Correction of systematic low-frequency time delay errors in THz systems by absorption line shape optimization.

Time-domain terahertz systems can face challenges due to systematic delay errors introduced by the employed delay mechanism, potentially leading to poor data quality. This article introduces a procedure to address these challenges by correcting low-frequency systematic errors that distort the acquired spectra and incorrectly diminish narrow absorption features. Our procedure solves an optimization problem aiming to find the corrected time-signal pairs that maximize the depth of narrow absorption features, and we highlight how the flexibility of the procedure, in principle, allows for correcting error profiles of arbitrary shape.

Balanced air-biased detection of terahertz waveforms.

A novel, to the best of our knowledge, balanced air-biased coherent detection scheme for capturing ultrabroadband terahertz (THz) waveforms is implemented. The balanced detection scheme allows for coherent detection at the full repetition rate of the laser system without requiring bias modulation, signal generators, or lock-in amplifiers while doubling the dynamic range and quadrupling the signal-to-noise ratio compared to conventional air-biased coherent detection. These advantages are achieved by rotating the bias electrodes by 90° relative to the conventional scheme.

Terahertz time-domain imaging for the examination of gilded wooden artifacts.

Terahertz imaging is unlocking unique capabilities for the analysis of cultural heritage artifacts. This paper uses terahertz time-domain imaging for the study of a gilded wooden artifact, providing a means to perform stratigraphic analysis, yielding information about the composition of the artifact, presence of certain materials identifiable through their THz spectral fingerprint, as well as alterations that have been performed over time. Due to the limited information that is available for many historic artifacts, the data that can be obtained through the presented technique can guide proper stewardship of the artifact, informing its long-term preservation.

Probing Carrier Dynamics in Large-Scale MBE-Grown PtSe Films by Terahertz Spectroscopy.

Atomically thin platinum diselenide (PtSe) films are promising for applications in the fields of electronics, spintronics, and photodetectors owing to their tunable electronic structure and high carrier mobility. Using terahertz (THz) spectroscopy techniques, we investigated the layer-dependent semiconducting-to-metallic phase transition and associated intrinsic carrier dynamics in large-scale PtSe films grown by molecular beam epitaxy. The uniformity of large-scale PtSe films was characterized by spatially and frequency-resolved THz-based sheet conductivity mapping.

Frequency-resolved characterization of broadband two-color air-plasma terahertz beam profiles.

The frequency-resolved terahertz (THz) beam profile characteristics of a two-color air-plasma THz source were investigated in the broadband frequency range (1-15 THz). The frequency resolution is achieved by combining THz waveform measurements and the knife-edge technique. Our results show that the THz focal spot size is strongly frequency dependent.

Non-Linear Conductivity Response of Graphene on Thin-Film PET Characterized by Transmission and Reflection Air-Plasma THz-TDS.

We demonstrate that the conductivity of graphene on thin-film polymer substrates can be accurately determined by reflection-mode air-plasma-based THz time-domain spectroscopy (THz-TDS). The phase uncertainty issue associated with reflection measurements is discussed, and our implementation is validated by convincing agreement with graphene electrical properties extracted from more conventional transmission-mode measurements. Both the reflection and transmission THz-TDS measurements reveal strong non-linear and instantaneous conductivity depletion across an ultra-broad bandwidth (1-9 THz) under relatively high incident THz electrical field strengths (up to 1050 kV/cm).

Terahertz Cross-Correlation Spectroscopy and Imaging of Large-Area Graphene.

We demonstrate the use of a novel, integrated THz system to obtain time-domain signals for spectroscopy in the 0.1-1.4 THz range.

Resonant Laser Printing of Optical Metasurfaces.

One of the challenges for metasurface research is upscaling. The conventional methods for fabrication of metasurfaces, such as electron-beam or focused ion beam lithography, are not scalable. The use of ultraviolet steppers or nanoimprinting still requires large-size masks or stamps, which are costly and challenging in further handling.

Four-probe sensing of temperature during Joule heating of silicon.

