Multi-element determination in some foods and beverages using silica gel modified with 1-phenylthiosemicarbazide.

1-Phenylthiosemicarbazide bonded modified silica gel (PTC-SG) was synthesised and characterised by FTIR, SEM and elemental analysis for a novel separation/preconcentration of multiple elements based on solid phase extraction. The analytical parameters including pH of solutions, amounts of PTC-SG, flow rates of sample, eluent type and sample volume were optimised. The adsorption capacities of PTC-SG were found to be 7.

A simple, rapid and green ultrasound assisted and ionic liquid dispersive microextraction procedure for the determination of tin in foods employing ETAAS.

This paper proposes a simple, rapid and green ultrasound assisted and ionic liquid dispersive microextraction procedure using pyrocatechol violet (PV) as complexing reagent and 1-hexyl-3-methylimidazolium bis(trifluoromethylsulfonyl)-imide [CMIM][TfN] as ionic liquid for the detection of tin employing electrothermal atomic absorption spectrometry (ETAAS). The optimization step was performed using a two-level full factorial design involving the following factors: pH of the working media, amount reagents, ionic liquid volume and extraction time and the chemometric response was tin recovery. The procedure allowed the determination of tin with limits of detection and quantification of 3.

A new separation and preconcentration method for selenium in some foods using modified silica gel with 2,6-diamino-4-phenil-1,3,5-triazine.

A novel and simple solid phase extraction method was improved and recommended for selenium. Silica gel was modified with 2,6-diamino-4-phenil-1,3,5-triazine and characterized by FTIR, SEM and elemental analysis and used adsorbent for column solid phase extraction of selenium ions. The experimental parameters (pH, flow rates, amounts of the modified silica gel, concentration and type of eluent, volume of sample, etc.

Honeybees and honey as monitors for heavy metal contamination near thermal power plants in Mugla, Turkey.

In the present work, 6 honeydew samples of known geographical and botanical origins and 11 honeybee samples were analyzed to detect possible contamination by the thermoelectric power plants in Mugla, Turkey. The contents of trace elements were determined by atomic absorption spectrometry after application of microwave digestion. The samples from the thermal power plants, which were 10-22 km away from the hives, that did not cause pollution in honeydew honeys were also analyzed.

Determination of As(III) and As(V) species in some natural water and food samples by solid-phase extraction on Streptococcus pyogenes immobilized on Sepabeads SP 70 and hydride generation atomic absorption spectrometry.

The speciation of arsenic(III) and arsenic(V) by using Streptococcus pyogenes immobilized on Sepabeads SP 70 resin has been investigated with solid-phase extraction method. The arsenic levels were determined hydride generation atomic absorption spectrometry (HGAAS) in sample solutions. The procedure presented based on quantitative recoveries of As(III) as >95%.

Coprecipitation of trace elements with Ni2+/2-Nitroso-1-naphthol-4-sulfonic acid and their determination by flame atomic absorption spectrometry.

Ni(2+)/2-Nitroso-1-naphthol-4-sulfonic acid precipitate was used for the coprecipitation of Co, Pb, Cu, Fe and Zn prior to their flame atomic absorption spectrometric (FAAS) determinations in environmental samples. The precipitate could be easily dissolved with concentrated nitric acid. The recovery values for analyte ions were higher than 95%.

3-Ethyl-4-(p-chlorobenzylidenamino-4,5-dihydro-1H-1,2,4-triazol-5-one (EPHBAT) as precipitant for carrier element free coprecipitation and speciation of chromium(III) and chromium(VI).

A method for the separation and speciative determination of Cr(VI) and Cr(III) has been developed. The procedure is based on coprecipitation of Cr(III) on 3-ethyl-4-(p-chlorobenzylidenamino-4,5-dihydro-1H-1,2,4-triazol-5-one (EPHBAT) without carrier element. The Cr(III) can be selectively precipitated on EPHBAT in the pH range of 8.

Speciation and separation of Cr(VI) and Cr(III) using coprecipitation with Ni2+/2-Nitroso-1-naphthol-4-sulfonic acid and determination by FAAS in water and food samples.

A speciation procedure for chromium(III) and chromium(VI) in the water and food samples has been established in the presented work. The procedure presented based on quantitative recoveries of Cr(III)>95% using coprecipitation of Ni(2+)/2-Nitroso-1-naphthol-4-sulfonic acid. The total chromium was measured after reduction of Cr(VI) by concentrated H(2)SO(4) and ethanol.

