Comment on "Fast and accurate electromagnetic field calculation for substrate-supported metasurfaces using the discrete dipole approximation".

The article entitled "Fast and accurate electromagnetic field calculation for substrate-supported metasurfaces using the discrete dipole approximation (DDA)" written by W. Liu and E. McLeod presents a method for computing the Green function in presence of a substrate or multilayer in an efficient way.

Optics Determines the Electrochemiluminescence Signal of Bead-Based Immunoassays.

Electrochemiluminescence (ECL) is an optical readout technique that is successfully applied for the detection of biomarkers in body fluids using microbead-based immunoassays. This technology is of utmost importance for in vitro diagnostics and thus a very active research area but is mainly focused on the quest for new dyes and coreactants, whereas the investigation of the ECL optics is extremely scarce. Herein, we report the 3D imaging of the ECL signals recorded at single microbeads decorated with the ECL labels in the sandwich immunoassay format.

Dry mass photometry of single bacteria using quantitative wavefront microscopy.

Quantitative phase microscopy (QPM) represents a noninvasive alternative to fluorescence microscopy for cell observation with high contrast and for the quantitative measurement of dry mass (DM) and growth rate at the single-cell level. While DM measurements using QPM have been widely conducted on mammalian cells, bacteria have been less investigated, presumably due to the high resolution and high sensitivity required by their smaller size. This article demonstrates the use of cross-grating wavefront microscopy, a high-resolution and high-sensitivity QPM, for accurate DM measurement and monitoring of single microorganisms (bacteria and archaea).

Scalar approximation of Maxwell equations: derivation and accuracy.

Replacing Maxwell equations by a scalar wave equation is often used in computational imaging to simulate the light-sample interaction. It significantly reduces the computational burden but provides field maps that are insensitive to the polarization of the incident field, provided the latter is constant throughout the sample. Here, we develop a scalar approximation that accounts for the polarization of the incident field.

Three-dimensional imaging with reflection synthetic confocal microscopy.

Biomedical imaging lacks label-free microscopy techniques able to reconstruct the contour of biological cells in solution, in 3D and with high resolution, as required for the fast diagnosis of numerous diseases. Inspired by computational optical coherence tomography techniques, we present a tomographic diffractive microscope in reflection geometry used as a synthetic confocal microscope, compatible with this goal and validated with the 3D reconstruction of a human effector T lymphocyte.

Inverse scattering for reflection intensity phase microscopy.

Reflection phase imaging provides label-free, high-resolution characterization of biological samples, typically using interferometric-based techniques. Here, we investigate reflection phase microscopy from -only measurements under diverse illumination. We evaluate the forward and inverse scattering model based on the first Born approximation for imaging scattering objects above a glass slide.

Versatile inversion tool for phaseless optical diffraction tomography.

Estimating three-dimensional complex permittivity of a sample from the intensity recorded at the image plane of a microscope for various angles of illumination, as in optical Fourier ptychography microscopy, permits one to avoid the interferometric measurements of classical tomographic diffraction microscopes (TDMs). In this work, we present a general inversion scheme for processing intensities that can be applied to any microscope configuration (transmission or reflection, low or high numerical aperture), scattering regime (single or multiple scattering), or sample-holder geometries (with or without substrate). The inversion procedure is tested on a wide variety of synthetic experiments, and the reconstructions are compared to that of TDMs.

Numerical approach for reducing out-of-focus light in bright-field fluorescence microscopy and superresolution speckle microscopy.

The standard two-dimensional (2D) image recorded in bright-field fluorescence microscopy is rigorously modeled by a convolution process involving a three-dimensional (3D) sample and a 3D point spread function. We show on synthetic and experimental data that deconvolving the 2D image using the appropriate 3D point spread function reduces the contribution of the out-of-focus fluorescence, resulting in a better image contrast and resolution. This approach is particularly interesting for superresolution speckle microscopy, in which the resolution gain stems directly from the efficiency of the deconvolution of each speckle image.

Coherent anti-Stokes Raman Fourier ptychography.

We present a theoretical and numerical study of coherent anti-Stokes Raman scattering Fourier ptychography microscopy (CARS-FPM), a scheme that has not been considered so far in the previously reported CARS wide-field imaging schemes. In this approach, the distribution of the Raman scatterer density of the sample is reconstructed numerically from CARS images obtained under various angles of incidences of the pump or Stokes beam. Our inversion procedure is based on an accurate vectorial model linking the CARS image to the sample and yields both the real and imaginary parts of the susceptibility, the latter giving access to the Raman information, with an improved resolution.

Versatile inversion tool for phaseless optical diffraction tomography: publisher's note.

This publisher's note corrects a typo in the title of J. Opt. Soc.

Quantitative model of the image of a radiating dipole through a microscope.

In this paper, we introduce a formalism to determine the relationship between the full vectorial electric field existing at the object plane of a microscope and that existing at the image plane. The model is then used to quantitatively simulate, in both phase and intensity, the image of a radiating electric dipole placed either in a homogeneous medium or in the vicinity of a substrate. These simulations are compared with experimental measurements on single gold nanoparticles carried out by quadriwave lateral shearing interferometry.

