Development and Stability Study of an Omeprazole Suppository for Infants.

Background And Objective: Omeprazole is a proton pump inhibitor (PPI) that is used in acid suppression therapy in infants. In this study we aimed to develop a pediatric omeprazole suppository, with good physical and chemical stability, suitable for pharmaceutical batch production.

Methods: The composition of the suppository consisted of omeprazole, witepsol H15 and arginine (L) base.

Rectal Omeprazole in Infants With Gastroesophageal Reflux Disease: A Randomized Pilot Trial.

Background And Objective: Omeprazole is a proton pump inhibitor that is used in acid suppression therapy in infants. Infants cannot swallow the oral tablets or capsules. Since, infants require a non-standard dose of omeprazole, the granules or tablets are often crushed or suspended in water or sodium bicarbonate, which may destroy the enteric coating.

Capillary electrophoretic bioanalysis of therapeutically active peptides with UV and mass spectrometric detection after on-capillary preconcentration.

An earlier developed capillary electrophoresis (CE) system with an on-capillary adsorptive phase is investigated for its suitability to quantitate low concentrations of angiotensin II and gonadorelin in plasma. An off-line solid-phase extraction is used for sample preparation. The on-line preconcentration CE system allows multiple capillary volumes of sample solution to be injected, increasing the concentration sensitivity of CE with 3-4 orders of magnitude.

Robust and cost-effective capillary electrophoresis-mass spectrometry interfaces suitable for combination with on-line analyte preconcentration.

This paper describes several successful cost-effective attempts to couple capillary electrophoresis (CE) and mass spectrometry (MS) without make-up flow or nebulizing gas. An in-depth analysis of several interfaces using conductive spray tips was performed as well as an easy-to-prepare T-junction with direct electrode contact, the latter being the most robust interface. No coating is necessary and the spray voltage is applied through a gold wire positioned at the gap between the separation and spray capillaries.