An investigation on the physical properties of cementitious pastes modified with low dosage of waste glass powder and silica fume.

Portland cement (PC) production is among the industrial activities that most emit harmful gases. Its replacement to green binders turns into a timely issue to face the global restrictions due to climate changes. In this study, some properties of cementitious pastes prepared with waste packing glass powder (GP) and silica fume (SF) were characterized in line with a prefixed alkaline equivalent limit.

Morphologic characterization and fractal analysis of lapped and polished surfaces of quartz single crystals.

Lapping and polishing are industrial processes sometimes used alternatively for surface finishing of hard and brittle materials. This article presents advanced image analysis of surfaces of quartz crystal blanks finished by lapping and polishing. Scanning electron micrographs were obtained from workpiece surfaces parallel to Y-, AT-, and Z-cut crystal planes treated with different normal stress and abrasive grit size, and stereometric and fractal/multifractal approaches were used to analyze the respective surfaces.

OSL and photo-transferred TL of quartz single crystals sensitized by high-dose of gamma-radiation and moderate heat-treatments.

This study investigates the optically stimulated luminescence (OSL) and the photo-transferred thermoluminescence (PTTL) signals in quartz single crystals showing a strong TL peak near 300°C after being sensitized by irradiation with 25kGy of gamma rays and heating at 400°C. Natural and sensitized samples were prepared from two crystals with different sensitivity levels in the 300°C TL region. Continuous-wave (CW) and linearly-modulated (LM) OSL signals were stimulated with blue light-emitting diodes during 40 and 1000s, respectively.