The effect of thermal cycling and air abrasion on cement failure loads of 4 provisional luting agents used for the cementation of implant-supported fixed partial dentures.

Purpose: To investigate the effects of thermal cycling and surface roughness of metal implant abutments and the intaglio surface of the copings on the retentive properties of 4 provisional luting agents commonly used in the cementation of implant-retained fixed partial dentures (FPDs).

Materials And Methods: A 2-unit implant-retained FPD and a 4-unit implant-retained FPD were fabricated using gold-palladium alloy. The abutments used were 5 mm in height.

Pre- and post-set hydrophilicity of elastomeric impression materials.

Purpose: To evaluate the hydrophilicity of one polyether, four poly(vinyl siloxanes), and one condensation silicone before and after setting under simulated clinical conditions, and to correlate the findings to the contact angle values of these materials.

Materials And Methods: The hydrophilicity before and after setting, as well as the contact angle values of the elastomeric impression materials were evaluated. Part I: A freshly extracted tooth, which was prepared for a full coverage restoration, was kept in saliva for 15 minutes and was then rinsed for 10 seconds.

Cement-retained versus screw-retained implant restorations: a critical review.

This article presents a comparison of screw-retained and cement-retained implant prostheses based on the literature. The advantages, disadvantages, and limitations of the 2 different types of restorations are discussed, because it is important to understand the influence of the attachment mechanism on many clinical aspects of implant dentistry. Several factors essential to the long-term success of any implant prosthesis were reviewed with regard to both methods of fixation.