Structure-properties relationships of defined CNF single-networks crosslinked by telechelic PEGs.

The high structural anisotropy and colloidal stability of cellulose nanofibrils' enable the creation of self-standing fibrillar hydrogel networks at very low solid contents. Adding methacrylate moieties on the surface of TEMPO oxidized CNFs allows the formation of more robust covalently crosslinked networks by free radical polymerization of acrylic monomers, exploiting the mechanical properties of these networks more efficiently. This technique yields strong and elastic networks but with an undefined network structure.

Hornification of cellulose-rich materials - A kinetically trapped state.

The fundamental understanding concerning cellulose-cellulose interactions under wet and dry conditions remains unclear. This is especially true regarding the drying-induced association of cellulose, commonly described as an irreversible phenomenon called hornification. A fundamental understanding of the mechanisms behind hornification would contribute to new drying techniques for cellulose-based materials in the pulp and paper industry while at the same time enhancing material properties and facilitating the recyclability of cellulose-rich materials.

Advanced Characterization of Self-Fibrillating Cellulose Fibers and Their Use in Tunable Filters.

Thorough characterization and fundamental understanding of cellulose fibers can help us develop new, sustainable material streams and advanced functional materials. As an emerging nanomaterial, cellulose nanofibrils (CNFs) have high specific surface area and good mechanical properties; however, handling and processing challenges have limited their widespread use. This work reports an in-depth characterization of self-fibrillating cellulose fibers (SFFs) and their use in smart, responsive filters capable of regulating flow and retaining nanoscale particles.

Strong Reinforcement Effects in 2D Cellulose Nanofibril-Graphene Oxide (CNF-GO) Nanocomposites due to GO-Induced CNF Ordering.

Nanocomposites from native cellulose with low 2D nanoplatelet content are of interest as sustainable materials combining functional and structural performance. Cellulose nanofibril-graphene oxide (CNF-GO) nanocomposite films are prepared by a physical mixing-drying method, with focus on low GO content, the use of very large GO platelets (2-45μm) and nanostructural characterization using synchrotron x-ray source for WAXS and SAXS. These nanocomposites can be used as transparent coatings, strong films or membranes, as gas barriers or in laminated form.

Cellulose nanocrystal/low methoxyl pectin gels produced by internal ionotropic gelation.

The biotechnological applications of cellulose nanocrystals (CNCs) continue to grow due to their sustainable nature, impressive mechanical, rheological, and emulsifying properties, upscaled production capacity, and compatibility with other materials, such as protein and polysaccharides. In this study, hydrogels from CNCs and pectin, a plant cell wall polysaccharide broadly used in food and pharma, were produced by calcium ion-mediated internal ionotropic gelation (IG). In the absence of pectin, a minimum of 4 wt% CNC was needed to produce self-supporting gels by internal IG, whereas the addition of pectin at 0.

Health-related quality of life in early psoriatic arthritis compared with early rheumatoid arthritis and a general population.

Objective: Both psoriatic arthritis (PsA) and rheumatoid arthritis (RA) have a significant impact on quality of life, but few reports have compared the two diseases. The current study assessed health-related quality of life (HRQoL) in PsA at diagnosis and after five years compared with early rheumatoid arthritis (RA) and a matched general population.

Methods: Patients with early PsA and early RA included in two Swedish registries with HRQoL data measured by the Medical Outcomes Study Short Form 36 (SF-36) at baseline and at five years follow-up were included.

Cross-Sections of Nanocellulose from Wood Analyzed by Quantized Polydispersity of Elementary Microfibrils.

Bio-based nanocellulose has been shown to possess impressive mechanical properties and simplicity for chemical modifications. The chemical properties are largely influenced by the surface area and functionality of the nanoscale materials. However, finding the typical cross-sections of nanocellulose, such as cellulose nanofibers (CNFs), has been a long-standing puzzle, where subtle changes in extraction methods seem to yield different shapes and dimensions.

Swelling of Cellulose-Based Fibrillar and Polymeric Networks Driven by Ion-Induced Osmotic Pressure.

Cellulose-based model materials in the form of fibrillar networks and macromolecular hydrogels were used to investigate the ion-induced swelling in relation to the elasticity and structure of the network. Both networks were charged by the introduction of carboxyl groups onto the cellulose surface, and the dimensions of the networks in aqueous solution were measured as a function of pH. The use of cellulose-model materials that contained either noncrystalline cellulose or cellulose I fibrils made it possible to model the effect of the ion-induced osmotic pressure of a delignified wood fiber wall.

Tuning the properties of regenerated cellulose: Effects of polarity and water solubility of the coagulation medium.