Mercury(II) and methyl mercury speciation on Streptococcus pyogenes loaded Dowex Optipore SD-2.

A solid phase extraction procedure based on speciation of mercury(II) and methyl mercury on Streptococcus pyogenes immobilized on Dowex Optipore SD-2 has been established. Selective and sequential elution with 0.1 mol L(-1) HCl for methyl mercury and 2 mol L(-1) HCl for mercury(II) were performed at pH 8.

Investigation of the levels of some element in edible oil samples produced in Turkey by atomic absorption spectrometry.

The element contents (Fe, Mn, Zn, Cu, Pb, Co, Cd, Na, K, Ca and Mg) in edible oils (olive oil, hazelnut oil, sunflower oil, margarine, butter and corn oil) from Turkey were determined using atomic absorption spectrometry after microwave digestion. The concentrations of trace element in the samples were found to be 291.0-52.

Characterization of biosorption process of As(III) on green algae Ulothrix cylindricum.

Arsenic (As) is generally found as As(III) and As(V) in environmental samples. Toxicity of As(III) is higher than As(V). This paper presents the characteristics of As(III) biosorption from aqueous solution using the green algae (Ulothrix cylindricum) biomass as a function of pH, biomass dosage, contact time, and temperature.

Assessment of trace element contents of chicken products from Turkey.

Due to the consumption of chicken and chicken products in Turkey at high ratio, trace metal content of chicken and chicken products from Turkey were determined by atomic absorption spectrometry after microwave digestion. The accuracy of the method was confirmed by analysis of standard reference material (NIST SRM 1577b Bovine liver). Trace element content in various parts of chicken samples and chicken products were to be in the range of 0.

Assessment of trace element levels in Rhododendron honeys of Black Sea Region, Turkey.

Rhododendron and multi-flower honeys obtained from Black Sea Region of Turkey (12 Rhododendron and 8 multi-flower honeys) were studied to determine the presence of the 14 trace elements such as Cu, Cd, Pb, Co, Cr, Ni, Al, Se, Zn, Mn, Fe, K, Ca and Mg. Trace element determination was performed by atomic absorption spectrometry (AAS) after microwave digestion. The results revealed that Rhododendron honeys exhibited higher concentrations of Cu, Co, Cr, Ni, Se, Zn, Ca and Mg but lower concentrations of Al, Mn, Fe and K than in the multi-flower honeys.

Biosorption of Pb(II) and Cr(III) from aqueous solution by lichen (Parmelina tiliaceae) biomass.

The biosorption characteristics of Pb(II) and Cr(III) ions from aqueous solution using the lichen (Parmelina tiliaceae) biomass were investigated. Optimum biosorption conditions were determined as a function of pH, biomass dosage, contact time, and temperature. Langmuir, Freundlich and Dubinin-Radushkevich (D-R) models were applied to describe the biosorption isotherm of the metal ions by P.

Trace metal levels in lichen samples from roadsides in East Black Sea region, Turkey.

Objective: To determine the metal contents of lichen species from East Black Sea region of Turkey for investigation of trace metal pollution sourced traffic.

Methods: The levels of copper, cadmium, lead, zinc, manganese, iron, chromium, nickel, cobalt, palladium in lichen samples collected from East Black Sea region of Turkey were determined by flame and graphite furnace atomic absorption spectrometry after microwave digestion method. The accuracy of the method was corrected by standard reference material (NIST SRM IAEA-336 Lichen).

Biosorption of copper(II), lead(II), iron(III) and cobalt(II) on Bacillus sphaericus-loaded Diaion SP-850 resin.

The biosorption of copper(II), lead(II), iron(III) and cobalt(II) on Bacillus sphaericus-loaded Diaion SP-850 resin for preconcentration-separation of them have been investigated. The sorbed analytes on biosorbent were eluted by using 1 mol L(-1) HCl and analytes were determined by flame atomic absorption spectrometry. The influences of analytical parameters including amounts of pH, B.

Cr(VI) and Cr(III) speciation on Bacillus sphaericus loaded diaion SP-850 resin.

A speciation procedure for chromium(III) and chromium(VI) in the environmental samples has been established in the presented work. The procedure presented based on quantitative biosorption of chromium(III) on Bacillus sphaericus loaded Diaion SP-850 at pH 5. The Cr(VI) recoveries at pH 5 were below 5% on the biosorbent.