Atomic-Scale Surface Segregation in Copper-Gold Nanoparticles.

We combine electron microscopy measurements of the surface compositions in Cu-Au nanoparticles and atomistic simulations to investigate the effect of gold segregation. While this mechanism has been extensively investigated within Cu-Au in the bulk state, it was never studied at the atomic level in nanoparticles. By using energy dispersive x-ray analysis across the (100) and (111) facets of nanoparticles, we provide evidence of gold segregation in Cu_{3}Au and CuAu_{3} nanoparticles in the 10 nm size range grown by epitaxy on a salt surface with high control of the nanoparticles morphology.

Synthesis and structural properties of high-entropy nanoalloys made by physical and chemical routes.

The development of synthesis methods with enhanced control over the composition, size and atomic structure of High Entropy Nano-Alloys (HENA) could give rise to a new repertoire of nanomaterials with unprecedented functionalities, notably for mechanical, catalytic or hydrogen storage applications. Here, we have developed two original synthesis methods, one by a chemical route and the other by a physical one, to fabricate HENA with a size between 3 and 10 nm and a face centered cubic structure containing three (CoNiPt), four (CoNiPtCu and CoNiPtAu) or five (CoNiPtAuCu) metals close to the equiatomic composition. The key point in the proposed chemical synthesis method is to compensate the difference in reactivity of the different metal precursors by increasing the synthesis temperature using high boiling solvents.

Cu segregation in Au-Cu nanoparticles exposed to hydrogen atmospheric pressure: how is fcc symmetry maintained?

In a recent work [A. Nassereddine 2021, , 2104571] we reported the atomic-scale structure and dynamics of sub-4 nm sized Au nanoparticles (NPs) supported on titania in H at atmospheric pressure obtained by using aberration-corrected environmental transmission electron microscopy (ETEM), density functional theory (DFT) optimizations and molecular dynamic (AIMD) simulations. Our results showed unstable Au NPs losing their face-centred cubic (fcc) symmetry (from fcc to non-fcc symmetries) and revealed the drastic effect of hydrogen adsorption.

Revealing Size Dependent Structural Transitions in Supported Gold Nanoparticles in Hydrogen at Atmospheric Pressure.

The enhancement of the catalytic activity of gold nanoparticles with their decreasing size is often attributed to the increasing proportion of low-coordinated surface sites. This correlation is based on the paradigmatic picture of working gold nanoparticles as perfect crystal forms having complete and static outer surface layers whatever their size. This picture is incomplete as catalysts can dynamically change their structure according to the reaction conditions and as such changes can be eventually size-dependent.

Quantitative In Situ Visualization of Thermal Effects on the Formation of Gold Nanocrystals in Solution.

Understanding temperature effects in nanochemistry requires real-time in situ measurements because this key parameter of wet-chemical synthesis simultaneously influences the kinetics of chemical reactions and the thermodynamic equilibrium of nanomaterials in solution. Here, temperature-controlled liquid cell transmission electron microscopy is exploited to directly image the radiolysis-driven formation of gold nanoparticles between 25 °C and 85 °C and provide a deeper understanding of the atomic-scale processes determining the size and shape of gold colloids. By quantitatively comparing the nucleation and growth rates of colloidal assemblies with classical models for nanocrystal formation, it is shown that the increase of the molecular diffusion and the solubility of gold governs the drastic changes in the formation dynamics of nanostructures in solution with temperature.

Corrosion Products Formed on MgZr Alloy Embedded in Geopolymer Used as Conditioning Matrix for Nuclear Waste-A Proposition of Interconnected Processes.

Geopolymer has been selected as a hydraulic mineral binder for the immobilization of MgZr fuel cladding coming from the dismantling of French Uranium Natural Graphite Gas reactor dedicated to a geological disposal. In this context, the corrosion processes and the nature of the corrosion products formed on MgZr alloy in a geopolymer matrix with and without the corrosion inhibitor NaF have been determined using a multiscale approach combining in situ Grazing Incidence hard X-ray Diffraction, Raman microspectroscopy, Scanning and Transmission Electron Microscopies coupled to Energy Dispersive X-ray Spectroscopy. The composition, the morphology, and the porous texture of the corrosion products were characterized, and the effect of the corrosion inhibitor NaF was evidenced.

Studying the Effects of Temperature on the Nucleation and Growth of Nanoparticles by Liquid-Cell Transmission Electron Microscopy.