In this study, the effect of different alcohols and esters as a coagulation medium in the regeneration of cellulose dissolved in an aqueous LiOH-urea-based solvent was thoroughly investigated using various methods such as solid state NMR, X-ray diffraction, water contact angle, oxygen gas permeability, mechanical testing, and scanning electron microscopy. It was observed that several material properties of the regenerated cellulose films follow trends that correlate to the degree of cellulose II crystallinity, which is determined to be set by the miscibility of the coagulant medium (nonsolvent) and the aqueous alkali cellulose solvent rather than the nonsolvents' polarity. This article provides an insight, thus creating a possibility to carefully tune and control the cellulose material properties when tailor-made for different applications.

Thermodynamics of the Water-Retaining Properties of Cellulose-Based Networks.

Noncrystalline cellulose-based gel beads were used as a model material to investigate the effect of osmotic stress on a cellulosic network. The gel beads were exposed to osmotic stress by immersion in solutions with different concentrations of high molecular mass dextran and the equilibrium dimensional change of the gel beads was studied using optical microscopy. The volume fraction of cellulose was calculated from the volume of the gel beads in dextran solutions and their dry content and the relation between the cellulose volume fraction and the total osmotic pressure was thus obtained.

Cubosomes for topical delivery of the antimicrobial peptide LL-37.

In this study, the use of cubosomes for topical delivery of the antimicrobial peptide (AMP) LL-37 was investigated. Topical delivery of AMPs is of great interest for treatment of skin infections caused by bacteria, such as Staphylococcus aureus. AMP containing cubosomes were produced by three different preparation protocols and compared: (i) pre-loading, where LL-37 was incorporated into a liquid crystalline gel, which thereafter was dispersed into nanoparticles, (ii) post-loading, where LL-37 was let to adsorb onto pre-formed cubosomes, and (iii) hydrotrope-loading, where LL-37 was incorporated during the spontaneously formed cubosomes in an ethanol/glycerol monooleate mixture.

Multiscale Control of Nanocellulose Assembly: Transferring Remarkable Nanoscale Fibril Mechanics to Macroscale Fibers.

Nanoscale building blocks of many materials exhibit extraordinary mechanical properties due to their defect-free molecular structure. Translation of these high mechanical properties to macroscopic materials represents a difficult materials engineering challenge due to the necessity to organize these building blocks into multiscale patterns and mitigate defects emerging at larger scales. Cellulose nanofibrils (CNFs), the most abundant structural element in living systems, has impressively high strength and stiffness, but natural or artificial cellulose composites are 3-15 times weaker than the CNFs.

Birch wood pre-hydrolysis vs pulp post-hydrolysis for the production of xylan-based compounds and cellulose for viscose application.

Hydrothermal treatments of birch wood and kraft pulp were compared for their ability to extract the xylan and produce viscose-grade pulp. Water post-hydrolysis of kraft pulp produced a high-purity cellulosic pulp with lower viscosity but higher cellulose yield than traditional pre-hydrolysis kraft pulping of wood. Post-hydrolysis of pulp also increased the crystallite dimensions and degree of crystallinity in cellulose, and promoted a higher extent of fibril aggregation.

Carbohydrate gel beads as model probes for quantifying non-ionic and ionic contributions behind the swelling of delignified plant fibers.

Macroscopic beads of water-based gels consisting of uncharged and partially charged β-(1,4)-d-glucan polymers were developed to be used as a novel model material for studying the water induced swelling of the delignified plant fiber walls. The gel beads were prepared by drop-wise precipitation of solutions of dissolving grade fibers carboxymethylated to different degrees. The internal structure was analyzed using Solid State Cross-Polarization Magic Angle Spinning Carbon-13 Nuclear Magnetic Resonance and Small Angle X-ray Scattering showing that the internal structure could be considered a homogeneous, non-crystalline and molecularly dispersed polymer network.

The Swedish Early Psoriatic Arthritis Registry 5-year Followup: Substantial Radiographic Progression Mainly in Men with High Disease Activity and Development of Dactylitis.

Objective: To describe early radiographic findings in patients from the Swedish psoriatic arthritis (SwePsA) registry, progression of destruction, correlations with clinical disease variables, and predictors of destruction.

Methods: Hand and foot radiographs were available for 72 of 197 SwePsA patients followed for 5 years. Clinical data were collected according to the SwePsA protocol.

Phosphorylated Cellulose Nanofibrils: A Renewable Nanomaterial for the Preparation of Intrinsically Flame-Retardant Materials.

Cellulose from wood fibers can be modified for use in flame-retardant composites as an alternative to halogen-based compounds. For this purpose, sulfite dissolving pulp fibers have been chemically modified by phosphorylation, and the resulting material has been used to prepare cellulose nanofibrils (CNF) that have a width of approximately 3 nm. The phosphorylation was achieved using (NH4)2HPO4 in the presence of urea, and the degree of substitution by phosphorus was determined by X-ray photoelectron spectroscopy, conductometric titration, and nuclear magnetic resonance spectroscopy.

Catabolism of coniferyl aldehyde, ferulic acid and p-coumaric acid by Saccharomyces cerevisiae yields less toxic products.

