Strain induced electrochemical behaviors of ionic liquid electrolytes in an electrochemical double layer capacitor: Insights from molecular dynamics simulations.

Electrochemical Double Layer Capacitors (EDLCs) with ionic liquid electrolytes outperform conventional ones using aqueous and organic electrolytes in energy density and safety. However, understanding the electrochemical behaviors of ionic liquid electrolytes under compressive/tensile strain is essential for the design of flexible EDLCs as well as normal EDLCs, which are subject to external forces during assembly. Despite many experimental studies, the compression/stretching effects on the performance of ionic liquid EDLCs remain inconclusive and controversial.

Silicon-Based Solid-State Batteries: Electrochemistry and Mechanics to Guide Design and Operation.

Solid-state batteries (SSBs) are promising alternatives to the incumbent lithium-ion technology; however, they face a unique set of challenges that must be overcome to enable their widespread adoption. These challenges include solid-solid interfaces that are highly resistive, with slow kinetics, and a tendency to form interfacial voids causing diminished cycle life due to fracture and delamination. This modeling study probes the evolution of stresses at the solid electrolyte (SE) solid-solid interfaces, by linking the chemical and mechanical material properties to their electrochemical response, which can be used as a guide to optimize the design and manufacture of silicon (Si) based SSBs.

Lithium-Ion Battery Degradation: Measuring Rapid Loss of Active Silicon in Silicon-Graphite Composite Electrodes.

To increase the specific energy of commercial lithium-ion batteries, silicon is often blended into the graphite negative electrode. However, due to large volumetric expansion of silicon upon lithiation, these silicon-graphite (Si-Gr) composites are prone to faster rates of degradation than conventional graphite electrodes. Understanding the effect of this difference is key to controlling degradation and improving cell lifetimes.

Large scale immersion bath for isothermal testing of lithium-ion cells.

Testing of lithium-ion batteries depends greatly on accurate temperature control in order to generate reliable experimental data. Reliable data is essential to parameterise and validate battery models, which are essential to speed up and reduce the cost of battery pack design for multiple applications. There are many methods to control the temperature of cells during testing, such as forced air convection, liquid cooling or conduction cooling using cooling plates.

A novel use for the biodegradable temporizing matrix.

Unlabelled: Biodegradable Temporising Matrix (BTM), a skin substitute, has been recently developed as a novel adjunct to the plastic surgeon's reconstructive repertoire. Its use has been described in literature in a variety of settings and complex wounds, including those that previously would have been described as "non-graftable", with favourable outcomes. We present the case of a patient with a wound to the right foot and ankle following extravasation injury.

Lithium-ion battery degradation: how to model it.

Predicting lithium-ion battery degradation is worth billions to the global automotive, aviation and energy storage industries, to improve performance and safety and reduce warranty liabilities. However, very few published models of battery degradation explicitly consider the interactions between more than two degradation mechanisms, and none do so within a single electrode. In this paper, the first published attempt to directly couple more than two degradation mechanisms in the negative electrode is reported.

Mechanical behaviour of inorganic solid-state batteries: can we model the ionic mobility in the electrolyte with Nernst-Einstein's relation?

Inorganic solid-state lithium-metal batteries could be the next-generation batteries owing to their non-flammability and higher specific energy density. Many research efforts have been devoted to improving the ionic conductivity of inorganic solid electrolytes. For a wide range of electrolytes including liquid and solid polymer electrolytes, an independent measurement or calculation of both electrolyte conductivity and diffusion coefficient is often time-consuming and challenging.

Financial viability of electric vehicle lithium-ion battery recycling.

Economically viable electric vehicle lithium-ion battery recycling is increasingly needed; however routes to profitability are still unclear. We present a comprehensive, holistic techno-economic model as a framework to directly compare recycling locations and processes, providing a key tool for recycling cost optimization in an international battery recycling economy. We show that recycling can be economically viable, with cost/profit ranging from (-21.

In Rheumatoid Arthritis Patients, HLA-DRB1*04:01 and Rheumatoid Nodules Are Associated With ACPA to a Particular Fibrin Epitope.