We present a four-probe setup for measuring temperature of Joule-heated silicon in two independent ways from the same voltage measurement: a method using the thermal dependence of resistivity and a method based on the measured sheet power density. The two methods are compared to optical temperature measurements made by fitting a gray-body model onto data from a commercial spectrometer. The two four-probe temperature measurements are conducted from 890 K to 1540 K, and they converge at temperatures above 1400 K indicating a high degree of self-consistency.

Mid-infrared, long-wave infrared, and terahertz photonics: introduction.

This feature issue presents recent progress in long-wavelength photonics, focusing on wavelengths that span the mid-infrared (3-50 µm), the long-wavelength infrared (30-60 µm), and the terahertz (60-300 µm) portions of the electromagnetic spectrum. The papers in this feature issue report recent progress in the generation, manipulation, detection, and use of light across this long-wave region of the "photonics spectrum," including novel sources and cutting edge advances in detectors, long-wavelength non-linear processes, optical metamaterials and metasurfaces, and molecular spectroscopy. The range of topics covered in this feature issue provide an excellent insight into the expanding interest in long-wavelength photonics, which could open new possibilities for basic research and applications in industries that span health, environmental, and security.

MHz-repetition-rate, sub-mW, multi-octave THz wave generation in HMQ-TMS.

We demonstrate the first megahertz (MHz) repetition-rate, broadband terahertz (THz) source based on optical rectification in the organic crystal HMQ-TMS driven by a femtosecond Yb:fibre laser. Pumping at 1035 nm with 30 fs pulses, we achieve few-cycle THz emission with a smooth multi-octave spectrum that extends up to 6 THz at -30 dB, with conversion efficiencies reaching 10 and an average output power of up to 0.38 mW.

Noise and spectral stability of deep-UV gas-filled fiber-based supercontinuum sources driven by ultrafast mid-IR pulses.

Deep-UV (DUV) supercontinuum (SC) sources based on gas-filled hollow-core fibers constitute perhaps the most viable solution towards ultrafast, compact, and tunable lasers in the UV spectral region, which can even also extend into the mid-infrared (IR). Noise and spectral stability of such broadband sources are key parameters that define their true potential and suitability towards real-world applications. In order to investigate the spectral stability and noise levels in these fiber-based DUV sources, we generate an SC spectrum that extends from 180 nm (through phase-matched dispersive waves - DWs) to 4 μm by pumping an argon-filled hollow-core anti-resonant fiber at a mid-IR wavelength of 2.

Terahertz time-domain spectroscopy of zone-folded acoustic phonons in 4H and 6H silicon carbide.

We investigate the dielectric properties of the 4H and 6H polytypes of silicon carbide in the 0.1-19 THz range, below the fundamental transverse-optical phonons. Folding of the Brillouin zone due to the specific superlattice structure of the two polytypes leads to activation of acoustic phonon modes.

Quality assessment of terahertz time-domain spectroscopy transmission and reflection modes for graphene conductivity mapping.

We present a comparative study of electrical measurements of graphene using terahertz time-domain spectroscopy in transmission and reflection mode, and compare the measured sheet conductivity values to electrical van der Pauw measurements made independently in three different laboratories. Overall median conductivity variations of up to 15% were observed between laboratories, which are attributed mainly to the well-known temperature and humidity dependence of non-encapsulated graphene devices. We conclude that terahertz time-domain spectroscopy performed in either reflection mode or transmission modes are indeed very accurate methods for mapping electrical conductivity of graphene, and that both methods are interchangeable within measurement uncertainties.

Robust mapping of electrical properties of graphene from terahertz time-domain spectroscopy with timing jitter correction.

We demonstrate a method for reliably determining the electrical properties of graphene including the carrier scattering time and carrier drift mobility from terahertz time- domain spectroscopy measurements (THz-TDS). By comparing transients originating from directly transmitted pulses and the echoes from internal reflections in a substrate, we are able to extract electrical properties irrespective of random time delays between pulses emitted in a THz-TDS setup. If such time delays are not accounted for they can significantly influence the extracted properties of the material.

Amplification of resonant field enhancement by plasmonic lattice coupling in metallic slit arrays.

