Polystyrene Thin Films Nanostructuring by UV Femtosecond Laser Beam: From One Spot to Large Surface.

In this work, direct irradiation by a Ti:Sapphire (100 fs) femtosecond laser beam at third harmonic (266 nm), with a moderate repetition rate (50 and 1000 Hz), was used to create regular periodic nanostructures upon polystyrene (PS) thin films. Typical Low Spatial Frequency LIPSSs (LSFLs) were obtained for 50 Hz, as well as for 1 kHz, in cases of one spot zone, and also using a line scanning irradiation. Laser beam fluence, repetition rate, number of pulses (or irradiation time), and scan velocity were optimized to lead to the formation of various periodic nanostructures.

Periodic TiO₂ Nanostructures with Improved Aspect and Line/Space Ratio Realized by Colloidal Photolithography Technique.

This paper presents substantial improvements of the colloidal photolithography technique (also called microsphere lithography) with the goal of better controlling the geometry of the fabricated nano-scale structures-in this case, hexagonally arranged nanopillars-printed in a layer of directly photopatternable sol-gel TiO₂. Firstly, to increase the achievable structure height the photosensitive layer underneath the microspheres is deposited on a reflective layer instead of the usual transparent substrate. Secondly, an increased width of the pillars is achieved by tilting the incident wave and using multiple exposures or substrate rotation, additionally allowing to better control the shape of the pillar's cross section.

Elaboration and surface modification of structured poly(L-lactic acid) thin film on various substrates.

Biosourced or biodegradable polymers like poly(lactic acid) (PLA) are often base-material for tissue-engineered scaffolds. However, in most of the cases, their bioadhesion properties are not satisfactory. Since the adhesion is controlled both by roughness and surface chemistry, PLA films were textured by applying the breath figure procedure and, then, plasma-treated.