Detection of volatile hydroperfluoroalkanes during hydrothermal liquefaction of perfluoroalkyl carboxylic acids at circumneutral pH.

Hydrothermal liquefaction (HTL) is a promising technology for converting wet organic waste such as sewage sludge into biocrude oil while simultaneously destroying per- and polyfluoroalkyl substances (PFAS). This study tracked the fate and degradation of six representative PFAS in water to address the effect of perfluoroalkyl chain length on degradation rates and the formation of volatile transformation products at 300-350 °C. While perfluorosulfonic acids were recalcitrant, perfluoroalkyl carboxylic acids (PFCAs) were rapidly and completely decarboxylated to hydroperfluoroalkanes (1 H-perfluoroheptane in the case of perfluorooctanoic acid).

Anaerobic digestion of wastewater from hydrothermal liquefaction of sewage sludge and combined wheat straw-manure.

Hydrothermal liquefaction (HTL) shows promise for converting wet biomass waste into biofuel, but the resulting high-strength process water (PW) requires treatment. This study explored enhancing energy recovery by anaerobic digestion using semi-batch reactors. Co-digesting manure with HTL-PW from wheat straw-manure co-HTL yielded methane (43-49% of the chemical oxygen demand, COD) at concentrations up to 17.

Is nitrification inhibition the bottleneck of integrating hydrothermal liquefaction in wastewater treatment plants?

Sewage sludge management poses challenges due to its environmental impact, varying composition, and stringent regulatory requirements. In this scenario, hydrothermal liquefaction (HTL) is a promising technology for producing biofuel and extracting phosphorus from sewage sludge. However, the toxic nature of the resulting process water (HTL-PW) raises concerns about integrating HTL into conventional wastewater treatment processes.

Wet oxidation of aqueous phase from hydrothermal liquefaction of sewage sludge.

Hydrothermal liquefaction (HTL) is a thermochemical process for the conversion of biomass into bio-crude oil. However, treatment of post-HTL aqueous by-products is an emerging issue towards the commercialisation of HTL technology. This study investigates the use of non-catalytic wet oxidation (WO) for the reduction of organic compounds and heat production at different temperatures (200-350 °C), residence times (RT) (2-180 min) and excess oxygen.

Hydrothermal liquefaction of sewage sludge; energy considerations and fate of micropollutants during pilot scale processing.

The beneficial use of sewage sludge for valorization of carbon and nutrients is of increasing interest while micropollutants in sludge are of concern to the environment and human health. This study investigates the hydrothermal liquefaction (HTL) of sewage sludge in a continuous flow pilot scale reactor at conditions expected to reflect future industrial installations. The processing is evaluated in terms of energy efficiency, bio-crude yields and quality.

Primary sewage sludge filtration using biomass filter aids and subsequent hydrothermal co-liquefaction.

Hydrothermal liquefaction (HTL) is a promising technology for biofuel production and treatment of wastewater sludge. The current study investigates a novel utilization of biomass-assisted filtration of primary sludge to obtain high dry matter (DM) content sludge. Drastic improvements in filtration speed are achieved using different types of lignocellulosic biomass filter aids prepared via mechanical pre-treatment.

Effect of hydrothermal liquefaction aqueous phase recycling on bio-crude yields and composition.

Hydrothermal liquefaction (HTL) is a promising thermo-chemical processing technology for the production of biofuels but produces large amounts of process water. Therefore recirculation of process water from HTL of dried distillers grains with solubles (DDGS) is investigated. Two sets of recirculation on a continuous reactor system using K2CO3 as catalyst were carried out.

Hydrothermal liquefaction of biomass: developments from batch to continuous process.

This review describes the recent results in hydrothermal liquefaction (HTL) of biomass in continuous-flow processing systems. Although much has been published about batch reactor tests of biomass HTL, there is only limited information yet available on continuous-flow tests, which can provide a more reasonable basis for process design and scale-up for commercialization. High-moisture biomass feedstocks are the most likely to be used in HTL.

Hydrothermal microwave processing of microalgae as a pre-treatment and extraction technique for bio-fuels and bio-products.

Microalgae are regarded as a promising source of lipids for bio-diesel production and bio-products. The current paper investigates the processing of microalgal slurries under controlled microwave irradiation. Microwave power was applied to reach temperatures of 80, 100, 120 and 140 °C at a constant residence time of 12 min.