Background: Lignocellulosic substrates and pulping process streams are of increasing relevance to biorefineries for second generation biofuels and biochemical production. They are known to be rich in sugars and inhibitors such as phenolic compounds, organic acids and furaldehydes. Phenolic compounds are a group of aromatic compounds known to be inhibitory to fermentative organisms.

Impact of the supramolecular structure of cellulose on the efficiency of enzymatic hydrolysis.

Background: The efficiency of enzymatic hydrolysis is reduced by the structural properties of cellulose. Although efforts have been made to explain the mechanism of enzymatic hydrolysis of cellulose by considering the interaction of cellulolytic enzymes with cellulose or the changes in the structure of cellulose during enzymatic hydrolysis, the process of cellulose hydrolysis is not yet fully understood. We have analysed the characteristics of the complex supramolecular structure of cellulose on the nanometre scale in terms of the spatial distribution of fibrils and fibril aggregates, the accessible surface area and the crystallinity during enzymatic hydrolysis.

Morphology and enzyme production of Trichoderma reesei Rut C-30 are affected by the physical and structural characteristics of cellulosic substrates.

The industrial production of cellulolytic enzymes is dominated by the filamentous fungus Trichoderma reesei (anamorph of Hypocrea jecorina). In order to develop optimal enzymatic cocktail, it is of importance to understand the natural regulation of the enzyme profile as response to the growth substrate. The influence of the complexity of cellulose on enzyme production by the microorganisms is not understood.

Lightweight, highly compressible, noncrystalline cellulose capsules.

We demonstrate how to prepare extraordinarily deformable, gas-filled, spherical capsules from nonmodified cellulose. These capsules have a low nominal density, ranging from 7.6 to 14.

Early psoriatic arthritis: short symptom duration, male gender and preserved physical functioning at presentation predict favourable outcome at 5-year follow-up. Results from the Swedish Early Psoriatic Arthritis Register (SwePsA).

Objective: The Swedish Early Psoriatic Arthritis Register describes the course of early psoriatic arthritis (PsA) in a real life clinical setting in Sweden. The aim of this study was to obtain information on predictors of clinical outcomes over a 5-year period with special focus on effects of gender, joint patterns, diagnostic delay and initial disease activity.

Methods: In six centres, patients with signs suggestive of PsA were included in the Swedish Early Psoriatic Arthritis Register within 2 years of symptom onset.

Preparation of dry ultra-porous cellulosic fibres: characterization and possible initial uses.

Dry ultra-porous cellulose fibres were obtained using a liquid exchange procedure in which water was replaced in the following order: water, methanol, acetone, and finally pentane; thereafter, the fibres were dried with Ar(g). The dry samples (of TEMPO-oxidized dissolving pulp) had a specific surface area of 130 m(2)g(-1) as measured using BET nitrogen gas adsorption. The open structure in the dry state was also revealed using field emission scanning electron microscopy.

Smoking interacts with HLA-DRB1 shared epitope in the development of anti-citrullinated protein antibody-positive rheumatoid arthritis: results from the Malaysian Epidemiological Investigation of Rheumatoid Arthritis (MyEIRA).

Introduction: Rheumatoid arthritis (RA) is a multifactorial autoimmune disease in which genetic and environmental factors interact in the etiology. In this study, we investigated whether smoking and HLA-DRB1 shared-epitope (SE) alleles interact differently in the development of the two major subgroups of rheumatoid arthritis (RA), anti-citrullinated proteins antibody (ACPA)-positive and ACPA-negative disease, in a multiethnic population of Asian descent.

Methods: A case-control study comprising early diagnosed RA cases was carried out in Malaysia between 2005 and 2009.

Smoking is associated with an increased risk of developing ACPA-positive but not ACPA-negative rheumatoid arthritis in Asian populations: evidence from the Malaysian MyEIRA case-control study.

We investigated the association between cigarette smoking and the risk of developing rheumatoid arthritis (RA) in the Malaysian population. A total of 1,056 RA patients and 1,416 matched controls aged 18-70 years within a defined area of Peninsular Malaysia were evaluated in a case-control study between August 2005 and December 2009. A case was defined as a person with early diagnosed RA using the 1987 American College of Rheumatology criteria for RA.

Shared epitope alleles remain a risk factor for anti-citrullinated proteins antibody (ACPA)--positive rheumatoid arthritis in three Asian ethnic groups.

Background: To investigate the associations between HLA-DRB1 shared epitope (SE) alleles and rheumatoid arthritis in subsets of rheumatoid arthritis defined by autoantibodies in three Asian populations from Malaysia.

Methods: 1,079 rheumatoid arthritis patients and 1,470 healthy controls were included in the study. Levels of antibodies to citrullinated proteins (ACPA) and rheumatoid factors were assessed and the PCR-SSO method was used for HLA-DRB1 genotyping.