Bioburden assessment of necrotic teeth disinfected with sodium hypochlorite, diode laser, and photodynamic therapy using flow cytometry-a randomized double-blinded clinical trial.

This study aimed to comparatively evaluate the disinfecting potential of sodium hypochlorite, diode laser, and photodynamic therapy in non-vital teeth with or without periapical rarefaction. Forty-five patients with the diagnosis of pulp necrosis with apical rarefaction were randomly assigned to three groups (n = 15) based on the disinfection protocol. Access cavities were prepared and pre-instrumentation microbial samples were taken using a paper point.

Influence of varying dry air temperatures on postoperative sensitivity, penetration depth, and push-out bond strength of an ethanol/water-based adhesive: An double-blind clinical trial and analysis.

Background: Incomplete monomer infiltration into the etched dentin causes postoperative sensitivity (POS) with total-etch adhesives. Increasing the temperature of the air to dry the adhesive has shown to improve its infiltration into the dentin.

Aims: The aim of this research is to evaluate the effectiveness of dry air temperatures of 15°C ± 5°C and 50°C ± 5°C on the POS, depth of penetration, and bond strength of an ethanol/water-based etch-and-rinse (ER) adhesive under and conditions.

Comparative Evaluation of Stress Distribution in Experimentally Designed Nickel-titanium Rotary Files with Varying Cross Sections: A Finite Element Analysis.

Introduction: Single cross-sectional nickel-titanium (NiTi) rotary instruments during continuous rotations are subjected to constant and variable stresses depending on the canal anatomy. This study was intended to create 2 new experimental, theoretic single-file designs with combinations of triple U (TU), triangle (TR), and convex triangle (CT) cross sections and to compare their bending stresses in simulated root canals with a single cross-sectional instrument using finite element analysis.

Methods: A 3-dimensional model of the simulated root canal with 45° curvature and NiTi files with 5 cross-sectional designs were created using Pro/ENGINEER Wildfire 4.