Objectives: To digitally evaluate the trueness and fit of additively and subtractively manufactured fixed complete dentures in materials intended for definitive use.
Methods: An edentulous maxillary model with implants at the left first molar, left canine, right canine, and right first molar site was digitized and a fixed complete denture was designed. This design was used to fabricate fixed dentures in an additively manufactured resin for definitive use (AM), a high-impact polymer composite (SM-CR), and a strength gradient zirconia (SM-ZR) (n = 10).
Int J Biol Macromol
October 2024
The incorporation of active compounds into polymeric matrices using traditional methods has several drawbacks mainly due to the high volatility and thermal sensitivity of these substances. A solution to this problem could be the incorporation of bioactive compounds forming inclusion complexes as a strategy to improve the chemical stability, bioactivity and achieve controlled release. In this work, β-cyclodextrin/carvacrol inclusion complex was prepared by spray drying to be incorporated into poly(lactic acid) (PLA) and Mater-Bi® films by supercritical CO impregnation.
View Article and Find Full Text PDFFecal ostomy creation is a commonly performed procedure with many indications. Better outcomes occur when preoperative patient education and stoma site marking are provided. Despite a seemingly simple operation, ostomy creation is often difficult and complications are common.
View Article and Find Full Text PDFIntroduction: Vertical root fractures (VRFs) are among the most frequent causes of tooth loss, mainly of endodontically treated teeth. However, very few data is available about the occurrence of VRFs following apical surgery.
Methods: Patient charts from 864 patients with 1058 teeth treated with apical surgery (September 1999 to December 2018) were retrospectively evaluated, if a VRF had occurred after surgery.