Iron ochre - a pre-catalyst for the cracking of methane.

Background: Iron ochres are gelatinous sludges that can cause problems in terms of water management. In this work, the application of iron ochre obtained from a river has been applied to catalytically crack methane - another potential waste product - into two useful products, hydrogen and a magnetic carbon-containing composite.

Results: The powder X-ray diffraction (XRD) pattern of the iron ochre was found to be consistent with the expected 2-line ferrihydrite, and energy dispersive X-ray (EDX) analysis showed Fe to be a major component although some Si and Ca were present.

Biodegradation of chitosan and its effect on metal bioavailability.

The microbial breakdown of chitosan, a fishery waste-based material, and its derivative cross-linked chitosans, in both non-contaminated and contaminated conditions was investigated in a laboratory incubation study. Biodegradation of chitosan and cross-linked chitosans was affected by the presence of heavy metals. Zn was more pronounced in inhibiting microbial activity than Cu and Pb.

Treatment of heavy metals by iron oxide coated and natural gravel media in Sustainable urban Drainage Systems.

Sustainable urban Drainage Systems (SuDS) filter drains are simple, low-cost systems utilized as a first defence to treat road runoff by employing biogeochemical processes to reduce pollutants. However, the mechanisms involved in pollution attenuation are poorly understood. This work aims to develop a better understanding of these mechanisms to facilitate improved SuDS design.

Metal accumulation in Lolium perenne and Brassica napus as affected by application of chitosans.

The effects of chitosan, a fishery waste-based material, and its derivative glutaraldehyde cross-linked chitosan (chitosan-GLA) on metal uptake by Lolium perenne (perennial ryegrass) and Brassica napus (rapeseed) were studied in a greenhouse pot experiment. Metal uptake by perennial ryegrass was highly dependent on the rate of addition of the chitosans. Low application rate (1% w/w) enhanced metal uptake, whereas 10% (w/w) addition decreased metal uptake.

Carbonised red mud--a new water treatment product made from a waste material.

Proposals to use red mud, the waste produced by the extraction of alumina from bauxite ore in the Bayer process, as a material for treatment of heavy metal-contaminated water are limited by its inherent alkalinity and variability. Attempts to lower its pH have been largely unreliable. However, an alternative strategy is carbonisation of red mud by catalytic hydrocarbon cracking, which results in a magnetic material of greater surface area.

Spatial and temporal variations in Pb concentrations and isotopic composition in road dust, farmland soil and vegetation in proximity to roads since cessation of use of leaded petrol in the UK.

Results are presented for a study of spatial distributions and temporal trends in concentrations of lead (Pb) from different sources in soil and vegetation of an arable farm in central Scotland in the decade since the use of leaded petrol was terminated. Isotopic analyses revealed that in all of the samples analysed, the Pb conformed to a binary mixture of petrol Pb and Pb from industrial or indigenous geological sources and that locally enhanced levels of petrol Pb were restricted to within 10 m of a motorway and 3 m of a minor road. Overall, the dominant source of Pb was historical emissions from nearby industrial areas.

Binding of heavy metal contaminants onto chitosans--an evaluation for remediation of metal contaminated soil and water.

The binding efficiency of chitosan samples for Ag(+), Cd(2+), Cu(2+), Pb(2+) and Zn(2+) has been evaluated in order to consider their application to remediate metal contaminated soil and water. The sorption behaviour of metal ions was assessed using a batch technique at different contact time and initial metal concentration with different background electrolytes. The kinetics followed a pseudo-second-order model, while the equilibrium data correlated well with the Freundlich and Langmuir isotherm models.

Analytical and sampling constraints in ²¹⁰Pb dating.

²¹⁰Pb dating provides a valuable, widely used means of establishing recent chronologies for sediments and other accumulating natural deposits. The Constant Rate of Supply (CRS) model is the most versatile and widely used method for establishing ²¹⁰Pb chronologies but, when using this model, care must be taken to account for limitations imposed by sampling and analytical factors. In particular, incompatibility of finite values for empirical data, which are constrained by detection limit and core length, with terms in the age calculation, which represent integrations to infinity, can generate erroneously old ages for deeper sections of cores.

Microbial respiration as an indication of metal toxicity in contaminated organic materials and soil.

The effect of heavy metals on microbial respiration in organic materials used as soil amendments was evaluated to assess the stability of the materials. Solutions of Pb (II), Cu (II) and Zn (II) at rates of 5, 10 and 50mg metal g(-1) were added to green waste compost, peat, coir and wood bark. Metal toxicity led to a significant decrease in carbon dioxide evolved by the contaminated materials, up to 80% less at the highest rate of addition compared to the untreated material.

Chitosan as a potential amendment to remediate metal contaminated soil - a characterisation study.

