In situ ground settlement sensor for oil-tank monitoring by combining a fiber-optic low-coherent interferometry with a fine mechanical design.

An in situ robust ground settlement (IR-GS) sensor was designed to meet the requirements for oil-tank health monitoring by combining a low-coherent fiber-optic interferometry with a fine mechanical spline shaft. A floating mirror was mounted on the shaft and moved up and down along with the liquid surface. The liquid-contained chambers were hydraulically connected at the bottom by using a liquid-filled tube.

Performance of the fiber-optic low-coherent ground settlement sensor: From lab to field.

A fiber-optic low-coherent interferometry sensor was developed to measure the ground settlement (GS) in an accuracy of the micrometer. The sensor combined optical techniques with liquid-contained chambers that were hydraulically connected together at the bottom by using a water-filled tube. The liquid surface inside each chamber was at the same level initially.

Tilt performance of the ground settlement sensor configured in a fiber-optic low-coherent interferometer.

Ground settlement (GS) is one of the causes that destroy the durability of reinforced concrete structures. It could lead to a deterioration in the structural basement and increase the risk of collapse. The methods used for GS monitoring were mostly electronic-based sensors for reading the changes in resistance, resonant frequencies, etc.

Fiber-optic ground settlement sensor based on low-coherent interferometry.

Ground settlement (GS) monitoring is a basic prerequisite in civil engineering. A commercialized instrument to meet this requirement has been available with millimeter accuracy. Major difficulties to improve this to micrometer scale, which are needed in special cases such as in high-speed railways, are challenged by the long stability of the sensor in the condition of the extremely slow settlement.

The performance analysis of distributed Brillouin corrosion sensors for steel reinforced concrete structures.

The Brillouin optical time-domain analysis (BOTDA)-based optical fiber method has been proposed to measure strain variations caused by corrosion expansion. Spatial resolutions of 1 m can be achieved with this kind of Brillouin sensor for detecting the distributed strain. However, when the sensing fiber is wound around the steel rebar in a number of circles in a range of several meters, this spatial resolution still has limitations for corrosion monitoring.