Promoting dual careers at higher education institutions: 31 benefits ranked by the project Student Athletes Erasmus+ Mobility in Europe (SAMEurope).

Introduction: The project Student Athletes Erasmus+ Mobility in Europe identified and defined a total of 31 benefits offered to dual-career student athletes who are combining their university studies with high-level training. The project was co-funded by the European Union and carried out by five universities: Chalmers University of Technology (Sweden), Institut national des sciences appliquées de Lyon (France), University of Jyväskylä (Finland), Karlsruhe Institute of Technology (Germany), and Universitat Jaume I (Spain).

Methods: The purpose of the study was to rank these benefits by combining the perspectives of the university staff and the student athletes from each university in the consortium.

Calibrating torsional eigenmodes of micro-cantilevers for dynamic measurement of frictional forces.

Non-invasive thermal noise calibration of both torsional and flexural eigenmodes is performed on numerous cantilevers of 10 different types. We show that for all tipless and short-tipped cantilevers, the ratio of torsional to flexural mode stiffness is given by the ratio of their resonant frequency times a constant, unique to that cantilever type. By determining this constant, we enable a calibration of the torsional eigenmode, starting from a calibration of the flexural eigenmode.

Direct evidence of H7N7 avian influenza virus mutation from low to high virulence on a single poultry premises during an outbreak in free range chickens in the UK, 2008.

H5 and H7 subtypes of low pathogenicity avian influenza viruses (LPAIVs) have the potential to evolve into highly pathogenic avian influenza viruses (HPAIVs), causing high mortality in galliforme poultry with substantial economic losses for the poultry industry. This study provides direct evidence of H7N7 LPAIV mutation to HPAIV on a single poultry premises during an outbreak that occurred in June 2008 in free range laying hens in Oxfordshire, UK. We report the first detection of a rare di-basic cleavage site (CS) motif (PEIPKKRGLF), unique to galliformes, that has previously been associated with a LPAIV phenotype.

Probing nano-scale viscoelastic response in air and in liquid with dynamic atomic force microscopy.

We perform a comparative study of dynamic force measurements using an Atomic Force Microscope (AFM) on the same soft polymer blend samples in both air and liquid environments. Our quantitative analysis starts with calibration of the same cantilever in both environments. Intermodulation AFM (ImAFM) is used to measure dynamic force quadratures on the same sample.

From force curves to surface nanomechanical properties.

Surface science, which spans the fields of chemistry, physics, biology and materials science, requires information to be obtained on the local properties and property variations across a surface. This has resulted in the development of different scanning probe methods that allow the measurement of local chemical composition and local electrical and mechanical properties. These techniques have led to rapid advancement in fundamental science with applications in areas such as composite materials, corrosion protection and wear resistance.