Optimization of chromium (VI) reduction in aqueous solution using magnetic Fe3O4 sludge resulting from electrocoagulation process.

The reuse of electro-coagulated sludge as an adsorbent for Cr(VI) ion reduction was investigated in this study. Electro-coagulated sludge was obtained during the removal of citric acid wastewater by the electrocoagulation process. The following parameters were optimized for Cr(VI) reduction: pH (5-7), initial Cr(VI) concentration (10-50 mg/L), contact time (10-45 min), and adsorbent dosage (0.

A combined process of chemical precipitation and aerobic membrane bioreactor for treatment of citric acid wastewater.

The wastewater generated from citric acid production has a high organic loading content. The treatment and reuse of citric acid wastewater with high organic loading become extremely important. In this study, the performance of calcium hydroxide (Ca(OH)) precipitation as a low-cost and environmentally friendly pre-treatment method and aerobic membrane bioreactor (MBR) combined treatment system was investigated for the treatment of citric acid (CA) wastewater.

Optimization of the anaerobic fermentation process for phosphate release using food waste.

Phosphorus (P) problem worries the whole world due to the increasing demand for finite and non-renewable natural phosphate resources and the inadequacy of sustainable phosphate production technologies. In this study, bio-acidification processes using waste sludge and food waste for simultaneous sustainable phosphate release and biogas production were investigated. Response surface methodology (RSM) was used for bio-acidification optimization.

An integrated process for wet scrubber wastewater treatment using electrooxidation and pressure-driven membrane filtration.

In this study, the electrooxidation (EO) and membrane processes were used for chemical oxygen demand (COD) and total phenol (TPh) removal from wet scrubber wastewater (WSW). EO experiments were carried out using Al, Fe, SS, Ti, graphite, active carbon cloth electrodes and Box-Behnken design were used for optimization of maximum COD and TPh removal efficiency. Moreover, membrane filtration experiments were conducted to EO process using nanofiltration (NF270) and reverse osmosis membranes (SW30 and BW30).