Droplet Friction on Superhydrophobic Surfaces Scales With Liquid-Solid Contact Fraction.

It is generally assumed that contact angle hysteresis of superhydrophobic surfaces scales with liquid-solid contact fraction, however, its experimental verification has been problematic due to the limited accuracy of contact angle and sliding angle goniometry. Advances in cantilever-based friction probes enable accurate droplet friction measurements down to the nanonewton regime, thus suiting much better for characterizing the wetting of superhydrophobic surfaces than contact angle hysteresis measurements. This work quantifies the relationship between droplet friction and liquid-solid contact fraction, through theory and experimental validation.

Ultrasonic Healing of Plastrons.

Superhydrophobic surfaces (SHS) exhibit a pronounced ability to resist wetting. When immersed in water, water does not penetrate between the microstructures of the SHS. Instead, a thin layer of trapped gas remains, i.

Super-Droplet-Repellent Carbon-Based Printable Perovskite Solar Cells.

Despite attractive cost-effectiveness, scalability, and superior stability, carbon-based printable perovskite solar cells (CPSCs) still face moisture-induced degradation that limits their lifespan and commercial potential. Here, the moisture-preventing mechanisms of thin nanostructured super-repellent coating (advancing contact angle >167° and contact angle hysteresis 7°) integrated into CPSCs are investigated for different moisture forms (falling water droplets vs water vapor vs condensed water droplets). It is shown that unencapsulated super-repellent CPSCs have superior performance under continuous droplet impact for 12 h (rain falling experiments) compared to unencapsulated pristine (uncoated) CPSCs that degrade within seconds.

Through-Drop Imaging of Liquid-Solid Interfaces: From Contact Angle Variations Along the Droplet Perimeter to Mapping of Contact Angles Across a Surface.

When a droplet interacts with a water-repellent surface, its triple-phase contact line typically exhibits varying contact angles, which can vary from point-to-point across the surface. Consequently, measuring the contact angles along the contact line would provide a better representation of the wetting properties of the surface than a single average contact angle. However, an effective method for estimating the local contact angle along the contact line on opaque hydrophobic surfaces is currently lacking.