Objectives: Rheumatoid arthritis (RA) is associated with HLA-DRB1 genes encoding the shared epitope (SE), a 5-amino acid motive. RA is usually preceded by the emergence of anti-citrullinated protein/peptide antibodies (ACPAs). Citrulline is a neutral amino acid resulting from post-translational modification of arginine involved in peptidic bounds (arginyl residue) by PeptidylArginine Deiminases (PADs).

Lithium ion battery degradation: what you need to know.

The expansion of lithium-ion batteries from consumer electronics to larger-scale transport and energy storage applications has made understanding the many mechanisms responsible for battery degradation increasingly important. The literature in this complex topic has grown considerably; this perspective aims to distil current knowledge into a succinct form, as a reference and a guide to understanding battery degradation. Unlike other reviews, this work emphasises the coupling between the different mechanisms and the different physical and chemical approaches used to trigger, identify and monitor various mechanisms, as well as the various computational models that attempt to simulate these interactions.

The Location and Rate of the Phosphate Release Step in the Muscle Cross-Bridge Cycle.

It is controversial whether the phosphate (Pi) release step in the cross-bridge cycle occurs before or after the first tension-generating step and whether it is fast or slow. We have therefore modified our previous model of the frog cross-bridge cycle by including a Pi release step either before (model A) or after (model B) the first tension-generating step and refined the two models by downhill simplex runs against experimental data for the force-velocity relation and the tension transients after length steps. Pi release step was initially made slow (70 s), but after refinement, it became fast (∼500 s for model A and ∼6000 s for model B).

Experimental and numerical analysis to identify the performance limiting mechanisms in solid-state lithium cells under pulse operating conditions.

Solid-state lithium batteries could reduce the safety concern due to thermal runaway while improving the gravimetric and volumetric energy density beyond the existing practical limits of lithium-ion batteries. The successful commercialisation of solid-state lithium batteries depends on understanding and addressing the bottlenecks limiting the cell performance under realistic operational conditions such as dynamic current profiles of different pulse amplitudes. This study focuses on experimental analysis and continuum modelling of cell behaviour under pulse operating conditions, with most model parameters estimated from experimental measurements.

Degradation of thin-film lithium batteries characterised by improved potentiometric measurement of entropy change.

The degradation phenomena of thin-film solid state batteries caused by cycling at a high cut-off voltage and different temperatures were studied using an improved potentiometric measurement of entropy change combined with electrochemical impedance analysis and incremental capacity analysis. Entropy profiling is demonstrated as a viable non-destructive technique for solid state batteries that is sensitive to structural changes in electrodes during galvanostatic cycling, and is complementary to other techniques for studying degradation. The characteristic peaks and valleys in the entropy profile as a function of the state-of-charge could be closely correlated to theories of phase transitions in the cathode material.

Chest wall resection and reconstruction for Rosai-Dorfman disease masquerading as a chest wall sarcoma.

Rosai-Dorfman disease (RDD) is a rare benign histiocytic proliferative disease that can present as a pseudotumour of soft tissue. We describe the first chest wall resection and reconstruction.

The force-generation process in active muscle is strain sensitive and endothermic: a temperature-perturbation study.

In experiments on active muscle, we examined the tension decline and its temperature sensitivity at the onset of ramp shortening and at a range of velocities. A segment (∼1.5 mm long) of a skinned muscle fibre isolated from rabbit psoas muscle was held isometrically (sarcomere length ∼2.

Potentiometric measurement of entropy change for lithium batteries.

Effective thermal management and tracking of battery degradation are two key challenges in the improved management of battery packs. Entropy change measurement is a non-destructive tool for characterizing both the thermal and structural properties of lithium batteries. However, conventional entropy measurements based on discontinuous potentiometric methods are too time-consuming for practical implementation in battery packs.

The atomistic structure of yttria stabilised zirconia at 6.7 mol%: an ab initio study.

Yttria stabilized zirconia (YSZ) is an important oxide ion conductor used in solid oxide fuel cells, oxygen sensing devices, and for oxygen separation. Doping pure zirconia (ZrO) with yttria (YO) stabilizes the cubic structure against phonon induced distortions and this facilitates high oxide ion conductivity. The local atomic structure of the dopant is, however, not fully understood.