Nonlinear spectroscopic investigation in the terahertz (THz) range requires significant field strength of the light fields. It is still a challenge to obtain the required field strengths in free space from table-top laser systems at sufficiently high repetition rates to enable quantitative nonlinear spectroscopy. It is well known that local enhancement of the THz field can be obtained for instance in narrow apertures in metallic films.

Reflection terahertz time-domain imaging for analysis of an 18th century neoclassical easel painting.

Terahertz time-domain imaging (THz-TDI) has been applied for imaging a hidden portrait and other subsurface composition layers of an 18th century (18C) easel painting by Nicolai Abildgaard, the most important 18C Danish neoclassical painter of historical and mythological subjects. For the first time, a real hidden portrait on an easel painting has been imaged by THz-TDI, with an unexpected richness of detail. THz C- and B-scans have been compared with images obtained by x-ray radiography and invasive cross-sectional imaging, leading to a deeper understanding of the strengths and limitations of this technique for art diagnostic purposes and defining its role among complementary tools for the investigation of art objects.

Permanently reconfigured metamaterials due to terahertz induced mass transfer of gold.

We present a new technique for permanent metamaterial reconfiguration via optically induced mass transfer of gold. This mass transfer, which can be explained by field-emission induced electromigration, causes a geometric change in the metamaterial sample. Since a metamaterial's electromagnetic response is dictated by its geometry, this structural change massively alters the metamaterial's behavior.

Dielectric tube waveguides with absorptive cladding for broadband, low-dispersion and low loss THz guiding.

Research on terahertz waveguides is experiencing a tremendous growth due to their importance for compact and robust THz systems. However, designing compact, broadband, mechanically stable and environmentally shielded THz waveguides is still a challenge due to high losses of both metals and dielectrics in this frequency range. Here we report on a novel twist on the classical tube waveguide where we deliberately introduce a thick and highly lossy cladding layer.

Design and optimization of mechanically down-doped terahertz fiber directional couplers.

We present a thorough practical design optimization of broadband low loss, terahertz (THz) photonic crystal fiber directional couplers in which the two cores are mechanically down-doped with a triangular array of air holes. A figure of merit taking both the 3-dB bandwidth and loss of the coupler into account, is used for optimization of the structure parameters, given by the diameter and pitch of the cladding (d and Λ) and of the core (d(c) and Λc) air-hole structure. The coupler with Λ = 498.

Fabrication and characterization of porous-core honeycomb bandgap THz fibers.

We present a numerical and experimental investigation of a low-loss porous-core honeycomb fiber for terahertz wave guiding. The introduction of a porous core with hole size of the same dimension as the holes in the surrounding honeycomb cladding results in a fiber that can be drawn with much higher precision and reproducibility than a corresponding air-core fiber. The high-precision hole structure provides very clear bandgap guidance and the location of the two measured bandgaps agree well with simulations based on finite-element modeling.

A new method for obtaining transparent electrodes.

In this article, we propose a simple scheme to make a metallic film on a semi-infinite substrate optically transparent, thus obtaining a completely transparent electrode in a desired frequency range. By placing a composite layer consisting of dielectric and metallic stripes on top of the metallic one, we found that the back-scattering from the metallic film can be almost perfectly canceled by the composite layer under certain conditions, leading to transparency of the whole structure. We performed proof-of-concept experiments in the terahertz domain to verify our theoretical predictions, using carefully designed metamaterials to mimic plasmonic metals in optical regime.

Flexible metamaterial absorbers for stealth applications at terahertz frequencies.

We have wrapped metallic cylinders with strongly absorbing metamaterials. These resonant structures, which are patterned on flexible substrates, smoothly coat the cylinder and give it an electromagnetic response designed to minimize its radar cross section. We compare the normal-incidence, small-beam reflection coefficient with the measurement of the far-field bistatic radar cross section of the sample, using a quasi-planar THz wave with a beam diameter significantly larger than the sample dimensions.

Porous-core honeycomb bandgap THz fiber.

In this Letter we propose a novel (to our knowledge) porous-core honeycomb bandgap design. The holes of the porous core are the same size as the holes in the surrounding cladding, thereby giving the proposed fiber important manufacturing benefits. The fiber is shown to have a 0.