Temperature control is a recent development that provides an additional degree of freedom to study nanochemistry by liquid cell transmission electron microscopy. In this paper, we describe how to prepare an in situ heating experiment for studying the effect of temperature on the formation of gold nanoparticles driven by radiolysis in water. The protocol of the experiment is fairly simple involving a special liquid cell with uniform heating capabilities up to 100 °C, a liquid-cell TEM holder with flow capabilities and an integrated interface for controlling the temperature.

Introducing cobalt as a potential plasmonic candidate combining optical and magnetic functionalities within the same nanostructure.

The control of magnetic properties at the nanoscale is a current topic of intense research. It was shown that combining both magnetic and plasmonic nanoparticles (NPs) led to the improvement of their magneto-optical signal. In this context, common strategies consist of the design of bimetallic NPs.

Characterization of the boron profile and coordination in altered glass layers by EEL spectroscopy.

Electron energy-loss spectroscopy was used to characterize the boron profile and its coordination (B and B), along the complex alteration layer of glass samples altered for 511 days at 50 °C in solution containing FeCl, MgCl and/or CaCl. To reach this goal, the impact of both TEM operating conditions and sample preparation on the determination of the boron coordination was first studied using mineralogical and pristine glasses reference samples. Then, the boron concentration profiles were characterized in the glass alteration layer.

Selective shortening of gold nanorods: when surface functionalization dictates the reactivity of nanostructures.

The selective shortening of gold nanorods (NRs) is a directional etching process that has been intensively studied by UV-Vis spectroscopy because of its direct impact on the optical response of these plasmonic nanostructures. Here, liquid-cell transmission electron microscopy is exploited to visualize this peculiar corrosion process at the nanoscale and study the impacts of reaction kinetics on the etching mechanisms. In situ imaging reveals that anisotropic etching requires a chemical environment with a low etching power to make the tips of NRs the only reaction site for the oxidation process.

On the Influence of Oxygen on the Degradation of Fe-N-C Catalysts.

Fe-N-C catalysts containing atomic FeN sites are promising candidates as precious-metal-free catalysts for oxygen reduction reaction (ORR) in proton exchange membrane fuel cells. The durability of Fe-N-C catalysts in fuel cells has been extensively studied using accelerated stress tests (AST). Herein we reveal stronger degradation of the Fe-N-C structure and four-times higher ORR activity loss when performing load cycling AST in O - vs.

Nanostructured Nickel Aluminate as a Key Intermediate for the Production of Highly Dispersed and Stable Nickel Nanoparticles Supported within Mesoporous Alumina for Dry Reforming of Methane.

Two routes of preparation of mesoporous Ni-alumina materials favoring the intermediate formation of nanostructured nickel-aluminate are presented. The first one involves an aluminum containing MOF precursor used as sacrificial template to deposit nickel while the second is based on a one-pot synthesis combined to an EISA method. As shown by a set of complementary techniques, the nickel-aluminate nanospecies formed after calcination are homogeneously distributed within the developed mesoporous alumina matrices whose porous characteristics vary depending on the preparation method.

Nanoscale temperature measurement during temperature controlled in situ TEM using Al plasmon nanothermometry.

Over recent years, the advent of microelectromechanical system (MEMS)-type microheaters has pushed the limits of temperature controlled in situ transmission electron microscopy (TEM). In particular, by enabling the observation of the structure of materials in their application environments, temperature controlled TEM provides unprecedented insights into the link between the properties of materials and their structure in real-world problems, a clear knowledge of which is necessary for rational development of functional materials with new or improved properties. While temperature is the key parameter in such experiments, accessing the precise temperature of the sample at the nanoscale during observations still remains challenging.

Structural analysis of single nanoparticles in liquid by low-dose STEM nanodiffraction.

Liquid-cell TEM has enabled an interdisciplinary community of scientists to carry out atomic- / nano-scale studies of solid/liquid interfaces. Nevertheless, the restricted resolution of TEM in liquid media and the necessity to reduce the electron dose to avoid harmful radiolytic effects induced by the beam have limited the use of high resolution imaging to study the atomic structure of nanomaterials in liquid. Here we show that STEM nanodiffraction can be exploited in liquid-cell TEM experiments to overcome these two limitations.