Reinterpretation of the Tension Response of Muscle to Stretches and Releases.

We have reexamined the experimental time courses of tension in frog muscle after rapid length steps. The early tension recoveries are biexponential. After 3 nm/hs stretches and releases, the rates of the immediate rapid tension changes are similar but the subsequent tension fall after a stretch is much slower than the rise after a release.

A zero dimensional model of lithium-sulfur batteries during charge and discharge.

Lithium-sulfur cells present an attractive alternative to Li-ion batteries due to their large energy density, safety, and possible low cost. Their successful commercialisation is dependent on improving their performance, but also on acquiring sufficient understanding of the underlying mechanisms to allow for the development of predictive models for operational cells. To address the latter, we present a zero dimensional model that predicts many of the features observed in the behaviour of a lithium-sulfur cell during charge and discharge.

Modeling the voltage loss mechanisms in lithium-sulfur cells: the importance of electrolyte resistance and precipitation kinetics.

Understanding of the complex electrochemical, transport, and phase-change phenomena in Li-S cells requires experimental characterization in tandem with mechanistic modeling. However, existing Li-S models currently contradict some key features of experimental findings, particularly the evolution of cell resistance during discharge. We demonstrate that, by introducing a concentration-dependent electrolyte conductivity, the correct trends in voltage drop due to electrolyte resistance and activation overpotentials are retrieved.

Chemical Descriptors of Yttria-Stabilized Zirconia at Low Defect Concentration: An ab Initio Study.

Yttria-stabilized zirconia (YSZ) is an important oxide ion conductor with applications in solid oxide fuel cells (SOFCs) and oxygen sensing devices. Doping the cubic phase of zirconia (c-ZrO2) with yttria (Y2O3) is isoelectronic, as two Zr(4+) ions are replaced by two Y(3+) ions, plus a charge compensating oxygen vacancy (Ovac). Typical doping concentrations include 3, 8, 10, and 12 mol %.

In-operando high-speed tomography of lithium-ion batteries during thermal runaway.

Prevention and mitigation of thermal runaway presents one of the greatest challenges for the safe operation of lithium-ion batteries. Here, we demonstrate for the first time the application of high-speed synchrotron X-ray computed tomography and radiography, in conjunction with thermal imaging, to track the evolution of internal structural damage and thermal behaviour during initiation and propagation of thermal runaway in lithium-ion batteries. This diagnostic approach is applied to commercial lithium-ion batteries (LG 18650 NMC cells), yielding insights into key degradation modes including gas-induced delamination, electrode layer collapse and propagation of structural degradation.

IgM and IgA rheumatoid factors purified from rheumatoid arthritis sera boost the Fc receptor- and complement-dependent effector functions of the disease-specific anti-citrullinated protein autoantibodies.

Rheumatoid factors (RF) and the disease-specific anti-citrullinated protein autoantibodies (ACPA) coexist in the joints of rheumatoid arthritis (RA) patients where they probably contribute to synovitis. We investigated the influence of IgM and IgA RF on the FcR- and complement-dependent effects of ACPA immune complexes (ACPA-IC). When stimulated by ACPA-IC formed in the presence of IgM RF or IgA RF fractions purified from RA serum pools, M-CSF-generated macrophages skewed their cytokine response toward inflammation, with increases in the TNF-α/IL-10 ratio and in IL-6 and IL-8 secretion, and decreases in the IL-1Ra/IL-1β ratio.

The endothermic ATP hydrolysis and crossbridge attachment steps drive the increase of force with temperature in isometric and shortening muscle.

The isometric tetanic tension of skeletal muscle increases with temperature because attached crossbridge states bearing a relatively low force convert to those bearing a higher force. It was previously proposed that the tension-generating step(s) in the crossbridge cycle was highly endothermic and was therefore itself directly targeted by changes in temperature. However, this did not explain why a rapid rise in temperature (a temperature jump) caused a much slower rate of rise of tension than a rapid length step.