Is It Possible To Develop Complex S-Se Graded Band Gap Profiles in Kesterite-Based Solar Cells?

This work presents the development of a novel chalcogenization process for the fabrication of CuZnSn(S,Se) (CZTSSe or kesterite)-based solar cells that enable the generation of sharp graded anionic compositional profiles with high S content at the top and low S content at the bottom. This is achieved through the optimization of the annealing parameters including the study of several sulfur sources with different predicted reactivities (elemental S, thiourea, SnS, and SeS). As a result, depending on the sulfur source employed, devices with superficially localized maximum sulfur content between 50 and 20% within the charge depletion zone and between 10 and 30% toward the bulk material are obtained.

CuZnSn(S,Se) thin-films prepared from selenized nanocrystals ink.

For the first time, CZTS ink was formulated using low-temperature heating up synthesis of NCs. Besides, the influence of powder concentration on the properties of the films was examined. Subsequently, the CZTS films were annealed under a selenium (Se)/argon (Ar) atmosphere at different temperatures to enhance their properties.

Development of a selective chemical etch to improve the conversion efficiency of Zn-rich Cu2ZnSnS4 solar cells.

Improvement of the efficiency of Cu(2)ZnSnS(4) (CZTS)-based solar cells requires the development of specific procedures to remove or avoid the formation of detrimental secondary phases. The presence of these phases is favored by the Zn-rich and Cu-poor conditions that are required to obtain device-grade layers. We have developed a selective chemical etching process based on the use of hydrochloric acid solutions to remove Zn-rich secondary phases from the CZTS film surface, which are partly responsible for the deterioration of the series resistance of the cells and, as a consequence, the conversion efficiency.