plastic potential is introduced and experimentally fitted to ensure better estimate of the load direction.