Radiative absorption enhancements by black carbon controlled by particle-to-particle heterogeneity in composition.

Black carbon (BC) absorbs solar radiation, leading to a strong but uncertain warming effect on climate. A key challenge in modeling and quantifying BC's radiative effect on climate is predicting enhancements in light absorption that result from internal mixing between BC and other aerosol components. Modeling and laboratory studies show that BC, when mixed with other aerosol components, absorbs more strongly than pure, uncoated BC; however, some ambient observations suggest more variable and weaker absorption enhancement.

The Cooling Rate- and Volatility-Dependent Glass-Forming Properties of Organic Aerosols Measured by Broadband Dielectric Spectroscopy.

Glass transitions of secondary organic aerosols (SOA) from liquid/semisolid to solid phase states have important implications for aerosol reactivity, growth, and cloud formation properties. In the present study, glass transition temperatures () of isoprene SOA components, including isoprene hydroxy hydroperoxide (ISOPOOH), isoprene-derived epoxydiols (IEPOX), 2-methyltetrols, and 2-methyltetrol sulfates, were measured at atmospherically relevant cooling rates (2-10 K/min) by thin film broadband dielectric spectroscopy. The results indicate that 2-methyltetrol sulfates have the highest glass transition temperature, while ISOPOOH has the lowest glass transition temperature.

Condensed-phase biogenic-anthropogenic interactions with implications for cold cloud formation.

Anthropogenic and biogenic gas emissions contribute to the formation of secondary organic aerosol (SOA). When present, soot particles from fossil fuel combustion can acquire a coating of SOA. We investigate SOA-soot biogenic-anthropogenic interactions and their impact on ice nucleation in relation to the particles' organic phase state.

Response to comment on "Radiative absorption enhancements due to the mixing state of atmospheric black carbon".

Jacobson argues that our statement that "many climate models may overestimate warming by BC" has not been demonstrated. Jacobson challenges our results on the basis that we have misinterpreted some model results, omitted optical focusing under high relative humidity conditions and by involatile components, and because our measurements consist of only two locations over short atmospheric time periods. We address each of these arguments, acknowledging important issues and clarifying some misconceptions, and stand by our observations.

Relationship between oxidation level and optical properties of secondary organic aerosol.

Brown carbon (BrC), which may include secondary organic aerosol (SOA), can be a significant climate-forcing agent via its optical absorption properties. However, the overall contribution of SOA to BrC remains poorly understood. Here, correlations between oxidation level and optical properties of SOA are examined.

Radiative absorption enhancements due to the mixing state of atmospheric black carbon.

Atmospheric black carbon (BC) warms Earth's climate, and its reduction has been targeted for near-term climate change mitigation. Models that include forcing by BC assume internal mixing with non-BC aerosol components that enhance BC absorption, often by a factor of ~2; such model estimates have yet to be clearly validated through atmospheric observations. Here, direct in situ measurements of BC absorption enhancements (E(abs)) and mixing state are reported for two California regions.

Transitions from functionalization to fragmentation reactions of laboratory secondary organic aerosol (SOA) generated from the OH oxidation of alkane precursors.

Functionalization (oxygen addition) and fragmentation (carbon loss) reactions governing secondary organic aerosol (SOA) formation from the OH oxidation of alkane precursors were studied in a flow reactor in the absence of NO(x). SOA precursors were n-decane (n-C10), n-pentadecane (n-C15), n-heptadecane (n-C17), tricyclo[5.2.

Low fractal dimension cluster-dilute soot aggregates from a premixed flame.

Using a novel morphology segregation technique, we observed minority populations ( approximately 3%) of submicron-sized, cluster-dilute fractal-like aggregates, formed in the soot-formation window (fuel-to-air equivalence ratio of 2.0-3.5) of a premixed flame, to have mass fractal dimensions between 1.

The spectroscopy and dynamics of microparticles.

The 137th Faraday Discussion covered a wide range of subjects divided into the four categories of Spectroscopic Techniques, Dusty Plasmas and X-Ray Characterization, Atmospheric Aerosols, and Particle Manipulation. These divisions organized the thinking into specific areas of research and allowed one to see interconnections between the two central foci of physical chemistry; techniques and applications. Physical chemists excel at developing and mastering a wide range of new techniques and applying them to a variety of tasks as the need arises.

Light scattering and absorption by fractal-like carbonaceous chain aggregates: comparison of theories and experiment.

This study compares the optical coefficients of size-selected soot particles measured at a wavelength of 870 nm with those predicted by three theories, namely, Rayleigh-Debye-Gans (RDG) approximation, volume-equivalent Mie theory, and integral equation formulation for scattering (IEFS). Soot particles, produced by a premixed ethene flame, were size-selected using two differential mobility analyzers in series, and their scattering and absorption coefficients were measured with nephelometry and photoacoustic spectroscopy. Scanning electron microscopy and image processing techniques were used for the parameterization of the structural properties of the fractal-like soot aggregates.

Heterogeneous uptake of 8-2 fluorotelomer alcohol on liquid water and 1-octanol droplets.

The heterogeneous uptake of the 8-2 fluorotelomer alcohol, F(CF2)8CH2CH2OH, on liquid water surfaces over the temperature range 256-273 K and on 1-octanol surfaces over the temperature range 264-295 K has been investigated with a droplet train flow reactor. The uptake coefficient on water droplets is zero within the error of the measurement (+/-0.01) and is independent of droplet temperature.