Multi-wavelength multi-angle reflection tomography.

We have developed a reflection tomographic microscope in which the sample is reconstructed from different holograms recorded under various angles and wavelengths of incidence. We present an iterative inversion algorithm based on a rigorous modeling of the wave-sample interaction that processes all the data simultaneously to estimate the sample permittivity distribution. We show that using several wavelengths permits a significant improvement of the reconstruction, especially along the optical axis.

Two-photon speckle illumination for super-resolution microscopy.

We present a numerical study of a microscopy setup in which the sample is illuminated with uncontrolled speckle patterns and the two-photon excitation fluorescence is collected on a camera. We show that, using a simple deconvolution algorithm for processing the speckle low-resolution images, this wide-field imaging technique exhibits resolution significantly better than that of two-photon excitation scanning microscopy or one-photon excitation bright-field microscopy.

Phase imaging and synthetic aperture super-resolution via total internal reflection microscopy.

Total internal reflection microscopy is mainly used in its fluorescence mode and is the reference technique to image fluorescent proteins in the vicinity of cell membranes. Here, we show that this technique can easily become a phase microscope by simply detecting the coherent signal resulting from the interference between the field scattered by the probed sample and the total internal reflection. Moreover, combining several illumination angles permits generating synthetic aperture reconstructions with improved resolutions compared to standard label-free microscopy techniques.

Improving the axial and lateral resolution of three-dimensional fluorescence microscopy using random speckle illuminations.

We consider a fluorescence microscope in which several three-dimensional images of a sample are recorded for different speckle illuminations. We show, on synthetic data, that by summing the positive deconvolution of each speckle image, one obtains a sample reconstruction with axial and transverse resolutions that compare favorably to that of an ideal confocal microscope.

Superresolution with full-polarized tomographic diffractive microscopy.

Tomographic diffractive microscopy is a three-dimensional imaging technique that reconstructs the permittivity map of the probed sample from its scattered field, measured both in phase and in amplitude. Here, we detail how polarization-resolved measurements permit us to significantly improve the accuracy and the resolution of the reconstructions, compared to the conventional scalar treatments used so far. An isotropic transverse resolution of about 100 nm at a wavelength of 475 nm is demonstrated using this approach.

Discrete dipole approximation in time domain through the Laplace transform.

We present a form of the discrete dipole approximation for electromagnetic scattering computations in time domain. We show that the introduction of complex frequencies, through the Laplace transform, significantly improves the computation time. We also show that the Laplace transform and its inverse can be combined to extract the field inside a scatterer at a real resonance frequency.

High-resolution tomographic diffractive microscopy in reflection configuration.

Tomographic diffractive microscopy (TDM) is a label-free imaging technique that reconstructs the 3D refractive index map of the probed object with an improved resolution compared to confocal microscopy. In this work, we consider a TDM implementation in which the sample is deposited on a reflective substrate. We show that this configuration requires calibration and inversion procedures that account for the presence of the substrate for getting highly resolved quantitative reconstructions.

Electromagnetic forces on a discrete spherical invisibility cloak under time-harmonic illumination.

We study electromagnetic forces and torques on a discrete spherical invisibility cloak under time-harmonic illumination. We consider the influence of material absorption and losses, and we show that while the impact of absorption on the optical force remains confined to frequencies near the absorption peak, its impact on the electromagnetic torque experienced by the cloak is spectrally broader and follows the spectrum of the absorption cross section of the cloak. We also investigate the mechanical shielding of a test particle within the cloak.

Two-photon fluorescence isotropic-single-objective microscopy.

Two-photon excitation provides efficient optical sectioning in three-dimensional fluorescence microscopy, independently of a confocal detection. In two-photon laser-scanning microscopy, the image resolution is governed by the volume of the excitation light spot, which is obtained by focusing the incident laser beam through the objective lens of the microscope. The light spot being strongly elongated along the optical axis, the axial resolution is much lower than the transverse one.

Isotropic single-objective microscopy: theory and experiment.

Isotropic single-objective (ISO) microscopy is a recently proposed imaging technique that can theoretically exhibit the same axial and transverse resolutions as 4Pi microscopy while using a classical single-objective confocal microscope. This achievement is obtained by placing the sample on a mirror and shaping the illumination beam so that the interference of the incident and mirror-reflected fields yields a quasi-spherical spot. In this work, we model the image formation in the ISO fluorescence microscope and simulate its point spread function.

Discrete dipole approximation for time-domain computation of optical forces on magnetodielectric scatterers.

We present a general approach, based on the discrete dipole approximation (DDA), for the computation of the exchange of momentum between light and a magnetodielectric, three-dimensional object with arbitrary geometry and linear permittivity and permeability tensors in time domain. The method can handle objects with an arbitrary shape, including objects with dispersive dielectric and/or magnetic material responses.