Thermodynamics of faceted palladium(-gold) nanoparticles supported on rutile titania nanorods studied using transmission electron microscopy.

Many physical properties of nanoparticles (NPs) are driven by their equilibrium shape (ES). Thus, knowing the kinetic and thermodynamic parameters that affect the particle morphology is key for the rational design of NPs with targeted properties. Here, we report on the thermodynamic ES of supported monometallic palladium and bimetallic palladium-gold (Pd-Au) single-crystalline truncated nano-octahedra (TOs) studied using aberration-corrected transmission electron microscopy (TEM).

Direct Measurement of the Surface Energy of Bimetallic Nanoparticles: Evidence of Vegard's Rulelike Dependence.

We use in situ transmission electron microscopy to monitor in real time the evaporation of gold, copper, and bimetallic copper-gold nanoparticles at high temperature. Besides, we extend the Kelvin equation to two-component systems to predict the evaporation rates of spherical liquid mono- and bimetallic nanoparticles. By linking this macroscopic model to experimental TEM data, we determine the surface energies of pure gold, pure copper, Cu_{50}Au_{50}, and Cu_{25}Au_{75} nanoparticles in the liquid state.

Monitoring the dynamics of cell-derived extracellular vesicles at the nanoscale by liquid-cell transmission electron microscopy.

Cell-derived extracellular vesicles (EVs) circulating in body fluids hold promises as bioactive therapeutic agents and as biomarkers to diagnose a wide range of diseases. However nano-imaging methods are needed to characterize these complex and heterogeneous soft materials in their native wet environment. Herein, we exploit liquid-cell transmission electron microscopy (LCTEM) to characterize the morphology and dynamic behavior of EVs in physiological media with nanometer resolution.

Exploring the Formation of Symmetric Gold Nanostars by Liquid-Cell Transmission Electron Microscopy.

The shape-dependent properties of gold nanostars (NSs) have motivated massive research efforts in the field of colloidal chemistry to gain a better control over the morphology of these promising nanostructures. Nevertheless, this challenge requires a better understanding of the atomic-scale processes leading to the formation of stellated nanoparticles. We hereby report an unprecedented in situ study focused on the seed-mediated synthesis of symmetric gold NSs performed by radiolysis in methanol.

Driving reversible redox reactions at solid-liquid interfaces with the electron beam of a transmission electron microscope.

Liquid-cell transmission electron microscopy (LCTEM) has opened up a new way to study chemical reactions at the interface between solids and liquids. However, understanding the effects of the electron beam in the liquid cell has been clearly identified as one of the most important challenges to assess correctly and quantitatively LCTEM data. Here we show that the electron beam can be used to drive reversible deposition/dissolution cycles of copper shells over gold nanoparticles in methanol.

Atomic-Scale Snapshots of the Formation and Growth of Hollow PtNi/C Nanocatalysts.

Determining the formation and growth mechanism of bimetallic nanoparticles (NPs) with atomic detail is fundamental to synthesize efficient "catalysts by design". However, an understanding of the elementary steps which take place during their synthesis remains elusive. Herein, we have exploited scanning transmission electron microscopy coupled to energy-dispersive X-ray spectroscopy, operando wide angle and small-angle X-ray scattering, and electrochemistry to unveil the formation and growth mechanism of hollow PtNi/C NPs.

Ostwald-Driven Phase Separation in Bimetallic Nanoparticle Assemblies.

The compositional stability of bimetallic nanoparticles (NPs) is crucial for many applications. We have studied the coarsening of amorphous carbon-supported Au-Pd NPs during annealing at 873 K. Using scanning transmission electron microscopy and energy-dispersive spectroscopy measurements, we show that, despite a complete miscibility of the two metals, the particle assembly undergoes a phase separation during annealing, which leads to two distinct populations: Au-rich NPs with a mean radius of 3.

New insights into the mixing of gold and copper in a nanoparticle from a structural study of Au-Cu nanoalloys synthesized via a wet chemistry method and pulsed laser deposition.

Gold-copper nanoparticles (Au-Cu NPs) were elaborated by both chemical (polyol reduction method) and physical (laser deposition) routes. The size, composition and crystal structure of these bimetallic nanoalloys were then characterized by aberration corrected transmission electron microscopy (TEM). Using a one-pot polyol method, Au-Cu nanocubes (NCs) with nominal compositions Au3Cu and AuCu3 were synthesized.