Understanding frictional behavior in fascia tissues through tribological modeling and material substitution.

The objective of this study is to develop a reliable tribological model to enable a more thorough investigation of the frictional behavior of fascia tissues connected to non-specific lower back pain. Several models were designed and evaluated based on their coefficient of friction, using a low-frequency, low-load reciprocating motion. The study found that two technical elastomers, layered on PDMS to simulate the fascia and underlying muscle, are suitable substitutes for biological tissue in the model.

Possible charge ordering and anomalous transport in graphene/graphene quantum dot heterostructure.

Observations of superconductivity and charge density waves (CDW) in graphene have been elusive thus far due to weak electron-phonon coupling (EPC) interactions. Here, we report a unique observation of anomalous transport and multiple charge ordering phases at high temperatures (T1∼213K,T2∼325K) in a 0D-2D van der Waals (vdW) heterostructure comprising of single layer graphene (SLG) and functionalized (amine) graphene quantum dots (GQD). The presence of functionalized GQD contributed to charge transfer with shifting of the Dirac point ∼ 0.

The Biomimetic Synthesis of Polyarylated Fluorenes, Relevant to Selaginellaceae Polyphenols, Leading to the Spontaneous Formation of Stable Radicals.

This work reports a biomimetic synthesis of polyarylated fluorene derivatives. The molecules are formed via intramolecular electrophilic aromatic substitution, resembling a cyclization leading towards the natural selaginpulvilins from selaginellins. The scope of the reaction was investigated, and the products were obtained in 60-95 % yields.

Injecting hyaluronan in the thoracolumbar fascia: A model study.

Hyaluronan (HA) has been recently identified as a key component of the densification of thoracolumbar fascia (TLF), a potential contributor to non-specific lower back pain (LBP) currently treated with manual therapy and systemic or local delivery of anti-inflammatory drugs. The aim of this study was to establish a novel animal model suitable for studying ultrasound-guided intrafascial injection prepared from HA with low and high Mw. Effects of these preparations on the profibrotic switch and mechanical properties of TLF were measured by qPCR and rheology, respectively, while their lubricating properties were evaluated by tribology.

Scanning Probe Microscopy controller with advanced sampling support.

A low-cost Digital Signal Processor (DSP) unit for advanced Scanning Probe Microscopy measurements is presented. It is based on Red Pitaya board and custom built electronic boards with additional high bit depth AD and DA converters. By providing all the necessary information (position and time) with each data point collected it can be used for any scan path, using either existing libraries for scan path generation or creating adaptive scan paths using Lua scripting interface.

Cyclotrimerization Approach to Symmetric [9]Helical Indenofluorenes: Diverting Cyclization Pathways.

Catalytic cyclotrimerization routes to symmetrical [9]helical indenofluorene were explored by using different transition-metal complexes and thermal conditions. Depending on the reaction conditions, the cyclotrimerizations were accompanied by dehydro-Diels-Alder reaction giving rise to another type of aromatic compounds. Structures of both symmetrical [9]helical cyclotrimerization product as well as the dehydro-Diels-Alder product were confirmed by single-crystal X-ray diffraction analyses.

Enhanced Adhesion of Electrospun Polycaprolactone Nanofibers to Plasma-Modified Polypropylene Fabric.

Excellent adhesion of electrospun nanofiber (NF) to textile support is crucial for a broad range of their bioapplications, e.g., wound dressing development.

Ultrafine-Grained Zn-Mg-Sr Alloy Synthesized by Mechanical Alloying and Spark Plasma Sintering.

Zinc materials are considered promising candidates for bioabsorbable medical devices used for the fixation of broken bones or stents. Materials for these applications must meet high mechanical property requirements. One of the ways to fulfil these demands is related to microstructure refinement, particularly the decrease in grain size.

Long-Range Magnetic Order in Nickel Hydroxide-Functionalized Graphene Quantum Dots.

