Toward a Physiologically Relevant 3D Helicoidal-Oriented Cardiac Model: Simultaneous Application of Mechanical Stimulation and Surface Topography.

Myocardium consists of cardiac cells that interact with their environment through physical, biochemical, and electrical stimulations. The physiology, function, and metabolism of cardiac tissue are affected by this dynamic structure. Within the myocardium, cardiomyocytes' orientations are parallel, creating a dominant orientation.

Multimaterial Nanoporous Membranes Shaped through High Aspect-Ratio Sacrificial Silicon Nanostructures.

We present an innovative fabrication method for solid-state nanoporous membranes based on the casting of sacrificial silicon nanostructures. The process allows the individual definition of geometry and placement of each nanopore through e-beam lithography and is compatible with a wide range of materials without the need to adapt the process to the materials used. We demonstrate the fabrication of membranes integrating high aspect-ratio nanopores with critical dimensions as small as 30 nm, 1.

Ultra-soft cantilevers and 3-D micro-patterned substrates for contractile bundle tension measurement in living cells.

Actin-myosin microfilament bundles or stress-fibers are the principal tension-generating structures in the cell. Their mechanical properties are critical for cell shape, motion, and interaction with other cells and extracellular matrix, but were so far difficult to access in a living cell. Here we propose a micro-fabricated two-component setup for direct tension measurement on a peripheral bundle within an intact cell.

Contact angle at the leading edge controls cell protrusion rate.

Plasma membrane tension and the pressure generated by actin polymerization are two antagonistic forces believed to define the protrusion rate at the leading edge of migrating cells [1-5]. Quantitatively, resistance to actin protrusion is a product of membrane tension and mean local curvature (Laplace's law); thus, it depends on the local geometry of the membrane interface. However, the role of the geometry of the leading edge in protrusion control has not been yet investigated.

Separation of platelets from other blood cells in continuous-flow by dielectrophoresis field-flow-fractionation.

We present a microfluidic device capable of separating platelets from other blood cells in continuous flow using dielectrophoresis field-flow-fractionation. The use of hydrodynamic focusing in combination with the application of a dielectrophoretic force allows the separation of platelets from red blood cells due to their size difference. The theoretical cell trajectory has been calculated by numerical simulations of the electrical field and flow speed, and is in agreement with the experimental results.

Continuous-flow electrical lysis device with integrated control by dielectrophoretic cell sorting.

We present a device capable of electrical cell lysis and evaluation of lysis efficiency in continuous flow using dielectrophoretic cell sorting. We use a combination of AC electrical fields and so-called liquid electrodes to avoid bubble creation at the electrode surface. The electrical field distribution is calculated in different electrode configurations by numerical simulations.

Blood cell counting by means of impedance measurements in a microsystem device.

This paper presents an innovative, portable and low power blood cell counter, based on micro-electro-mechanical-systems (MEMS) technology. It was realized by designing and developing a custom impedance measurement circuit, which drives an electro-fluidic microsystem, providing a parallel, multi-channel Coulter counter. A method for a reliable, easy, and low-cost interfacing to such kind of micro-devices, allowing both fluidic and electric coupling, is also shown.