The potential of chitosan, a fishery waste-based material, as a soil amendment to clean-up metal contaminated soil was investigated. Chitosan was treated using glutaraldehyde (GLA), epichlorohydrin (ECH) and ethylene glycol diglycidyl ether (EGDE) as cross-linking reagents to enhance its chemical stability in acidic media and to improve its physical properties. Cross-linking treatment had significant effects on chitosan surface area, pore diameter, surface morphology and crystallinity.

Carbon deposition and phase transformations in red mud on exposure to methane.

A characterization study detailing the phase transformations and microstructural nature of the carbon deposited during methane decomposition over red mud has been undertaken. In situ XRD was carried out to study the phase transformation sequences of red mud during the reaction. Scanning electron microscopy, high resolution transmission electron microscopy, thermogravimetric analysis, BET surface area determination and CHN analysis were carried out to investigate the properties of the post-reaction samples.

Source term characterisation using concentration trends and geochemical associations of Pb and Zn in river sediments in the vicinity of a disused mine site: implications for contaminant metal dispersion processes.

River sediment at a disused lead-zinc mine was analysed to provide an understanding of the chemical nature of the source term for contaminated sediment exported from the site. Changes in concentration and geochemical associations of Pb and Zn were measured using aqua regia digestion and the BCR sequential extraction procedure. Sediment in the immediate vicinity of the mine was highly contaminated with Pb (max.

Cadmium phytoextraction using short-rotation coppice Salix: the evidence trail.

A substantial body of evidence has now accumulated that raises expectations that clean-up of Cd-contaminated land can be achieved through cultivation and harvest of selected clones of short-rotation coppice willow within a realistic crop lifecycle. Cd uptake rates into Salix are high compared to other trace elements and to other plant species. Effective phytoextraction would require (i) careful targeting of hotspots, (ii) repeated harvest prior to leaf fall and (iii) final removal of the root bole.

Development of an ombrotrophic peat bog (low ash) reference material for the determination of elemental concentrations.

Given the increasing interest in using peat bogs as archives of atmospheric metal deposition, the lack of validated sample preparation methods and suitable certified reference materials has hindered not only the quality assurance of the generated analytical data but also the interpretation and comparison of peat core metal profiles from different laboratories in the international community. Reference materials play an important role in the evaluation of the accuracy of analytical results and are essential parts of good laboratory practice. An ombrotrophic peat bog reference material has been developed by 14 laboratories from nine countries in an inter-laboratory comparison between February and October 2002.

Screening of willow species for resistance to heavy metals: comparison of performance in a hydroponics system and field trials.

The aim of this study was to ascertain whether metal resistance in willow (Salix) clones grown in a hydroponics screening test correlated with data from the same clones grown independently in a field trial. If so, results from a short-term, glasshouse-based system could be extrapolated to the field, allowing rapid identification of willows suitable for planting in metal-contaminated substrates without necessitating longterm field trials. Principal Components Analysis was used to show groups of clones and to assess the relative importance of the parameters measured in both the hydroponics system and the field; including plant response factors such as increase in stem height, as well as metal concentrations in plant tissues.

Development of a hydroponic screening technique to assess heavy metal resistance in willow (Salix).

A nutrient thin film hydroponic system has been developed which allows rapid screening of willow (Salix) clones for their resistance to heavy metals, and hence their use in phytoremediation. Two clones known to be different in their resistance to heavy metals (Salix burjatica (Germany) and S. triandra x viminalis (Q83)), could be distinguished on the basis of leaf biomass, root biomass and stem height after 6 weeks.

Sorption of Cu and Zn by bone charcoal.

Bone charcoal is being developed as a treatment for decontaminating polluted water. In particular, its potential to adsorb metal species from contaminated water supplies is being examined. In this study, bone charcoal was used in batch and column experiments designed to investigate the sorption of two cationic metals Cu and Zn.

Phytoremediation of heavy metal-contaminated land by trees--a review.

This paper reviews the potential for using trees for the phytoremediation of heavy metal-contaminated land. It considers the following aspects: metal tolerance in trees, heavy metal uptake by trees grown on contaminated substrates, heavy metal compartmentalisation within trees, phytoremediation using trees and the phytoremediation potential of willow (Salix spp.).

Tissue nutrient signatures predict herbaceous-wetland community responses to nutrient availability.

•  An extensive survey of European wetlands was undertaken to compare the importance of growing conditions vs functional characteristics of vegetation in determining N, P and K contents. •  Stress-tolerator dominated stands (S) had consistently lower nutrient contents and higher N : P ratios whereas ruderal-dominated (R) stands displayed the opposite pattern. Competitor (C) and competitor-stress tolerator (CS) stands were intermediate to R and S.