In this work, we demonstrate the prospect of chemically synthesizing transition metal (Ni) doped magnetic graphene quantum dots (GQDs) with the sole aim of shedding light on their magnetic properties. Our results show that adsorption of nickel hydroxide on predominantly paramagnetic GQDs reveals antiferromagnetic ordering in the M-T profile around 10 K with change of the spin exchange coupling deviating from = 1/2 to = 1, mainly arising from the d-p mixing hybridization between the p orbital of carbon from the GQD and the d orbital of Ni. Furthermore, our results are well complemented by simulations showing asymmetry of the up and down spins around the Fermi level for nickel hydroxide-doped GQDs with long-range spin polarization.

Advanced Zinc-Magnesium Alloys Prepared by Mechanical Alloying and Spark Plasma Sintering.

Zinc and its alloys are considered as promising materials for the preparation of biodegradable medical devices (stents and bone fixation screws) due to their enhanced biocompatibility. These materials must achieve an ideal combination of mechanical and corrosion properties that can be influenced by alloying or thermomechanical processes. This paper presents the effects of different mechanical alloying (MA) parameters on the composition of Zn-1Mg powder.

Roadmap for 2D materials in biotribological/biomedical applications - A review.

The human body involves a large number of systems subjected to contact stresses and thus experiencing wear and degradation. The limited efficacy of existing solutions constantly puts a significant financial burden on the healthcare system, more importantly, patients are suffering due to the complications following a partial or total system failure. More effective strategies are highly dependent on the availability of advanced functional materials demonstrating excellent tribological response and good biocompatibility.

Biodegradable Nanohybrid Materials as Candidates for Self-Sanitizing Filters Aimed at Protection from SARS-CoV-2 in Public Areas.

The COVID-19 pandemic has raised the problem of efficient, low-cost materials enabling the effective protection of people from viruses transmitted through the air or via surfaces. Nanofibers can be a great candidate for efficient air filtration due to their structure, although they cannot protect from viruses. In this work, we prepared a wide range of nanofibrous biodegradable samples containing Ag (up to 0.

Insight into the Lubrication and Adhesion Properties of Hyaluronan for Ocular Drug Delivery.

Hyaluronan (HA) is widely used for eye drops as lubricant to counteract dry eye disease. High and low molecular weight HA are currently used in ophthalmology. However, a large portion of the current literature on friction and lubrication addresses articular (joint) cartilage.

Synthetic Data in Quantitative Scanning Probe Microscopy.

Synthetic data are of increasing importance in nanometrology. They can be used for development of data processing methods, analysis of uncertainties and estimation of various measurement artefacts. In this paper we review methods used for their generation and the applications of synthetic data in scanning probe microscopy, focusing on their principles, performance, and applicability.

Rhodium-Catalyzed Enantioselective Synthesis of Highly Fluorescent and CPL-Active Dispiroindeno[2,1-c]fluorenes.

The enantioselective synthesis of chiral [7]-helical dispirodihydro[2,1-c]indenofluorenes (DSF-IFs) was achieved for the first time in good yields with high er values (er up to 99 : 1). The crucial step of the whole reaction sequence was the enantioselective intramolecular [2+2+2] cycloaddition of tethered triynediols to indenofluorenediols, which was catalyzed by a Rh/SEGPHOS® complex. Further transformations led to the corresponding DSF-IFs.

The effect of albumin and γ-globulin on synovial fluid lubrication: Implication for knee joint replacements.

Total knee arthroplasty has become a routine procedure for patients suffering from joint diseases. Although the number of operations continuously increases, a limited service-life of implants represents a persisting challenge for scientists. Understanding of lubrication may help to suitably explain tribological processes on the way to replacements that become durable well into the third decade of service.

How levelling and scan line corrections ruin roughness measurement and how to prevent it.

Surface roughness plays an important role in various fields of nanoscience and nanotechnology. However, the present practices in roughness measurements, typically based on some Atomic Force Microscopy measurements for nanometric roughness or optical or mechanical profilometry for larger scale roughness significantly bias the results. Such biased values are present in nearly all the papers dealing with surface parameters, in the areas of nanotechnology, thin films or material science.

