From Bottle Caps to Frisbee-A Case Study on Mechanical Recycling of Plastic Waste towards a Circular Economy.

This study demonstrates an open-loop recycling process of a specific post-consumer plastic waste stream. The targeted input waste material was defined as high-density polyethylene beverage bottle caps. Two methods of waste collection, informal and formal, were employed.

Polypropylene Post-Consumer Recyclate Compounds for Thermoforming Packaging Applications.

Polypropylene (PP) plastic packaging waste consists of a variety of different plastic packaging products with a great span in rheological and mechanical behavior. Therefore, the resulting post-consumer recyclates usually show melt mass-flow rates (MFR) in the region of injection molding grades and intermediate mechanical properties. High-quality packaging applications demand a distinct property profile that is met by tailor-made PP grades and cannot be met by recyclates with intermediate performance.

Assessment of Commercially Available Polyethylene Recyclates for Blow Molding Applications by a Novel Environmental Stress Cracking Method.

The transition to a circular economy has a major impact on waste management and the reuse of materials. New mandatory recycling targets for plastics will lead to a high availability of recyclates. For these recyclates, useful applications need to be found.

Polypropylene Pipe Compounds with Varying Post-Consumer Packaging Recyclate Content.

The high recycling targets set by the European Commission will create an increased availability of polypropylene (PP) post-consumer recyclates (PCRs). However, no regulations mandate the use of recycled PP (rPP), so the industry is challenged to explore possibilities to utilize such materials. One option, as suggested by the European Commission, is the introduction of rPP in pipe applications.

Short- and Long-Term Performance of Pipe Compounds Containing Polyethylene Post-Consumer Recyclates from Packaging Waste.

The polymer industry is pushed to present solutions that lead to a circular plastics economy. High plastic packaging waste recycling targets will eventually lead to a high availability of packaging material recyclates. Although the use of polyethylene terephthalate (PET) recyclates is prescribed by regulations to be used in new PET bottles, no such regulation prescribes the use of polyethylene recyclate (rPE) in new products.

Characterization of Composition and Structure-Property Relationships of Commercial Post-Consumer Polyethylene and Polypropylene Recyclates.

The current efforts in moving closer towards a circular plastics economy puts massive pressure on recycled plastics, especially recycled polyethylene (rPE) and recycled polypropylene (rPP) to enter new markets. Their market penetration remained low so far, despite PE and PP constituting the largest share of plastic wastes. However, with the current imperative of more circularity comes a new focus on performance of recyclates.

Global and Local Aging in Differently Stabilized Polypropylenes Exposed to Hot Chlorinated Water with and without Superimposed Mechanical-Environmental Loads.

The influence of chlorinated water on the global and local aging behavior of polypropylene (PP) was investigated for three differently stabilized PP grades consisting of the same PP base polymer. While one of the PP grades contained only a processing stabilizer (PP-S0), the other two were modified with a primary phenolic antioxidant (PP-S1) and a combination of a primary phenolic antioxidant and a hindered amine stabilizer (PP-S3). To study global aging effects, micro-sized specimens were pre-exposed to chlorinated water (5 mg/L free chlorine) at 60 °C for up to 750 h.

Chlorinated Water Induced Aging of Pipe Grade Polypropylene Random Copolymers.

Polypropylene random copolymers (PP-R) are common materials for pressurized hot water pipes. In many pipe systems, potable water is disinfected by chlorine to prevent waterborne diseases. This paper deals with hot chlorinated water induced aging of two PP-R grades with varying morphology.