A General Synthetic Approach and Photophysical Properties of Regioselectively Fluorinated [5]- and [6]-Helical Bispiroindenofluorenes.

A first series of fluorinated [n]helical compounds (n=5 and 6) with the dihydroindenofluorene scaffold was prepared in 5 or 9 (octafluorinated dihydroindenofluorene) steps and their photophysical properties were determined. Rh-catalyzed intramolecular [2+2+2] cyclotrimerization of triyndiols, which were prepared in a modular fashion from simple starting material such as fluorinated haloarylcarbaldehydes, to the intermediate [n]helical dihydroindeno[2,1-c]fluorene-5,8-diols was the crucial synthetic step and proceeded with high efficacy. Their further transformation gave the desired selectively fluorinated bispirodihydroindeno[2,1-c]fluorenes.

Post treatment of swine anaerobic effluent by weak electric field following intermittent vacuum assisted adjustment of N:P ratio for oil-rich filamentous microalgae production.

A weak electric field (EF) was applied to decolorize the swine anaerobic effluent, which was followed by N:P ratio adjustment via intermittent-vacuum stripping (IVS) system for oil-rich filamentous microalgae Tribonema sp. cultivation. A higher electric field strength, higher temperature, and lower pH conditions showed higher efficiency in decolorization and nutrients removal during EF application.

On the Dependence of Rheology of Hyaluronic Acid Solutions and Frictional Behavior of Articular Cartilage.

Hyaluronic acid (HA) injections represent one of the most common methods for the treatment of osteoarthritis. However, the clinical results of this method are unambiguous mainly because the mechanism of action has not been clearly clarified yet. Viscosupplementation consists, inter alia, of the improvement of synovial fluid rheological properties by injected solution.

Cell type specific adhesion to surfaces functionalised by amine plasma polymers.

Our previously-obtained impressive results of highly increased C2C12 mouse myoblast adhesion to amine plasma polymers (PPs) motivated current detailed studies of cell resistance to trypsinization, cell proliferation, motility, and the rate of attachment carried out for fibroblasts (LF), keratinocytes (HaCaT), rat vascular smooth muscle cells (VSMC), and endothelial cells (HUVEC, HSVEC, and CPAE) on three different amine PPs. We demonstrated the striking difference in the resistance to trypsin treatment between endothelial and non-endothelial cells. The increased resistance observed for the non-endothelial cell types was accompanied by an increased rate of cellular attachment, even though spontaneous migration was comparable to the control, i.

Biotribology of Synovial Cartilage: A New Method for Visualization of Lubricating Film and Simultaneous Measurement of the Friction Coefficient.

A healthy natural synovial joint is very important for painless active movement of the natural musculoskeletal system. The right functioning of natural synovial joints ensures well lubricated contact surfaces with a very low friction coefficient and wear of cartilage tissue. The present paper deals with a new method for visualization of lubricating film with simultaneous measurements of the friction coefficient.

The Effect of Synovial Fluid Composition, Speed and Load on Frictional Behaviour of Articular Cartilage.

Articular cartilage ensures smooth motion of natural synovial joints operating at very low friction. However, the number of patients suffering from joint diseases, usually associated with cartilage degradation, continuously increases. Therefore, an understanding of cartilage tribological behaviour is of great interest in order to minimize its degradation, preserving the reliable function of the joints.

Straightforward Synthesis and Properties of Highly Fluorescent [5]- and [7]-Helical Dispiroindeno[2,1-c]fluorenes.

This work presents a general approach for synthesis of substituted [5]-helical dispiroindeno[2,1-c]fluorenes based on Rh-catalyzed intramolecular cyclotrimerization of triynes. This approach was further extended for the first synthesis of configurationally stable [7]-helical dispiroindeno[2,1-c]fluorenes. A series of variously substituted derivatives was prepared and their photophysical and electrochemical properties were evaluated.